HOBOnodeOutdoorRepeaterSetupGuide
Follow these steps to setup a HOBOnode Outdoor Repeater and antennas.
Part# MAN-W-REPEATER-QS Document # 12474-C
Components
HOBOnode Outdoor Repeater
Grease tube
Mounting Kit
Omni-Directional Antenna
Directional Antenna
Onset 2 meter Tri-pod (optional)
Summary of Steps
Step 1 - Assemble Tripod
Step 2 - Mount Omni-Directional Antenna
Step 3 - Assemble Directional Antenna
Step 4 - Mount Directional Antenna
Step 5 - Attach HOBOnode Outdoor Repeater to Mounting Plate
Step 6 - Connect Antenna Cables to HOBOnode Outdoor Repeater
Step 7 - Mount HOBOnode Outdoor Repeater to Tri-pod
Step 8 - Link Repeater to HOBOnode Network.
Step 1 - Assemble Tripod
Step 2 - Mount Omni-Directional Antenna
For more details, see the Tripod Setup Guide
available at www.onsetcomp.com/support/manuals
Before you begin:
remove all parts from the box
remove the bolts and washers from the U-bolts.
HOBOnode Outdoor Repeater and Antennas Mounted on Tri-pod
d Slide the upper mast into the
lower mast. Make sure the notch
on the upper mast lines up with
the groove in the lower mast.
e. Tighten the tri-clamp bolts.
f. Attach U-bolt and tighten.
a. Unfold the legs on the base until
the leg braces are horizontal.
b. Screw the bolts loosely into the
holes in the tri-clamps.
c. Slide the lower mast through the tri-
clamps.
