nvent ERIFLEX IFBS User manual

≈2 mm
1
3
4
5
CLIC
C-
Other mounting
Min. 50mm
Min. 50mm
OR
Min. A
x1,x2,x3 ...
≈2 mm
1 1
1
NOT INCLUDED
DIN 7504 M - 3,9X13
UNCLIC
1
3'
A
B
D
2
PCR30X15-3M / PCR35X35-2M / PCR35X35-3M
(557780) (557520) (557790)
OR
E- Optionnal (IFBSXXSCXX)
1
1
2
2
OR
IFBS20
IFBS24
IFBS32
IFBS40
IFBS50
IFBS63
2
A'
M8
3
3
TECHNICAL SUPPORT
www.nVent.com
IP8652_A 1 OF 3
INSTRUCTION SHEET
nVent, nVent CADDY, nVent ERICO Cadweld, nVent ERICO Critec, nVent ERICO, nVent ERIFLEX, and nVent LENTON are owned by
nVent or its global affiliates. All other trademarks are the property of their respective owners. nVent reserves the right to change
specifications without prior notice.
WARNING:
nVent products shall be installed and used only as indicated in nVent product instruction sheets and training materials. Instruction sheets are available at 1.
www.nVent.com
and from your nVent customer service representative.
nVent products must never be used for a purpose other than the purpose for which they were designed or in a manner that exceeds specified load ratings. 2.
All instructions must be completely followed to ensure proper and safe installation and performance. 3.
Improper installation, misuse, misapplication or other failure to completely follow nVent's instructions and warnings may cause product malfunction, property 4.
damage, serious bodily injury and/or death, and void your warranty.
SAFETY INSTRUCTIONS:
All governing codes and regulations and those required by the job site must be observed.
Always use appropriate safety equipment such as eye protection, hard hat, and gloves as appropriate to the application.


© 2023 nVent All Rights Reserved

SB30X30
(557770)
L = 400mm
TABLE 1
TABLE 2
TABLE 3
TECHNICAL SUPPORT
www.nVent.com
IP8652_A 2 OF 3
INSTRUCTION SHEET
nVent, nVent CADDY, nVent ERICO Cadweld, nVent ERICO Critec, nVent ERICO, nVent ERIFLEX, and nVent LENTON are owned by
nVent or its global affiliates. All other trademarks are the property of their respective owners. nVent reserves the right to change
specifications without prior notice.


© 2023 nVent All Rights Reserved

L in mm
TECHNICAL SUPPORT
www.nVent.com
IP8652_A 3 OF 3
INSTRUCTION SHEET
nVent, nVent CADDY, nVent ERICO Cadweld, nVent ERICO Critec, nVent ERICO, nVent ERIFLEX, and nVent LENTON are owned by
nVent or its global affiliates. All other trademarks are the property of their respective owners. nVent reserves the right to change
specifications without prior notice.


© 2023 nVent All Rights Reserved