OgenaSolutions ANIVAC ProHeat II Maintenance manual

Daily Cleaning* & Maintenance
*When finished using unit for the day the clean solu�on tank should be almost completely
empty. Recommend ini�ally prac�cing with plain water to get an idea of how much cleaning
solu�on to start with.
Step 1: Flush Pump & Solu�on Line
Fill empty Clean Soluon tank with 1 gallon of plain water
Turn on PUMP switch only
Place vacuum head in empty catch basin
Pull trigger unl most of water has sprayed into catch basin & spray
starts to diminish NOTE: NEVER RUN PUMP DRY
Turn oPUMP switch
Step 2: Flush Vacuum Hose Assembly
Turn on VACUUM switches only
Vacuum up soluon in catch basin from previous step with air
NOTE: DO NOT COMPLETELY SUBMERGE VACUUM HEAD
(The goal is to create turbulence to dislodge any dirt, hair & debris that
may accumulate inside the vacuum hose and pipe by suoning 50:50
liquid/air)
Turn oACUUM switches
Step 3: Clean Floor Cleaning Tool Assembly & Vacuum Hose
Disconnect metal pipe & soluon line from black plasc handle
Use clean rag soaked with disinfectant soluon to clean the squeegee,
brush, wheels, vacuum head & pipes removing any hair present (If needed
use t head screwdriver ‘pop’ the wheels out to remove any hair caught
around the axels then ‘pop’ back into place)
Using a glovnger check inside vacuum head (at the joint) for any hair or
debris accumuon
Store with squeegee/brush ooor to prevent damage
Disconnect vacuum hose & soluon line from ANIVAC unit
Wipe exterior of hose/line with disinfectant soaked rag
Hang on designated hose rack
Chama Gomez
Technical Field Specialist
United States
855-900-8822 x 227
cgomez@ogenasoluons.com
Ogenasoluons.com

Step 4: Clean Main Unit
Disconnect extension cord(s) from electrical outlet(s) & wipe with rag as
they are being wound up
Store on hanger in designated area
Wheel unit to locaon that has a drain & clean water hose
Pull discharge hose from clamp on front of machine, remove plug and
gently lay down to the drain
Remove clear round lid from the Dirty Soluon tank
Hose down interior of Dirty Soluon tank unl water runs clear
NOTE: PAY CAREFUL ATTENTION TO RINSE THE EXTERIOR OF
THE WIRE FLOAT CAGE LOCATED IN THE UPPER LEFT CORNER OF
THE TANK
Once the Dirty Soluon Tank is empty push discharge hose back into clamp
Wipe down exterior of unit & threads of Dirty Soluon tank lid
Store unit in designated area*
*When storing unit, it is recommended to leave discharge hose unplugged & lid to the Dirty
Solu�on tank offto allow interior of unit to dry out.
Weekly Maintenance:
Step 1: Lubricate Quick Disconnect
NOTE: ONLY USE A SILICONE SPRAY COMPATIBLE w/RUBBER
Spray the e inside of the female quick disconnect ng being sure
to coat the ball bearings & spin the collar
Spray the exterior of the male quick disconnect ng while pressing in
the middle pin
Repeatedly connect & disconnect the ngs together un male ng
‘pops out’ easily when disconnected (usually 3-4 mes is suient)
Step 2: Lubricate Trigger Valve
Spray Trigger Valve located in the ‘V’ between yellow ptrigger &
the boom of the handle
Gently work trigger to disperse lubricant
Step 3: Clean & lubricate any connec�ons where easy removal is desired
(For example)
Threads to Dirty Soluon tank lid
Soluon line connectors
Floor tool metal pipe to vacuum handle
Floor tool metal pipe secons
Vacuum head to pipe