One Stop Gardens 98109 Parts list manual

SOLAR BAMBOO LIGHT
Model 98109
ASSEMBLY AND OPERATION INSTRUCTIONS
Diagrams within this manual may not be drawn proportionally.
Due to continuing improvements, actual product may differ slightly from the product described herein.
Distributed exclusively by Harbor Freight Tools®.
3491 Mission Oaks Blvd., Camarillo, CA 93011
Visit our website at: http://www.harborfreight.com
Read this material before using this product.
Failure to do so can result in serious injury.
SAVE THIS MANUAL.
Copyright©2008 by Harbor Freight Tools®. All rights reserved. No portion of this
manual or any artwork contained herein may be reproduced in any shape or form
without the express written consent of Harbor Freight Tools.
For technical questions or replacement parts, please call 1-800-444-3353.

Page 2SKU 98109 For technical questions, please call 1-800-444-3353.
SAVE THIS MANUAL
Keep this manual for the safety warn-
ings and precautions, assembly, operat-
ing, inspection, maintenance and cleaning
procedures. Write the product’s serial
number in the back of the manual near the
assembly diagram (or month and year of
purchase if product has no number). Keep
this manual and the receipt in a safe and
dry place for future reference.
IMPORTANT SAFETY
INSTRUCTIONS
In this manual, on the labeling, and all other
information provided with this product:
This is the safety alert
symbol. It is used to alert
you to potential personal
injury hazards. Obey all
safety messages that
follow this symbol to avoid
possible injury or death.
DANGER indicates
a hazardous
situation which, if not
avoided, will result in death or
serious injury.
WARNING
indicates a
hazardous situation which, if
not avoided, could result in
death or serious injury.
CAUTION, used
with the safety
alert symbol, indicates a
hazardous situation which, if
not avoided, could result in
minor or moderate injury.
NOTICE is used to
address practices
not related to personal injury.
CAUTION, without
the safety alert
symbol, is used to address
practices not related to
personal injury.
READ AND UNDERSTAND ALL INSTRUCTIONS
When using the Solar Bamboo Light, safety
precautions should always be followed including
the following:
Work Area Safety
Dress Properly -a. Wear ANSI-ap-
proved safety goggles and heavy-
duty work gloves. Do not wear loose
clothing or jewelry. Wear protective
hair covering to contain long hair.
Stay Alert - Watch what you are do-b.
ing. Use common sense. Do not set
up the Solar Bamboo Light when you
are tired. Keep work area clean and
well lit. Cluttered or dark areas invite
accidents.
Keep children and bystandersc.
away while operating this product.
Distractions can cause you to lose
control.
Electrical Safety
Stay alert, watch what you are do-1.
ing and use common sense when
operating the Solar Bamboo Light.
Do not use this product while you are
tired or under the inuence of drugs,
alcohol or medication. A moment of
inattention while operating the Solar
Bamboo Light may result in serious
personal injury.

Page 3SKU 98109 For technical questions, please call 1-800-444-3353.
Use the Solar Bamboo Light only with2.
specically designated batteries. Use
of any other batteries may create a
risk of injury and re.
Ni-Cd batteries must be recycled or3.
disposed of properly. Install Ni-Cd
batteries only. Do not incinerate.
Under abusive conditions, liquid may4.
be ejected from the battery; avoid
contact. If contact accidentally oc-
curs, ush with water. If liquid con-
tacts eyes, additionally seek medical
help. Liquid ejected from the battery
may cause irritation or burns.
This product is not a toy. Keep it out5.
of reach of children.
People with pacemakers should6.
consult their physician(s) before use.
Electromagnetic elds in close prox-
imity to heart pacemaker could cause
pacemaker interference or pacemak-
er failure. In addition, people with
pacemakers should:
• Avoid operating alone.
• Do not use with power switch locked
on.
• Properly maintain and inspect to
avoid electrical shock.
• Any power cord must be properly
grounded. Ground Fault Circuit Inter-
rupter (GFCI) should also be imple-
mented – it prevents sustained elec-
trical shock.
General Safety
Do not use Solar Bamboo Light for1.
other than intended use.
Inspect before use. Do not use if2.
parts are loose or damaged. Main-
tain labels and nameplates on the
Solar Bamboo Light. These carry
important safety information. If un-
readable or missing, contact Harbor
Freight Tools for a replacement.
Never look directly into the Solar3.
Bamboo Light.
The warnings, precautions, and in-4.
structions discussed in this instruction
manual cannot cover all possible con-
ditions and situations that may occur.
It must be understood by the operator
that common sense and caution are
factors which cannot be built into this
product, but must be supplied by the
operator.
S A V E T H E S E
INSTRUCTIONS.

