CS1500 CHAINSAW
Quick Start Instructions
ATTENTION! Bar and chain oil
prevents premature wear. Never
operate the chainsaw if oil is not
visible in the inspection window.
Check oil level frequently and ll as
needed.
STEP 4: Fully loosen the side cover
release knob (A) and remove the side
cover. Remove the bar and saw chain.
ATTENTION! Chainsaw chain is sharp,
wear suitable gloves when handling.
4
STEP 2: Loosen the side cover release
knob (A) slightly. Do not fully remove
the side cover
BLACK
A
STEP 3: Loosen the chain tensioning
ring (B) by turning counter-clockwise
until it stops
BLACK
A
STEP 5: Re-t the side cover and fully
tighten the side cover release knob (A).
Note bar and chain removed.
RED
B
BLACK
A
5
ATTENTION! SAFETY NOTICE
Unplug the chainsaw
3
ATTENTION! SAFETY NOTICE
Plug in the chainsaw
2
STEP 6: Run the saw for around 2
minutes or until you see oil present on
the bar pad.
When the oil system has been primed
as per the above steps, unplug
the chainsaw and re-t the bar
and sawchain as described in the
instruction manual under “Maintaining
the guide bar”
Remember to top up your bar and
chain oil regularly.
6
IMPORTANT SAFETY NOTICE
Wear protective gloves when handling chainsaw chain.
After removing the chainsaw from the box, inspect it
carefully to ensure no damage has occurred during
shipping and that no parts are missing. If any parts
are damaged or missing, do not use the chainsaw.
Contact Oregon® to obtain replacement parts. For
country-specic telephone numbers, see “Customer
Service by Country”.
This sheet is meant to be a suppliment, not a replacement for your operator’s manual.
What’s in the Box?
These items ship with the chainsaw:
1) Chainsaw
2) Guide Bar
3) Saw Chain
4) Instruction Manual
5) Blade Cover
5
4
2
3
1
FILLING THE BAR AND CHAIN OIL
RESERVOIR
STEP 1: Place the chainsaw n a firm,
flat surface, so that the oil cap (A) is
on top.
• Clean any debris from the cap area.
• Remove the cap.
• Carefully pour 120 ml of bar and
chain oil into the reservoir.
A
If the reservoir is totally full on
initial startup, it can slow down
the prime. We suggest 90% full.
1
