NuWhirl Mojave Inline suction Service manual

Page 1
Mojave Water Heaters
Installation Instruction Manual
NuWhirl Systems Corp • www.nuwhirl.com • 951-817-5600
MANHW REV C 2/1/2017
Inline & Tee Models
For Use By Qualified Service Personnel ONLY.

Page 2
PLEASE READ CAREFULLY PRIOR TO
Troubleshooting and Servicing Electrical Equipment
Definitions:
WARNING (May cause serious injuries or death)
CAUTION (May cause property damage)
For information on NuWhirl Instructions, see:
www.nuwhirl.com/docs/product-instructions.html
When installing and using this electrical equipment, basic safety
precautions should always be followed, including:
Important Safety Instructions
WARNING: Keep dry. Replace heater if
exposed to water, moisture or
contamination.
WARNING: Use and follow these
instructions along with all instructions that
have been provided with your whirlpool
bathtub componenets.
WARNING: Electronic control system
components should be installed as per
local and national Electrical Codes, in a
location not to be subjected to splashing or
flooding. Exposure to water or splashing
will void all product certifications and
warranties.
There are no user serviceable parts inside.
Opening, modifying, or tampering with
control system components will void all
product certifications and warranties.
WARNING: Risk of electric shock. Connect
control only to a ground type receptacle or
power supply junction box protected by a
Ground-Fault Circuit Interrupter (GFCI).
Contact a qualified electrician if you cannot
verify that the power supply is protected by
a GFCI. The GFCI should be tested on a
routine basis. Consult the GFCI
manufacturer’s instructions for correct
testing and operation.
For electrical connections, see applicable
wiring diagram.
See www.nuwhirl.com/docs/product-
instructions.html
Do not use an extension cord to connect the
product to the electric supply; provide a
properly located receptacle or junction box.
WARNING: Failure to install in strict
accordance with each and every instruction
above may compromise the system, which
may cause injury to persons and/or property.
The tub may be supplied from more than one
power source. Before working on any
electrical device, make sure all power to the
control system is off.
Use this unit only for its intended use as
described in this manual. Do not use
attachments not recommended by the
manufacturer. Any improper installation or
misuse of the equipment may result in injury
to the user and will void the warranty.
Save these instructions.

Page 3
Mojave Water Heater
Installation Instructions
NuWhirl Tub Water Heater Installation Guide
Important Notes
 DANGER: Risk Of Electric Shock.
 These Tub Water Heaters are approved for Factory Installation
ONLY, per the Tub Factory’s relevant Certification Files (UL / CSA /
etc.), and are to be serviced by Qualified Service Personnel only.
 Do not subject the Heater to splashing/water, dropping, rough
handling, freezing, or running dry; the unit must be replaced if this
happens. No User-Serviceable Parts Inside. Misuse or
misapplication of the unit voids all warranties.
 The Power Cord is to be connected as intended (Plug / Hardwire) to
a GFCI-Protected circuit.
 The Bonding Lug must be connected to the Tub’s Bonding Wire
System.
 The Heater is to be installed horizontally, with the Housing oriented
vertically or sideways, as shown in the diagrams. Never install
upside-down.
 The Heater is to be installed with the Water Flow Arrow pointing in
the correct direction.
 Ensure that the O-Rings in the Pipe Fittings are correctly in place
before installing.
 The Pipe Fittings are to be securely Hand-Tightened only – do not
use tools!

Page 4
NuWhirl Systems Corp • www.nuwhirl.com • 951-817-5600
MANHW REV C 2/1/2017
Water Heater Installation Diagrams
T-Style Heaters are to be installed as shown:
In-Line Heaters are to be installed as shown:
In-Line “Pump Suction Side” Heaters are to be installed as shown:
WARNING: The Heater is to be used in strict accordance with the Tub
Manufacturer’s instructions. If the Heater’s Thermal Protector has tripped, a
thorough investigation and correction as to its cause must be performed before
resetting it.
PRESSURE PRESSURE
VACUUM
VACUUM MODEL
VACUUM
PRESSURE PRESSURE
PRESSURE
Side view of tub
End view
of tub
End view
of tub