Page 4SKU 98109 For technical questions, please call 1-800-444-3353.
SPECIFICATIONS
Material
Injection molded
Resin Plastic, solar
panel with blue
mono-crystalline
cells
Charge Time 6-8 hours
Power Source
(2), AAA, 1.2V,
600 mAh, Ni-Cd
rechargeable
batteries (these
batteries are
included)
UNPACKING
When unpacking, check to make sure
that the item is intact and undamaged. If
any parts are missing or broken, please
call Harbor Freight Tools at the number
shown on the cover of this manual as soon
as possible.
ASSEMBLY
Read the ENTIRE IMPORTANT
SAFEGUARDS section at the
beginning of this manual
including all text under
subheadings therein before set
up or use of this product.
Note: For additional information1.
regarding the parts listed in the fol-
lowing pages, refer to the Assembly
Diagram near the end of this manual.
Choose a location that receives full,2.
direct sunlight a minimum of eight
hours a day. The location should not
be near nighttime light sources such
as porch lights or streetlights as this
will cause the Light to remain off.
The Solar Bamboo Light must be set3.
on a at, even and stable surface.
The Solar Light is water resistant
to protect against normal daily ele-
ments. The Light is not waterproof
and must not be set in water such as
pools or ponds.
Battery
Cover (8)
On/Off
Button (5)
Figure 1
Screw (10)
4. Twist off the Bamboo Cover (2) from
the Bamboo Body (11). Remove the
Battery Cover (8), see Figure 1 and
“Replacing The Batteries” section on
page 5. If the Batteries are covered
by protective tape, remove the tape.
Replace the Battery Cover.
During the day, the Solar Panel con-5.
verts sunlight into electricity which
recharges the batteries. The amount
of light the Solar Panel receives
depends on placement of the Light,
geographic location and weather.
If the weather is cloudy and the panel6.
did not receive a full charge, the
Solar Light may not achieve the full
eight hours of operating time. It will
catch up on its own after two to three
days of full sun.
Located under the Bamboo Cover7.
(2) of the Solar Light is a panel with
an On/Off Button (6) -see Figure 1.
Pressing down on the On/Off Button
(6) will turn the Light on or off. After
the initial charge is set, check to see
that the LEDs are on by viewing the

Page 5SKU 98109 For technical questions, please call 1-800-444-3353.
Bamboo Light at night or in a dark
location.
If the LED (9) is not lit, press the On/8.
Off Button (6) again until it is in the
“ON” position-see Figure 1.
REPLACING THE BATTERIES
Battery
Cover (8)
Batteries (5)
Figure 2
Battery
Compartment (3)
1. Before performing any maintenance,
make sure the On/Off Button (6) is in
the off position.
Located on the bottom of the So-2.
lar Light is a Battery Cover (8) held
in place with four Screws (10)-see
Figure 1. Place the Solar Light over
a working surface that is at and
clear of debris so that you may eas-
ily retrieve the Screws if they are
dropped. Using a small screwdriver
(not included), remove each of the
Screws (10). Place the Screws (10) in
a secure location. Pull off the Battery
Cover (8).
Remove the Batteries (5) and replace3.
with two new Batteries-see Figure 2.
Make certain that the batteries are4.
installed with the positive and nega-
tive poles as indicated. Use Ni-Cad
Batteries only.
Replace the Battery Cover and5.
thread in Screws.
INSPECTION AND
MAINTENANCE
TO PREVENT
SERIOUS INJURY
FROM ACCIDENTAL
OPERATION OR ELECTRIC
SHOCK:
Before light inspection or
maintenance, make sure the
Light switch is turned off, and
the unit has cooled
completely.
TO PREVENT SERIOUS
INJURY FROM FAILURE:
Do not use damaged
products.
BEFORE EACH USE, inspect
the general condition of the
Solar Bamboo Light. Check
for loose screws, cracked or
broken parts, and any other
condition that may affect its safe
operation.
When storing your Light indoors for1.
more than 2 or 3 days, turn the On/
Off Button to “OFF”.
Store the Light in a dry location free2.
of dust and debris. Make certain that
the Light is out of reach of children.
Storing the Light for prolonged pe-
riods may damage the light or de-
crease performance.
Keep the Solar Panel free from dirt3.
and debris. A dirty Solar Panel will
keep the batteries from charging.
Clean regularly with a damp cloth.

Page 6SKU 98109 For technical questions, please call 1-800-444-3353.
PLEASE READ THE FOLLOWING CAREFULLY
THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS LIST AND ASSEMBLY DIAGRAM IN THIS MANUAL
AS A REFERENCE TOOL ONLY. NEITHER THE MANUFACTURER OR DISTRIBUTOR MAKES ANY REPRESENTATION OR
WARRANTY OF ANY KIND TO THE BUYER THAT HE OR SHE IS QUALIFIED TO MAKE ANY REPAIRS TO THE PRODUCT,
OR THAT HE OR SHE IS QUALIFIED TO REPLACE ANY PARTS OF THE PRODUCT. IN FACT, THE MANUFACTURER AND/
OR DISTRIBUTOR EXPRESSLY STATES THAT ALL REPAIRS AND PARTS REPLACEMENTS SHOULD BE UNDERTAKEN BY
CERTIFIED AND LICENSED TECHNICIANS, AND NOT BY THE BUYER. THE BUYER ASSUMES ALL RISK AND LIABILITY
ARISING OUT OF HIS OR HER REPAIRS TO THE ORIGINAL PRODUCT OR REPLACEMENT PARTS THERETO, OR ARISING
OUT OF HIS OR HER INSTALLATION OF REPLACEMENT PARTS THERETO.
PARTS LIST
Part Description Q’ty Part Description Q’ty
1 Solar Panel 1 7 Circuit Board 1
2 Bamboo Cover 1 8 Battery Cover 1
3 Battery
Compartment
1 9 LED 2
4 Spring 2 10 Screw 4
5 Battery-”AAA” 2 11 Bamboo Body 1
6 On/Off Button 1

Page 7SKU 98109 For technical questions, please call 1-800-444-3353.
ASSEMBLY DIAGRAM