Orion Technology GST-894i User manual



Introduction
This guide provides instructions for installing the Network Camera on your network. For all
other aspects of using the product, please see the User’s Manual, available from the Product
CD.
1. Check the package contents against the list below.
2. Install the hardware on page 3
3. Set the IP address on page 3.
Package Contents
Hardware Overview
Item
Descriptions
Network Camera
IP Dome Camera
Power Adaptor
Option.
Country specific item.
Software CD
User’s Manual, Utility software
Quick User Guide
This document
Accessories
Top Cushion Plate
Bottom Cushion Plate
Both
-sided Tape
Anchor : 4pcs
Tapping Screw 4x30 : 4pcs
Hex lobular
L-key Wrench
Alarm I/O extension cable
Video monitor cable
IMPORTANT
Th
is product must be installed in compliance with local laws and regulations.



Hardware Overview
   


$/$50,12873,1$VVLJQPHQW




Making Connection
1. If you have external devices such as sensor or alarms, make connection from connectors.
2. Connect Ethernet cable to make connection to the network hub.
3. Connect power cable to the camera.
When you use PoE function, you don’t need to connect power.
LED Indicators
After applying the power, please check the status LED. See below table for details.
LED
Color
Description
Power/Status
Green
Steady for correct power and activity.
Amber
Flashes for factory default activity.
Unlit
It is when no or incorrect power is supplied.
Network
Green
Link LED.
Steady for connection 10/100 Mbit/s network
Amber
Active LED. Flashes for network activity.
Unlit
No Network connection
Assign an IP address
The default setting of the camera is set to “DHCP” and “UPnP” function is set to ON. If you
have a DHCP server on your network and UPnP function is enabled on your PC you can find
the network camera in “My network”.
If a DHCP server is not available on your network, please assign IP address by the following
process.
1) Execute Admintool.exe and click “Search” button.
2) After the camera is listed in camera list, select the camera.
3) Type in the all network information.
4) Click “Apply” button, the setting will be showed in the list.
5) Click “Setting” Button to set network information to the camera.
Then double click the camera in the list, Internet explorer will open automatically.



Web browser connection
Note: The Network camera supports Internet Explorer 7 or above.
Please check version of your browser and update it if necessary.
When you first access the camera you need to download and install an Active-X
control from the camera to display a live image.
Default User and Password are set to “ADMIN” and “1234”. Please type in the user
ID and password to connect the network camera.
For further information for setup, please refer to User’s manual in
software CD.