Page 3 of 4
Art. No. 32063
Parts list:
- 32077 –Adapter Plate (Acetal)
- 32063/1 –M6 x 12 Screw (2x)
- 35744/5 –Allen Wrench 5 mm
Attach the adapter plate to the superior end of
the base plate by means of the two M6 screws.
This assembly can then be put over the pins of a
two or three-pin lock bar.
Verify that the adapter plate is attached in the
correct manner. The shape of the adapter plate
should follow the shape of the base plate, where
the adapter plate is bent.
Art. No. 32077
Parts list:
- 32077 –Adapter Plate (POM)
- 32063/1 –M6 x 12 Screw (2x)
- 35744/5 –Allen Wrench 5 mm
Attach the adapter plate to the superior end of base
plate 32110 or 35751N by means of the two M6
screws. This assembly can then be put over the pins of
a two or three-pin lock bar.
Verify that the adapter plate is attached in the correct
manner. The shape of the adapter plate should follow
the shape of the base plate, where the adapter plate is
bent.
This adapter plate allows to position base plates 32110
and 35751N in exactly the same position as base plate
32110/MR. The position of the built-in adapter plate
of base plate 32100/MR corresponds to the position of
the adapter plate 32077 on base plates 32110 and
35751N.
D. STORAGE
The base plate can be stored with adapter plate
attached. If so, be careful during handling as the
device is an extension to the base plate and may
injure persons.
Always store the item in such a way that the
adapter plate does not take any weight of the base
plate. Do not store anything on top of the adapter
plate. A damaged adapter plate must be repaired
or replaced!
Always store the product in a safe place to prevent
it from getting damaged.
Handle with care.
E. MAINTENANCE AND WASTE MANAGEMENT
This product can be cleaned and disinfected by
means of an isopropanol based disinfectant,
applied with a soft cloth. If unsure about the
cleaning fluid, do not use. Never use aerosol
sprays, corrosive cleaning agents, solvents or
abrasive detergents.
Periodic checks of the product should be done to
insure the parts are not worn and require repair or
replacement. Do not attempt to make repairs
yourself. Contact your distributor if there are any
questions or concerns.
The product can be disposed of with household
waste.
