Omega ORU50X Installation guide

CONTENTS
ORU50X
Undermount Rangehoods
Instructions for the Use and Care and Installation of

CONTENTS
1) WARNING
2) INSTALLATION INSTRUCTIONS
3) OPERATION
4) LIGHT REPLACEMENT
5) CLEANING
6) ATTENTION
7) TROUBLESHOOTING
8) SPECIFICATION
It is important that you retain these instructions, proof of purchase as well as other
important documents about this product for future reference.
Due to continual product development, Omega reserves the right to alter specifications
or appearances without notice.
Dispose of packaging responsibly – recycle where facilities are available.
2

1. WARNING
•Young children should be supervised to ensure that they do not play with the
appliance.
•The appliance is not intended for use by persons (including children) with
reduced physical, sensory or mental capabilities, or lack of experience and
knowledge, unless they have been given supervised or instruction concerning
use of the appliance by a responsible person for their safely.
•Your cooker hood is for domestic use only, not suitable for barbecue, fast -food
shops, and other commercial use.
•Any installation work must be carried out by a qualified electrician or competent
person.
•The cooker hood and its filter mesh should be cleaned regularly in order to keep
in good working order.
•Before cleaning, always ensure that you have switched your cooker hood off.
•Do not flambé under the range hood.
•Clean the cooker hood according to the instruction manual, and keep the
cooker hood away from the danger of flames.
•If there is any fault with your cooker hood, please call the customer service
number in the Warranty Card.
•Please keep the room adequately ventilated when your cooker hood and gas
hob are working.
•Do not exhaust the gas from cooker hood through the same heated flue which
is for the gas from gas hob and other kitchen appliances.
•Before installation and usage, read all the instructions and make sure that the
voltage (V) and the frequency (Hz) indicated on your cooker hood are exactly
the same as the voltage (V) and the frequency (Hz) in your home.
•To ensure that you get the best Warranty experience for your cooker hood,
please provide copies of the Warranty Card and purchase receipt, when
booking warranty work with the Customer Service department.
3

2. INSTALLATION
Please ensure that before installing the range hood, that all power is switched off.
Installation must be in accordance to the local electrical authority and codes. This
range hood must be earthed at all times for the operators’ safety.
The G.P.O. for the range hood should be positioned to enable the user to turn the
power off, to enable cleaning and any maintenance required.
Ensure that when installing the range hood, that it is protected from any
possible damage from tools etc.
Ducting for this unit must be installed in accordance to the local authority. Ensure
that the fixings used for this range hood are suitable.
Check the area where the range hood is to be fitted, to ensure that it is
structurally sound.
Before using the appliance, remove the plastic coatings protecting the
stainless steel finish.
Ensure that the wall is structurally sound, and is capable of carrying the
weight of the range hood.
It is recommended that the dimension be checked on the range hood
before installing.
1.
2.
3．
The cooker hood should be placed at a distance of 65-75cm (26-30inch)
from the cooking surface for the best effect.
Drill a hole in the cupboard, 490*265(mm) for model ORU50X.
Make sure the distance between the edge of the hole and the edge of
the cupboard edge is at least 35mm. Take down the filter and remove the
four screws on the panel.
4. Use random accessory tighten screws fix the hood into cabinet.
5. Use 4 screws fix the panel into body and equip the filter.
6. Install one-way valve: put the one-way valve into air outlet, Put on
the one-way valve with air outlet.
4

3. OPERATION:
Note: Before the unit can be operated, it must be ducted.
1. Connect the plug into the power.
2. Push ‘Stop’ button, the motor will stop.
3. Push the ‘Low’ button, the motor runs at low speed.
4. Push the ‘Mid’ button, the motor runs at mid speed.
5. Push the ‘High’ button, the motor runs at high speed.
6. Push the ‘Light’ button and the two lights will be on. Push it again and the light
will turn off.
If your range hood does not function correctly when attempting any of the
above, please ensure that your power is on and is functioning correctly. If the
power seems to be functioning correctly in the house, there may be a problem with
the range hood. Please call your authorised Omega service centre in this case to
organise a service call.
5

4. LIGHT REPLACEMENT
1. Switch the unit off and disconnect from mains power first.
2. Remove filter and read labels regarding maximum lamp ratings.
3. Press the light face and remove by turning in anti-clockwise direction.
4. Pull out the halogen light bulb carefully and replace by same type and same rated
halogen light bulb (12V 40W MAX).
5. CLEANING
SAFETY PRECAUTION
Before cleaning your range hood or performing any maintenance, please
ensure that the range hood is turned off at the power point.
Do not use abrasive cleaners to clean the range hood. The use of warm soapy
water and a cloth are recommended.
Ensure that the range hood is cleaned regularly, as a build up of grease and fat may
occur otherwise.
The filters on the range hood must be cleaned regularly to maintain efficiency, and
prevent grease build up.
It is recommended that this is undertaken every 4 – 6 weeks, depending on
frequency of use.
The filters can be cleaned with warm soapy water or a cloth, or they may be
washed in a dishwasher. If washed in a dishwasher, discolouration may occur to
the mesh and frame.
Cleaning of the range hood must be performed as described above, otherwise
there is a possibility of a fire hazard due to grease and fat build up.
6

6.
·
·
·
·
ATTENTION
Rangehood uses 220-240V 50Hz power;
Disconnect the power when you clean the rangehood;
Do not detach the filter surround
If the power cord or plug is damaged, contact service center
7. TROUBLESHOOTING
For Omega service contact: 1300 739 033
Fault Cause Solution
Light does not work,
but motor works
The lamp may damaged Replace lamp
Light panel switch is damaged Contact service
Light works, but motor
does not work
Motor bearings damaged Contact Service
Motor burn out Contact Service
Light does not work,
motor does not work
Plug contact outlet is damaged Contact Service
Power wire cut off Contact service
Switch damaged Contact Service
Shake of the body
Fan is damaged Contact service
Motor screw loose Contact service
Combination screw loose Contact service
Insufficient suction
The distance between the body
and the cooktop is too high Readjust the distance
Cross-ventilation too strong or
too closed in the kitchen
Reduce
cross-ventilation or
open the window
Exhaust pipe too long Adjust the length of
pipe
Air outlet valve not open Check the valve if
flexible
The outside wind is too strong No the technical
problem

8. SPECIFICATION
Voltage 220V-240V~/50Hz
Rated motor input power 190W
Illumination ≤ 40W+40W(GU-10 base halogen)
Rated input power 270W
Airflow
667m
3
/hr
Outlet diameter 150mm
8

Omega products are distributed in Australia
by Shriro Australia Pty Ltd. Locked Bag
5002, Kingsgrove NSW 2208 Phone: 1300
795 572 Fax: [phone] Email:
[email protected]
Web: www.omegaappliances.com.au