Okayo DST-OTG User manual

[ USER MANUAL ]
Applied models:
5-slot charger C5
25-slot charger C25
50-slot charger C50
Stationary transmitter DST-OTG
OTG-200 series*
*Specific connection cable required.
Okayo OTG Software

User Manual OK-OTG-SW
1
System Requirements
OS
Microsoft Windows 10 or above: 32/64 bit or above
CPU
Intel ® Core ™i3 or above
RAM
2GB RAM or above
Display Resolution
1280 x 720 or above
§“Windows” and “Microsoft” are the trademarks of Microsoft Corporation.
§ “Intel” and “Core” are the trademarks of Intel Corporation.

User Manual OK-OTG-SW
2
Connecting instructions before programming
Bodypack transmitter/receiver OTG-200T/R via proprietary programming cable
Stationary transmitter DST-OTG via micro-USB to USB programming cable
Charger C5 / C25 / C50 via USB to USB programming cable

User Manual OK-OTG-SW
3
Program Setup
○
1Insert disk and double click OK-OTG-SW v1.0.xas shown below.
○
2Click Next when following window shows up.
○
3Set a route for installation of OK-OTG-SW and click Next to continue.

User Manual OK-OTG-SW
4
○
4Input user name, organization and authorized serial number (being offered as a
hardcopy) and click Nextto continue.
○
5Click Next to start the installation.

User Manual OK-OTG-SW
5
○
6Installation is under process.
○
7Click Close to complete the installation.
○
8Shortcut is available for setting / channel compilation now.

User Manual OK-OTG-SW
6
Interface
○
AStatus of connected device
Model name, frequency code, firmware version and so on will show up for
checking.
○
BBespoke ID compilation
Two (2) kinds of ID-number compilation are available.
○
1Cumulative ID number:
ID number will be cumulative every time when a new device is connected and
updated, specifically for a group with same setting operated by different
people, e.g. a tour operator or rental market.
○
2Fixed ID number:
ID number will be fixed without change every time when a new device is
connected and updated, specifically for a project or event where people use it
without obligation, e.g. ALS market.
○
CTotal 4 pages are available for various setting adjustments upon models.
○
C
Rules of ID number:
○
1Capital characters or numbers for first 2-digits.
○
2Numbers only for last 2-digits.
○
3Only numbers in last 2-digits can be cumulated.
○
E
○
D
○
B
○
C
○
A
○
F

User Manual OK-OTG-SW
7
○
DChannels can optionally be selected or deselected upon preference and only
clicked channels will be shown on unit(s).
○
EBespoke channel name can be compiled and only inputting “Description” with desired
characters on clicked channels will be shown on unit(s).
○
FFile setup
: Open previously saved file (.dt).
: Save current settings and channels in your PC (.dt).
: Read the device that is connected with your PC.
: Update current settings and channels onto connected device.
: All settings, except ID number, on connected devices will be reset
to default. Note the button needs to be pressed again to update
connected device after all settings are reset to default ( ).See all default
settings upon models below.
○
1General setting
ID NO.
---
Channel Lock
On (Enabled)
Off (Disabled)
○
2Receiver setting
Alarm (when out of range)
On (Enabled)
Off (Disabled)
Earphone Out
HAC level
Regular
Auto-Off after 20 mins
On (Enabled)
Off (Disabled)