service and/or cleaning procedure. Only handle the power cord by the plug
end, never pull out the plug by tugging the wire portion of the cord.
•Do not operate this fixture if the power cord has become frayed, crimped
and/or damaged. If the power cord is damaged, replace it immediately with
a new one of similar power rating.
N E V E R O P E N T H I S F I X T U R E W H I L E I N U S E !
•Ensure ALL connections and end caps are properly sealed with a
dielectric grease (available at most electrical suppliers) to prevent
water corrosion and/or electrical short circuit.
During the initial operation of this fixture, a light smoke or smell may emit from
the interior of the fixture. This is a normal processand is caused by excess paint
in the interior of the casing burning off from the heat associated with the lamp
and will decrease gradually over time.
•Please make sure there are NO FLAMMABLE MATERIALS close to the
fixture while operating, to prevent any fire hazard.
•Minimum distance of inflammable materials from the surface 1.6 feet
(0.5m).
•DO NOT attempt installation and/or operation without knowledge how to
do so.
•DO NOT allow operation by persons who are not qualified to operate this
type of fixture. Most damages are the result of operations by
nonprofessionals.
•Consistent operational breaks may ensure the fixture will function properly
for many years to come.
•DO NOT shake fixture, avoid brute force when installing and/or operating
fixture.
•Always install the fixture with an appropriate safety cable. When installing
the fixture in a suspended environment, always use mounting hardware
that is no less than M10 x 25 mm, also be sure the hardware is insert in
the pre-arranged screw holes in the bracket of the fixture.
