One Stop Gardens 9018 User manual

CHILDREN’S PATIO SET
4 PIECE
ASSEMBLY and OPERATING
INSTRUCTIONS
3491 Mission Oaks Blvd., Camarillo, CA 93011
Visit our Web site at http://www.harborfreight.com
For technical questions and replacement parts, please call 1-800-444-3353
®
Copyright © 2003 by Harbor Freight Tools®. All rights reserved. No portion of this
manual or any artwork contained herein may be reproduced in any shape or form
without the express written consent of Harbor Freight Tools .
Model 09018

Page 2
SKU 09018
Specifications
Save This Manual
You will need the manual for the safety warnings and precautions, assembly instructions,
operating and maintenance procedures, parts list and diagram. Keep your invoice with this
manual. Write the invoice number on the inside of the front cover. Keep the manual and
invoice in a safe and dry place for future reference.
Safety Warnings and Precautions
WARNING: When using this product, basic safety precautions should always be fol-
lowed to reduce the risk of personal injury and damage to equipment.
Read all instructions before using this product!
1. Keep work area clean. Cluttered areas invite injuries.
2. Observe work area conditions. Don’t expose to rain unless the wood is properly
treated. Keep work area well lighted.
3. Keep children away. Children must never be allowed in the work area during
assembly.
4. Store idle equipment. When not in use, the Patio Set must be stored in a dry
location to inhibit rust and wear.
5. Use the right tool for the job. Do not attempt to force a small Patio Set to do the
work of a larger Patio Set. There are certain applications for which this Patio Set was
designed. It will do the job better and more safely if you do not modify this
Patio Set and do not use this Patio Set for a purpose for which it was not intended.
6. Dress properly. Do not wear loose clothing or jewelry during assembly. Protective,
electrically non-conductive clothes and non-skid footwear are recommended when
working. Wear restrictive hair covering to contain long hair.
7. Use eye protection. Always wear ANSI approved impact safety goggles during
assembly
8. Do not overreach. Keep proper footing and balance at all times.
Table Dimensions 28” Dia. x 20-1/4” H
Chair Dimensions (2) 12” X 14” X 24” H
Umbrella Dimensions 46” Dia. x 30-1/2” L (opened)
Umbrella Stand 2-1/8” W x 5-5/8” L
Chair Sitting Area 9-1/4” W x 12” L
Materials: Hard Wood, Carbon Steel Frames, Gray Paint,
Waterproof Umbrella Material
CHAIR CAPACITY: 220 LBS. / TABLE CAPACITY: 175 LBS.

Page 3
SKU 09018
9. Maintain the Patio Set with care. Keep it clean for better and safer performance.
Inspect the Patio Set periodically, and if damaged, have it repaired by an authorized
technician.
10. Stay alert. Watch what you are doing, use common sense. Do not assemble the
Patio Set when you are tired.
11. Check for damaged parts. Before using the Patio Set, any part that appears
damaged should be carefully checked to determine that it will operate properly and
perform its intended function. Check for alignment and binding of moving parts; any
broken parts or mounting fixtures; and any other condition that may affect proper
operation. Any part that is damaged should be properly repaired or replaced by a
qualified technician.
12. Replacement parts and accessories. When servicing, use only identical
replacement parts. Use of any other parts will void the warranty.
13. Do not assemble the Patio Set if under the influence of alcohol or drugs. Read
warning labels if taking prescription medicine to determine if your judgement or
reflexes are impaired while taking drugs. If there is any doubt, do not assemble the
Patio Set.
14. Choose the proper location. Set up the Patio Set on a flat, dry, level surface.
15. Be aware of weather conditions. Make sure the umbrella is tied in the closed
position or removed entirely during windy weather. The wind can knock over the
umbrella and table causing serious injury.
16. Maintenance. For your safety, maintenance should be performed regularly by a
qualified technician.
Warning: The warnings, cautions, and instructions discussed in this instruction manual
cannot cover all possible conditions and situations that may occur. It must be under-
stood by the operator that common sense and caution are factors which cannot be
built into this product, but must be supplied by the operator.
Unpacking
When unpacking, check to make sure the parts listed on page 6 are included. If any parts
are missing or broken, please call Harbor Freight Tools at the number on the cover of this
manual as soon as possible.
WARNING: The brass components of this product contain lead, a chemical
known to the State of California to cause birth defects (or other reproductive
harm). (California Health & Safety code 25249.5, et seq.)

