Omega National Products KitchenMate Blind Corner Caddy User manual

KitchenMate TM Blind Corner Caddy
P0650MNL1
Important Notes
• Always read the instructions completely and carefully before beginning assembly.
• Remove and check contents for damage and/or missing parts. Keep the original
cartons and packing materials, which are required for any authorized adjustment by
our dealers.
• These instructions are for reference only. Make sure installation procedures comply
with all applicable building codes in your area.
Form OME-063, 01/2007
©Omega National Products
Step 1: Turn drawer unit vertical with drawer fronts up
and slide unit into cabinet (See figure 1)
Drawer Unit
Assembly Instructions
Figure 1
Notes: Cabinet door opening must
be a minimun of 15 inches
wide to install this unit.
To allow corner caddy to
work properly cabinet door
must be attached to oppo-
site side of door opening
from corner caddy
Remove Cabinet door for
ease of installation.

Step 3: Position unit so the drawer fronts are even
with, or slightly behind, door opening.
(See Figure 3)
Screw unit to cabinet bottom using the (4) # 8
x 3/4" screws (See figure 3A)
#6 x 1 1/4" Screws
Step 4: Postion caddy slide assembly into cabinet, set-
ting mounting rails on cabinet bottom and front
of assembly against back of face frame.
Fasten slide assembly to cabinet side panel
using (4) #6 x 1 1/4" screws. (See figure 4)
Figure 3
Figure 4
Form OME-063, 01/2007
©Omega National Products
Step 2: Slide unit back into cabinet and then
rotate front of unit downward into position.
(See figure 2)
Figure 2
Suggested Screw Locations
Figure 3A

Step 6: Pull follower unit out and fasten caddy
to follower using (3) #6 x 1 1/4" screws.
(See figure 6).
(3) #6 x 1 1/4" Screws
Figure 6
Form OME-063, 01/2007
©Omega National Products
Outside
Step 5: Using supplied drilling template mark and then
drill (3) 3/32" pilot holes in back of caddy on
side unit is to hinge on. (See figure 5)
Figure 5