Oklahoma Sound WM-200H User manual

Manufacturers Warranty
Our DUAL WIRELESS MIC SYSTEM undergoes the
most rigid and exacting tests for superior quality
and performance before leaving the factory.
Oklahoma Sound Corporation warrants this
product to be free from defective material and
workmanship for two years from the date of
resale by an authorized Oklahoma Sound distrib-
utor. Oklahoma Sound will replace defective parts
and repair malfunctioning products under this
warranty when the defect occurs under normal
installation and use, provided the unit is returned
to our factory via prepaid transportation after
direct authorization and approval by Oklahoma
Sound. This warranty provides that examination
of the returned product must disclose in our
judgement, a manufacturing defect. This warran-
ty does not extend to any product which has been
subject to misuse, neglect, accident, improper
installation, or where the serial number has been
removed or defected and is given in lieu of any
other warranty implied or expressed and will not
cover any consequential damages.
MODEL #WM-200H
OKLAHOMA SOUND CORPORATION
PACKAGE CONTENTS
Your Unit should Contain the Following:
• Two Color Coded Microphones
•Two Coded Antennae
• Receiver Unit
• Cable
SPECIFICATIONS
FrequencyRange..........Mic A: 57–59 MHz
........................................Mic B: 61–63 MHz
Operating Distance ......150–200 ft.
Power ..............................Receiver: 110V
........................................Transmitter Mics: 9V ea.
4
Dual Hand-Held Wirless Mic System
5
FEATURES & ACCESSORIES
A) MICROPHONE "A" (w/GREEN BAND)
B) MICROPHONE "B" (w/RED BAND)
C) RECEIVER UNIT
D) ANTENNA LABELED "A"
E) ANTENNA LABELED "B"
(CABLE and POWER CORD not shown)
REFER TOPICTURE AND LABELING OF PARTS FOR ASSISTANCE IN OPERATION
Dual Hand-Held
Wireless
Mic System
B
A
D
E
C
INSTRUCTION MANUAL

OKLAHOMA SOUND CORPORATION
INTRODUCTION
Congratulations! You are now the owner of
the unique Dual Hand-Held Wireless
Microphone System from Oklahoma Sound
Corp.
The two wireless microphones can be used
at the same time, Karaokee-style or for
speaker/audience participation. Just follow
the instructions in this booklet and you are
ready to go.
This state-of-the-art microphone system
should provide trouble free usage for years
to come. If you experience any difficulty with
our product, or have questions, please call
our customer service at [phone].
OKLAHOMA SOUND CORP.
149 Entin Road, Clifton, NJ 07014
Tel [phone] • Fax [phone]
www.oklahomasound.com • e-mail: [e-mail]
2
Dual Hand-Held Wirless Mic System
7
OKLAHOMA SOUND CORPORATION
6
Dual Hand-Held Wirless Mic System
3
TABLE OF CONTENTS
Introduction ..............................................................2
Package Contents & Specifications ....................4
Product Features......................................................5
Assembly Instructions ..............................................6
Operating Instructions .......................................... 7
Manufacturer’s Warranty ...................................... 8
ASSEMBLY
Before you begin using the unit:
1. Remove microphone housing from MIC A and also from
MIC B.
2. Insert 9 VOLTbattery (not included) into battery cham-
ber of both mic Aand mic B . Make sure to connect the
positive (+) and negative (-) prongs of battery as per
diagram within chamber.
3. Plug one adapter of cable into jack labeled "AUDIO
OUTPUT" — located on rear side of receiver unit and
plug other adapter of cable into your existing sound sys-
tem. Note: If your system does not havea1/4" input, you
must purchase an adapter.
4. Attach included 110V prong to power cord
5. Connect the antenna labeled "A" to upside of receiver
unit on the left side and antenna labeled "B" to the
upside of receiver unit on the right side.
6. Plug power cord into outlet.
OPERATION
A.Turn switch on microphones to the on position. Switch
is located on underside of microphones. Turning on
MIC A should illuminate green lamp on underside of
microphone (next to switch). Turning on MIC B should
illuminate red lamp on underside of unit (next to
switch).
B. When receiver is plugged into outlet power light on
receiver unit should illuminate.
C. When MIC A is in operation lamp labeled A on front
of receiver should illuminate.
D. When MIC B is in operation liamp labeled B on front
of receiver unit should be illuminated.
TROUBLESHOOTING
In event you experience problems with either MIC try
to replace batteries with new fresh batteries. If prob-
lem persists feel free to call our customer service at
201-261-4111.