Octopus-Leisure Bounce Away User manual

Page 1 of 6
Assembly Instructions
Folding Trampoline Enclosure
Octopus-Leisure.com

Contents Supplied
Tools Supplied
Ref Description Illustration Qty
A
B
C
D
8
8
8
1
Hex
Key
Surround
Pole (bottom)
Surround
pole (middle)
Surround
mesh
1
16
Enclosure Bolt
M6 x 85mm
E
Spanner 1
Before You Start:
Follow your trampoline instructions for assembly location and use. Ensure the
clearances.
can damage the trampoline pole frame and legs and cause potential safety hazards.
This trampoline should only be assembled by two responsible adults. Check the pack
and make sure you have all of the parts listed.
Customer helpline 0151 531 8348 Mon-Fri 09:00-5:00pm
Retain these instructions for future use.
First ensure the trampoline is in the down position and that all the safety locks on the
trampoline frame and wheels are engaged.
Page 2 of 6
Surround pole
with end caps.
(top)
Octopus-Leisure.com

Take the bottom surround pole item (A) ensuring the spring pin is facing outwards insert the
enclosure bolt (E) through the hole in enclosure pole then take the black plastic spacer and
place over the bolt, now insert through the hole at the top of the trampoline leg, take the nut
and secure loosely, repeat the above step with the bottom hole. Fully tighten all nuts, then
repeat this step on all of the remaining legs.
Page 3 of 6
Step 1
A
A
E
A
Take the top surround pole item (B) and place over the middle surround pole item (C), depress
the spring pin on (C) and push poles together ensuring the spring pin locates in the hole you
may have to twist the poles until the pin clicks into place. Repeat this step with the remaining
enclosure poles. Next take the enclosure poles and insert into the surround mesh pockets on
item (D) ensuring that the protective foam fully covers the poles (B&C) whilst inside the pockets.
Step 2
B
C
D
Octopus-Leisure.com

Step 3
a b
Place the enclosure onto the trampoline ensuring not to damage the safety pad or mat.
Arrange the enclosure so that the zipped entrance is next to the warning label on the safety pad
(see above) now align each of the poles with the bottom leg poles previously attached.Take one
of the enclosure poles and place over the bottom enclosure pole, depress the spring pin and
push down you may have to twist the pole until it locates and the pin clicks into the hole of
enclosure(see above) repeat this step with the remaining enclosure poles.
Now take the elastic straps at the bottom of the enclosure mesh and attach to the `V` rings on
the trampoline mat,
DO NOT ATTACH TO THE SPRINGS
Your trampoline is now ready for use
Please read operating instructions
Page 4 of 6
Zipped
Entrance
Octopus-Leisure.com

Page 5 of 6
IMPORTANT – PLEASE READ!
WARNING – GENERAL SAFETY ADVICE
- Please read the instructions before use, and retain for future reference.
- Ensure the trampoline enclosure has been assembled correctly, as per the instructions in the
manual.
- ENSURE the zip and Velcro tabs are fully closed before use.
- Children MUST NEVER use the trampoline unless supervised by a responsible adult with
knowledge of trampoline use.
- Children MUST NEVER be left unattended inside the enclosure at any time.
- DO NOT climb, swing or intentionally jump onto the panels or poles of the enclosure.
- If the enclosure material becomes damaged refrain from use.
- The enclosure is ONLY intended to be used to reduce the risk of injury from falling off the
trampoline.
- DO NOT let children take items or toys into the enclosure.
- Please read and refer to other warnings and use information in the trampoline and enclosure
instructions before use.
Please retain this information for future reference.
Care & Use
Assembly Information
- This Enclosure must be assembled by an adult.
- They must be assembled exactly in accordance with the assembly instructions. Enlisting the
aid of a helper will make assembly easier.
- This Enclosure contains small parts and is not suitable for children under 3 years.
- Please take an inventory of all parts before assembly.
- Should there be any missing parts, the equipment must not be used until replacement parts
have been fitted.
Location
- Your trampoline must be placed on a flat and level surface which is well-lit.
- Under no circumstances should it be positioned on a hard surface such as concrete or
asphalt, unless the ground under the trampoline has free-space of 2 metres surrounding the
trampoline and is covered with a safety surface as well as a 7 metres clearance space in
height. Examples of suitable surfaces are grass, sand or a play surface intended for this tram-
poline.
It is important not to place or store anything under your trampoline.
Please also read the instructions supplied with your trampoline.
Octopus-Leisure.com

Page 6 of 6
Safety Information
- This Enclosure is designed and made for family domestic use only by people 6 years and older. It is
not a rebounding device. It is designed as an enclosure to:
1. Control entry and exit to and from the trampoline and,
2. Allow jumpers to gain confidence, balance, coordination and agility without the fear of
rebounding off the trampoline, where injury could occur.
– Children should always be supervised while they are playing on the trampoline fitted with a
Enclosure and should be instructed not to use it in an inappropriate or hazardous manner.
In particular be aware of:
- The objects children bring into the Enclosure
- Children’s activities inside the Enclosure
- Conditions inside the Enclosure when children are using it
- The way children get into and out of the Enclosure
- Children should not wear cycle helmets while playing on the trampoline.
- The frame of your trampoline is made of steel and it will conduct electricity.
No electrical equipment (lights, heaters, extension cords, household appliances, etc.) should be
permitted in or on the Enclosure under any circumstances to avoid the risk of electrocution.
- Never allow more than one person to use the trampoline at a time. Multiple users may collide with
each other and this can result in serious injury.
- As your trampoline mat is raised off the ground, there is the risk of a fall when exiting the trampo-
line through the door of the Enclosure. Children should be assisted when entering and exiting the
Enclosure so to reduce their risk of falling.
- Only the door of the trampoline Enclosure should be used to enter or exit the Enclosure.
Weather conditions
Special care should be taken as weather conditions change. In particular, surfaces can become
slippery in wet weather and tongues and lips can stick to metal work at sub-zero temperatures. In
warmer and sunnier weather, parts can become hot, and temperatures should be regularly checked
during use, especially metal parts.
Care & Maintenance Of Your Trampoline
- With all products it is vital that the equipment is checked regularly and often by an adult.The
complete products should be checked at least once a month, and particular attention should be
paid to connections and fastenings. If any parts exhibit signs of wear and tear, they may need to be
replaced. Failure to do this may result in the product malfunctioning and causing injury.
- The product must not be used until properly and fully installed and checked. Galvanized tubular
products may require occasional maintenance. If surface rust appears it should be removed with
either a wire brush or coarse sandpaper, and the area treated with non-toxic paint.
- To avoid damage to the Enclosure, do not allow pets or other animals inside.Their claws and teeth
can damage the netting and the trampoline mat.
- Make sure that no bonfires are lit close enough to threaten your trampoline and Enclosure. In
windy conditions, sparks and embers can travel significant distances and burn holes in both the
enclosure netting and trampoline mat.
- Any large trampoline, with or without an enclosure, can be blown around in high winds and cause
injury or damage.We recommend that the Enclosure should be removed under these conditions
and stored in a dry place.
Octopus-Leisure.com
Table of contents
Popular Accessories manuals by other brands

Pertronic
Pertronic 5251CPI Installation and maintenance instructions

Alecto
Alecto ADB-11 manual

Wenglor
Wenglor P1KY10 Series operating instructions

Leviton
Leviton QuickPlate 5EA20-1 installation instructions

ISYGLT
ISYGLT LS-03 Technical Data/Instruction Manual

Ecolink
Ecolink WST-242 Installation instructions & user manual