Nuova Rade 99960 User manual

www.nuovarade.com
99960
175
110
250
120
55
Instruction Manual
Faucet, w/ Adjust. Spray & Shower Tube 150cm
Dimensions are in mm
Cut out piece Ø 40

www.nuovarade.com
A B C
DD
M
Faucet, w/ Adjust. Spray
& Shower Tube 150cm
1. Close the hot and cold water supply.
2. Screw on the mixer, by hand, without
making use of tools, the exible
connectors which supply cold and hot
water (A), the short hose through which
the already mixed water will come out
(B), and nally the dowel screws (C).
Do not use tools to screw the hoses
as if more force than necessary is
used, these may break completely
or partially or cause damage to the
joints. Excessive tightening can also
damage the metal structurally, without
the damage being apparent to the
eye, which can cause over time, and
without prior notice, a total breakage of
the hose and the ooding of the bath.
3. Unscrew the nuts (K) from the dowel
screws (C).
4. Thread the hand shower (D) at the
top end of the exible hose by placing
the gasket (M) to ensure proper
sealing and if necessary insert the
exible hose (L) through the spout
mouth (in some models the hose is
already inserted).
5. Put the base ring (E) if applicable (in
some models it is already threaded
onto the faucet).
6. Place the round rubber washer (F)
that will work as joint between the
faucet and the countertop.
7. Insert the connections into the
countertop orice to settle the faucet
on the countertop.
8. Place beneath the rubber support
washer (G), triangle (H) and metal
horseshoe (I).
9. Screw the nuts (K) to the dowel
screws (C) to secure the faucet to the
worktop.
10. Connect the exible hose (L) to the
short connector (B).
11. Place the lead counterweight (J) at
the lowest curved part of the exible
hose.
12. Connect the exible connections to
the water distribution system.
13. Open the water supply and ensure
the correct seal.