Omnie IG OHC 05 Troubleshooting guide

a
OMNIE HOME USB
COORDINATOR
IG OHC 05
Installation Guide & User Manual
www.omnie.co.uk

aIG OHC 05
OMNIE HOME USB COORDINATOR
Page 2/4
Last Updated: 7th May 2020
© 2017 - OMNIE. No. 6446222 | VAT No. 941838600 | Address: Trade City, Sidmouth Road, Exeter, EX2
5GL, United Kingdom. Call us on 01392 36 36 05. Email [email protected].
USB COORDINATOR
Introduction
If you have no internet you can manually set up the system, this is done
without the OMNIE Home app function.
USB coordinator connects the OMNIE Home devices in Offline mode and it
is necessary to create a ZigBee network. USB coordinator provides wireless
control of all devices in the OMNIE Home RF system. One USB coordinator
can handle up to 30 thermostats, 8 wiring centres. If there are more than
32 battery powered devices in the OMNIE Home network (e.g. thermostats,
relays) or distances between devices cause network range problems, the
system must be equipped with an additional repeater, this can be any
mains powered OMNIE Home device i.e. 230v thermostat or relay.
STAGE 1
Attach USB Coordinator to a USB mains adapter or the USB point on the
OMNIE Home wireless wiring centre.
STAGE 2
Power up the USB plug or OMNIE Home wireless wiring centre.

aIG OHC 05
OMNIE HOME USB COORDINATOR
Page 3/4
Last Updated: 7th May 2020
© 2017 - OMNIE. No. 6446222 | VAT No. 941838600 | Address: Trade City, Sidmouth Road, Exeter, EX2
5GL, United Kingdom. Call us on 01392 36 36 05. Email [email protected].
STAGE 3
To commence system installation press and hold the button for 5 seconds
until button starts flashing red. This means the ZigBee network is ready to
accept RF OMNIE Home devices.
STAGE 4
When everything is paired press and hold button for 5 seconds or till the
flashing stops. If you want to replace or add RF OMNIE Home devices
please ensure you follow steps 3 to 4.
CHECKING SYSTEM CONFIGURATION
To check which devices of the RF Home system are paired and have been
configured correctly, you can use Identify mode. Press the button to
activate Identify mode. Using Identify mode the USB Coordinator will show
all equipment that is connected to your system. Press the button again to
cancel Identify process. Identify mode will time out after 10 minutes.

aIG OHC 05
OMNIE HOME USB COORDINATOR
Page 4/4
Last Updated: 7th May 2020
© 2017 - OMNIE. No. 6446222 | VAT No. 941838600 | Address: Trade City, Sidmouth Road, Exeter, EX2
5GL, United Kingdom. Call us on 01392 36 36 05. Email [email protected].
FACTORY RESET
Choosing a factory restore results in erasing all saved setting and removing
connected equipment from the system. Press and hold button for 15
seconds, if you want to use a factory restore. When the process is
completed, LED light will flash continuously.