OKULEN VARIO mat F Configuration guide

produced by:
Distribution Partner: Fomacon Group
Mörsenbroicher Weg 191 | D- 40470 Düsseldorf
Tel.: [phone]
Free call: [phone]
www.vario-mat.com
E-Mail: [email protected]
General information
Unloading:
The panels can be unloaded from a lorry using a forklift truck. When lifting, special care must be taken to ensure that the panels
cannot slip or fall off. The panels can also be unloaded and installed using a crane.
Storage: Never stack directly more than 5 panels at a time. It is recommended to stack a maximum of 4 packs of 5 panels on top of
each other. Each pack can be separated by 3 square timbers (100mmx100mm) to allow later lifting by forklift truck.
Use of the panels:
Single-sided use. The upper side is engineered with a tread pattern.

produced by:
Distribution Partner: Fomacon Group
Mörsenbroicher Weg 191 | D- 40470 Düsseldorf
Tel.: [phone]
Free call: [phone]
www.vario-mat.com
E-Mail: [email protected]
Lifting and laying:
Each panel has 4 lifting lugs. A lifting device must be inserted into each eyelet. These devices must in turn be connected to a lifting
hook (on a chain sling).
With the help of the chain sling, the panel can be moved to the desired position and installed.

produced by:
Distribution Partner: Fomacon Group
Mörsenbroicher Weg 191 | D- 40470 Düsseldorf
Tel.: [phone]
Free call: [phone]
www.vario-mat.com
E-Mail: [email protected]
Connecting 4 panels:
Connect and screw the panels together using the 4-way connecting cover panel and 4 hexagonal screws (M16x30mm).
All adjacent panels must be connected in this way.
Connecting 2 panels:
Connect and screw the panels together using the 2-way connecting cover panel and 2 hexagonal screws (M16x30mm).
All adjacent panels must be connected in this way.