Page 4
SKU 09018
See the Parts List/Drawing on page 6.
Assembly
FIGURE 1
FIGURE 2
FIGURE 3
Brace (#10)
Screws (#6)
Table
Stand (#1)
Umbrella
Stand (#9)
Screws (#6)
Bracket (#11)
Table Screw (#5)
Table
Board
(#2)
Screws (#6)
1. Assembling the Table Stand (#1): Use two sets of Screws (#6) on each side of the
Brace (#10) to support the bottom of the Table Stand (#1). Align the Umbrella Stand (#9)
next to the Brace (#10). See FIGURE 1.
2. Attach the two Brackets (#11) to the
underside of the Table Board (#2) using
four sets of Table Screws (#5).
See FIGURE 2.
3. Attach the Table Stand (#1) to
the Brackets (#11) on the
Table Board (#2) using two sets
of Screws (#6).
See FIGURES 2 & 3.

Page 5
SKU 09018
Assembly (continued)
Umbrella (#8)
Screw (#7)
Pole (#12)
Chair
Board
(#4)
Chair Stand (#3)
FIGURE 4
FIGURE 5
4. Connect the Umbrella (#8) and the
Pole (#12) using Screw (#7). Slide the
Pole (#12) into the Umbrella Stand (#9).
See FIGURE 4.
Umbrella Stand (#9)
5. Attach the Chair Board (#4)
to the Chair Stand (#3)
using four sets of
Screws (#6).
Maintenance
Note: Remember to set
the Patio Set up on a
flat, dry, level surface. Do
not deploy the Umbrella (#8)
during windy conditions.
1. Periodically check the hardware and tighten if necessary.
2. If you leave the set outdoors during inclement weather, it is recommended that you seal
the set with a marine quality varnish or paint.

Page 6
SKU 09018
NOTE: Some parts are listed and shown for illustration purposes only and are not available
individually as replacement parts.
PLEASE READ THE FOLLOWING CAREFULLY
THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS DIAGRAM IN THIS
MANUAL AS A REFERENCE TOOL ONLY. NEITHER THE MANUFACTURER NOR DISTRIBU-
TOR MAKES ANY REPRESENTATION OR WARRANTY OF ANY KIND TO THE BUYER THAT HE
OR SHE IS QUALIFIED TO MAKE ANY REPAIRS TO THE PRODUCT OR THAT HE OR SHE IS
QUALIFIED TO REPLACE ANY PARTS OF THE PRODUCT. IN FACT, THE MANUFACTURER
AND/OR DISTRIBUTOR EXPRESSLY STATES THAT ALL REPAIRS AND PARTS REPLACEMENTS
SHOULD BE UNDERTAKEN BY CERTIFIED AND LICENSED TECHNICIANS AND NOT BY THE
BUYER. THE BUYER ASSUMES ALL RISK AND LIABILITY ARISING OUT OF HIS OR HER
REPAIRS TO THE ORIGINAL PRODUCT OR REPLACEMENT PARTS THERETO, OR ARISING
OUT OF HIS OR HER INSTALLATION OF REPLACEMENT PARTS THERETO.
Parts List
Part No. Description Qty.
1 Table Stand 1
2 Table Board 1
3 Chair Stand 2
4 Chair Board 2
5 Table Screw (6mm x 35mm) 4 Sets
6 Screw (6mm x 20mm) 14 Sets
7 Screw 1
8 Umbrella 1
9 Umbrella Stand 1
10 Brace 1
11 Bracket 2
12 Pole 1
#5 #6
#7 #9
#10 #11