Omega National Products KitchenMate WR7020MUF User manual

KitchenMate TM Waste & Recycle Pullouts
WR7020MUF, WR7030MUF
Important Notes
• Always read the instructions completely and carefully before beginning assembly.
• Remove and check contents for damage and/or missing parts. Keep the original
cartons and packing materials, which are required for any authorized adjustment by
our dealers.
• These instructions are for reference only. Make sure installation procedures comply
with all applicable building codes in your area.
Form OME-058, 04/2009
©Omega National Products
Step 1: Pre-drill two 3/32" holes 1/2" deep in each
stile. These should be drilled 4 1/2" down from
the top of the door opening and 3/8" back from
the face of the stiles (see figure 1). 4 1/2"
3/8"
Step 2: Remove outer section of the drawer slides by
fully extending the slide and pushing up on the
black lever on the left slide and pushing down
on the black lever on the right slide, and then
pulling the slide apart while still pushing the
lever (see figure 2)..
Assembly Instructions
Figure 1
PUSH LEVER
PULL SLIDE
Figure 2
Step 3: Mount the outer sections of the drawer slides
to the stiles with #6 x 1/2" Truss head screws
provided, using the pre-drilled holes made in
step 1.
Figure 3

Step 4: Locate rear mounting position of the plastic
sockets by placing them on the slides and
extending them to the back of the cabinet.
Slides must be level and parallel with sides of
the cabinet. When positioned, fasten to the
back of the cabinet with 4 #6 x 1/2" Truss head
screws per each rear mounting socket.
Step 5: Reinstall Pullout unit on the slides and make
sure it moves freely in and out. Mark the prop-
er location for the door.
Step 6: Attach the four door mounting brackets to the
Pullout with one #10-32 x 5/8" Truss Head
Machine Screws for each bracket.
Figure 4
Figure 5
Form OME-058, 04/2009
©Omega National Products
Figure 6
Step 7: Mount the door to the Pullout through at least
two of the brackets with #8 x 1/2" Washer
head screws provided (predrill if neccesary)
and check for correct position. Correct posi-
tion if neccesary and then fasten the door
through the other 2 brackets
Figure 7
Omega National Products