One Stop Gardens 56680 Assembly instructions

Visit our website at: http://www.harborfreight.com
Email our technical support at: [email protected]
4 SOLAR DISK LIGHTS
Owner’s Manual & Safety Instructions
Save This Manual Keep this manual for the safety warnings and precautions, assembly,
operating, inspection, maintenance and cleaning procedures. Write the product’s serial number in the back
of the manual near the assembly diagram (or month and year of purchase if product has no number). Keep
this manual and the receipt in a safe and dry place for future reference. 19i
When unpacking, make sure that the product is intact
and undamaged. If any parts are missing or broken,
please call 1-888-866-5797 as soon as possible.
Copyright© 2019 by Harbor Freight Tools®. All rights reserved.
No portion of this manual or any artwork contained herein may be reproduced in
any shape or form without the express written consent of Harbor Freight Tools.
Diagrams within this manual may not be drawn proportionally. Due to continuing
improvements, actual product may differ slightly from the product described herein.
To ol s r eq ui r ed f o r as s em bl y a nd se rv ic e m ay n o t be in cl u de d.
Read this material before using this product.
Failure to do so can result in serious injury.
SAVE THIS MANUAL.

Page 2 For technical questions, please call 1-888-866-5797. Item 56680
Specifications
Battery Type 1 x AA rechargeable NiMH
Charge Time 8 hr.
Run Time 8 hr.
Important Safety Information
1. THIS IS NOT A TOY; FOR
DECORATION ONLY.
2. DO NOT APPLY PRESSURE TO
SOLAR PANEL WHEN INSTALLING.
3. For outdoor use only.
4. Keep bystanders out of the
area during assembly.
5. Do not assemble when tired
or when under the influence
of drugs or medication.
6. Position battery in proper polarity.
7. This product is not a toy. Do not allow
children to play with or near this item.
8. Use as intended only.
9. Inspect before every use; do not use
if parts are loose or damaged.
10. Maintain product labels and
nameplates. These carry
important safety information.
If unreadable or missing, contact
Harbor Freight Tools for a replacement.
11. Make certain that the path of the Stake
is clear of lines, cables and conduits.

Page 3For technical questions, please call 1-888-866-5797.Item 56680
Setup Instructions
CAUTION! To prevent injury, keep
fingers clear of the four small spikes.
1. Assemble Stakes. For each
light, insert smaller piece into
larger piece. See below.
Small
Spike
2. Turn power switch to ON position.
3. Lay disk, solar panel down, on
soft surface. Line up small spikes
with holes in disk. Be careful of the
sharp points while you press Stake
down until it is firmly seated.
NO OFF
4. Decide where you want to place
the Solar Disks. Choose a location
that receives full, direct sunlight
a minimum of eight hours a day.
The location should not be near
nighttime light sources such as
porch lights or streetlights as this will
cause the Solar Disks to remain off.
5. Make certain that the path of the Stake
is clear of lines, cables and conduits.
6. Press the Stake securely
into the ground.
7. DO NOT APPLY PRESSURE TO
SOLAR PANEL WHEN INSTALLING.
Operating Instructions
Note: During the day, the Solar Panel
converts sunlight into electricity, recharging
the battery. The amount of light the Solar
Panel receives depends on placement
of the Solar Disks, geographic location
and weather. If the weather is cloudy
and the panels do not receive a full
charge, the Solar Disks may not achieve
the full run time. They will catch up
after two to three days of full sun.
1. After a full 8 hours of sunlight
charging, the Lights will automatically
turn ON during the night.
2. After the initial charge is set, check to
see that the Lights are on by viewing
the them at night or in a dark location.
If they are not lit, check that the Solar
Panel has had full sunlight for 8 hours.

Page 4 For technical questions, please call 1-888-866-5797. Item 56680
Maintenance
1. BEFORE EACH USE, inspect the
general condition of the tool. Check for:
• leaking, swollen, or cracked battery
• loose hardware
• misalignment or binding of parts
• cracked or broken parts
• any other condition that may
affect its safe operation.
2. AFTER USE, wipe external surfaces
of the tool with clean cloth.
3. Clean regularly with a damp towel.
Do not clean with solvent.
Do not put too much pressure
on the Solar Panel while
cleaning. Dry thoroughly.
Battery Replacement
Note: Replace the battery every 12 months.
1. Remove Stake, then remove four
screws and Metal Outer Ring.
2. Remove Lens and Gasket
from top of Solar Panel.
3. Locate tab on Solar Panel, then
carefully pry Solar Panel off. See below.
Tab
4. To prevent damage, do not pull on the
wires. Carefully remove the battery and
replace with same, noting polarity.
5. Carefully replace Solar Panel, lining
up tab with slot in Disk. Replace
Gasket, Lens and Ring. Make sure
Gasket and Lens line up correctly.
Securely tighten screws.
Note: Incorrect reassembly may
compromise this item’s weather resistance.

Page 5For technical questions, please call 1-888-866-5797.Item 56680
Troubleshooting
Problem Possible Causes Probable Solutions
Light will
not turn on
1. Battery not allowed time for
recharging via Solar Panel.
2. Solar Disks is set near
nighttime light sources such as
porch lights or street lights.
3. Solar Panel is dirty and
covered with dirt or dust.
1. Check that Solar Panel has direct
access to sunlight. Allow one to
two days for a full charge.
2. Move Solar Disks or change Solar Panel
position.
3. Clean Solar Panel with a soft cloth.

Page 6 For technical questions, please call 1-888-866-5797. Item 56680
Record Serial Number Here:
Note: If product has no serial number, record month and year of purchase instead.
Note: Replacement parts are not available for this item.

Page 7For technical questions, please call 1-888-866-5797.Item 56680
Limited 90 Day Warranty
Harbor Freight Tools Co. makes every effort to assure that its products meet high quality
and durability standards, and warrants to the original purchaser that this product is free from
defects in materials and workmanship for the period of 90 days from the date of purchase.
This warranty does not apply to damage due directly or indirectly, to misuse, abuse, negligence
or accidents, repairs or alterations outside our facilities, criminal activity, improper installation,
normal wear and tear, or to lack of maintenance. We shall in no event be liable for death,
injuries to persons or property, or for incidental, contingent, special or consequential damages
arising from the use of our product. Some states do not allow the exclusion or limitation of
incidental or consequential damages, so the above limitation of exclusion may not apply to you.
THIS WARRANTY IS EXPRESSLY IN LIEU OF ALL OTHER WARRANTIES, EXPRESS OR
IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS.
To take advantage of this warranty, the product or part must be returned to us with transportation
charges prepaid. Proof of purchase date and an explanation of the complaint must accompany
the merchandise. If our inspection verifies the defect, we will either repair or replace
the product at our election or we may elect to refund the purchase price if we cannot readily
and quickly provide you with a replacement. We will return repaired products at our expense,
but if we determine there is no defect, or that the defect resulted from causes not within
the scope of our warranty, then you must bear the cost of returning the product.
This warranty gives you specific legal rights and you may also
have other rights which vary from state to state.

26541 Agoura Road • Calabasas, CA 91302 • 1-888-866-5797