OXO JORAN Installation instructions

USER INSTRUCTION
JORAN
FOR YOUR OWN SAFETY, PLEASE READ THIS USER
MANUAL CAREFULLY BEFORE YOU INITIALLY START-UP

User Instruction - JORAN V1 03/2017 2/6
1. Dans la boîte
• 1 Joran
2. Instructions
WARNING
Read the instruction in this manual carefully and thoroughly, as they give important
information regarding safety during use and maintenance. Keep this manual with the unit, in
order to consult it in the future. If the unit is sold or given to another operator, make certain
that it always has its manual, to enable the new owner to read about its operation and relative
instructions.
Protect the unit from excessive dryness or humidity (ideal conditions are between 35% and
80%).
To prevent fire or shock hazard, do not expose this product under a high temperature or
humidity area.
DO NOT make any inflammable liquids, water or metal objects enter the unit.
Should any liquid be spilled on the unit, DISCONNECT the power supply to the unit
immediately.
This product must be earthed.
Take care not to damage the power cord.
After having removed the packaging check that the unit is NOT damaged in any way. If in
doubt, DON'T use it and contact an authorized dealer.
NEVER use the unit under the following conditions:
- In places subject to excessive humidity.
- In places subject to vibrations or bumps.
- In places with a temperature of over 45 C/113 F or less than 2 C/35.6 F.
DO NOT open the unit--there are no user serviceable parts inside.
NEVER try to repair the unit yourself. Repairs by unqualified people could cause damage or
faulty operation. Contact your nearest dealer.
Wait for at least one second to turn on the power after turning off this unit.
This unit is intended for indoor use only.
Packaging material (plastic bags, polystyrene foam, nails, etc.) MUST NOT be left within
children's reach, as it can be dangerous.
STOP using the unit immediately In the event of serious operation problems and either contact
your local dealer for a check or contact us directly.
DO NOT dismantle or modify the unit.
If in doubt, DON'T use it and contact an authorized dealer.

User Instruction - JORAN V1 03/2017 3/6
This unit must only be operated by adults. DO NOT allow children to tamper or play with it.
3. Technical specifications
Power input 230VAC 3 Ø + N+ E 50Hz, 32A per Phase
Power output 16A per channel
Fuse 16A circuit breaker
Dimensions 483x88x381
Weight 8.38Kg
4. Global view
Front panel
1. Circuit breaker This circuit breaker will cut off power supply automatically when load
current exceed 16A.
2. Dip switches These switches are used to select initial channel setting mode.
3. Channel sliders These sliders are used to control the intensities of channels of 1 to 6.
4. Channel LEDs Show current intensity of the relevant channel numbered from 1 to 6.
5. DMX LED
6. Power indicator This indicator is turned on when power is ON

User Instruction - JORAN V1 03/2017 4/6
Rear panel
Risk Of Electric Shock
Ne Pas Ouvrir. Risque De Choc Electrique
Warning : This Unit Must Be Grounded
1=Gro und; 2= Data- ; 3=Dat a+
Made in P.R .C.
1. DMX output socket Connect DMX input socket of next unit for parallel
2. DMX input socket Connect DMX input signals
3. Output port (x6) Connects 6 channel output
4. Power in Connects Power Source
4. Operation
• Please confirm power requirement is matched with that specified on this unit.
• Apply required control signals.
• Check for proper wire connections, turn power switch ON.
• Allow the system to connect available control signal at a time, the prevailing one should
control channel output.
• Curve selection
Set dip switch 10 to ON, the curve type is square.
Set dip switch 10 of OFF, the curve type is linear.
• Initial DMX address setting, please refer to following table.

User Instruction - JORAN V1 03/2017 5/6
1 2 3 4 5 6 7 8 9 Initial address 1 2 3 4 5 6 7 8 9 Initial address
1 0 0 0 0 0 0 0 0
0 1 0 0 0 0 0 0 0
1 1 0 0 0 0 0 0 0
0 0 1 0 0 0 0 0 0
1 0 1 0 0 0 0 0 0
0 1 1 0 0 0 0 0 0
1 1 1 0 0 0 0 0 0
0 0 0 1 0 0 0 0 0
1 0 0 1 0 0 0 0 0
0 1 0 1 0 0 0 0 0
1 1 0 1 0 0 0 0 0
0 0 1 1 0 0 0 0 0
1 0 1 1 0 0 0 0 0
0 1 1 1 0 0 0 0 0
1 1 1 1 0 0 0 0 0
0 0 0 0 1 0 0 0 0
1 0 0 0 1 0 0 0 0
0 1 0 0 1 0 0 0 0
1 1 0 0 1 0 0 0 0
0 0 1 0 1 0 0 0 0
1 0 1 0 1 0 0 0 0
. . . . . . . . . . . . . .
. . . . . . . . . . . . . .
0 0 0 0 0 1 0 0 0
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
. . .
. . .
32
1 0 0 0 0 1 0 0 0
. . . . . . . . . . . . . .
. . . . . . . . . . . . . .
. . . . . . . . . . . . . .
0 0 0 0 0 0 1 0 0
1 0 0 0 0 0 1 0 0
0 1 0 0 0 0 0 1 0
. . . . . . . . . . . . . .
. . . . . . . . . . . . . .
. . . . . . . . . . . . . .
0 0 0 0 0 0 0 1 0
1 0 0 0 0 0 0 1 0
0 1 0 0 0 0 0 1 0
. . . . . . . . . . . . . .
. . . . . . . . . . . . . .
. . . . . . . . . . . . . .
0 0 0 0 0 0 0 0 1
1 0 0 0 0 0 0 0 1
1 0 0 0 0 0 0 1 0
. . . . . . . . . . . . . .
. . . . . . . . . . . . . .
. . . . . . . . . . . . . .
0 1 1 1 1 1 1 1 1
1 1 1 1 1 1 1 1 1
3
. . .
. . .
. . .
64
65
66
. . .
. . .
. . .
128
129
130
. . .
. . .
. . .
256
257
258
. . .
. . .
. . .
510
511
• Turn the power switch off, adjust channel program setting, and then turn the power on.
WARNING!!!
1. This apparatus must be earthed
2. To prevent fire or electric shock hazard, do not expose this apparatus to rain or mois-
ture.
3. In case circuit breaker is cut off automatically, check corresponding channel to find
whether there is any malfunction.
4. To assure ventilation, do not block or stack goods near to opening.
5. Wait for at least 3 seconds to turn on your unit after you have turned off your unit.