ORIGYN autoSPRITZ OAS1aw User manual

auto
SPRITZ™
Hand Sanitizer Dispenser
User Manual
Model: OAS1aw
PATENT PENDING

ORIGYN™, LLC l Boston, MA 02115 l www.origyn.co
©2020 Origyn LLC
Installation Instructions
1
Remove bottle
from dispenser.
2
Remove the shipping
cap (red) and insert the
cap with the tube (grey),
screw on tightly.

ORIGYN™, LLC l Boston, MA 02115 l www.origyn.co
©2020 Origyn LLC
3
Put bottle back into
dispenser, push rmly
until it clicks.
4
Pull the plastic tab
from the back of the
unit to provide power
to the dispenser.
Installation Instructions cont.

ORIGYN™, LLC l Boston, MA 02115 l www.origyn.co
©2020 Origyn LLC
Installation Instructions cont.
5
Touch the ON button
on the top of the product
until blue light lights up.
Refer to LED codes for
LED behaviors.
6
You are ready to auto-
SPRITZ™. With one hand,
or two hands together,
move into the spray zone
to apply sanitizer.
During rst use, it is normal
to activate 3-4 times before
the spray comes out.
After a period of non-use,
it is normal to activate
several times to achieve
full spray.

ORIGYN™, LLC l Boston, MA 02115 l www.origyn.co
©2020 Origyn LLC
Installation Instructions cont.
7
To rell the dispenser,
purchase The Origyn
Liquid Hand Sanitizer
online, turn product off,
remove bottle and cap,
ll up bottle, replace cap,
replace bottle, turn
product ON.
ATTENTION:
Do not leave sanitizer
in direct sunlight.
Place on at and level
surface. Make sure not to
allow foreign contaminants
into sanitizer bottle. If you
will not use the product for
some time, then turn the
product off. Do not carry
sanitizer by goose neck.

ORIGYN™, LLC l Boston, MA 02115 l www.origyn.co
©2020 Origyn LLC
Dispenser Status LED:
Turn-on: Touch button for one second, blue light illuminates.
Turn-off: Touch button for two seconds, red light illuminates.
Dispense: Blue light illuminated (normal operation).
Power: Redashing2timesduringdispense.ReplaceAAbatteries.
Technical Data:
Rated: 4xAAbatteries6VDC
Warnings:
• Use dispenser only as directed.
• Dispensed product is for external use only. Flammable,
keepawayfromheatorame.
• Keep out of reach of children, if swallowed, get medical
help or contact poison control.
• When using this product, keep out of eyes, ears
and mouth. In case of contact with eyes, rinse
eyes thoroughly with water.
• Do not use on open skin wounds.
• Discontinue use if there is skin rash or irritation.
• Discontinue use if dispenser is clogged.
•Donotexposedispensertoextremehot(above40°C/104°F)or
extremecold(below5°C/41°F)orwetlocations.
• Use only Origyn’s Liquid Hand Sanitizer.
• Using sanitizer gel will clog dispenser.
• Insert batteries per markings inside compartment.
• Do not mix old and new batteries, or different brands.

ORIGYN™, LLC l Boston, MA 02115 l www.origyn.co
©2020 Origyn LLC
Trouble-shooting
•Checkthatthebatteriesareinsertedcorrectly.
• Replace the batteries.
•Checkthatthebottlehassanitizer.
•Checkthatthetubeisinsertedintocap.
•Checkthatthespraynozzle
(seeFig.A)isnotblocked.
• Put hands closer to IR sensor
(seeFig.A).
• For more detailed trouble-shooting,
refer to website: origyn.co
Cleaning and Maintenance
•Cleanexteriorsurfacesusingwaterandmildsoap.
• Do not use abrasive cleaners.
• Do not immerse .
• Dry using soft cloth.
•Examinespraynozzle(FigureA)forbuild-up,cleanusingisopropyl
(rubbing) alcohol & a clean cloth.
• Wipe IR sensor with a clean dry cloth.
• Prior to installation, clean the cap and tube using isopropyl alcohol
to remove any surface contaminants.
IR sensor
Spray
nozzle
Figure A
1-yearlimitedwarranty,
refer to website for more details.
Distributed by:
ORIGYN™, LLC
Boston,MA02115
www.origyn.co
MadeinChina.
For rells visit:
origyn.co/product/rell

ORIGYN™, LLClBoston,MA02115lwww.origyn.co