Ozone Footpads and Straps V2 Setup guide

How to set up and adjust
Footpads and
straps V2
Make sure tHe tongue angle faces forward, towards tHe toe side of tHe footpad.
NOTE: tHere is no left or rigHt tongue, all tongues are tHe saMe.
2:: slide tHe strap tongues up tHrougH tHe
footpad baseplate slot froM tHe underside
1:: undo tHe strap velcro and reMove tHe tongues.

4:: position tHe strap tongues at tHe Middle
baseplate setting. tHis is tHe standard position.
5:: line up tHe baseplate Holes witH tHe board inserts
and fasten tHe screws.
6:: witH tHe screws tigHtened down, put your foot in tHe
strap and adjust tHe velcro left and rigHt sides to fit.
3:: feed tHe velcro straps tHrougH tHe tongue slot wHile inserting tHe tongues into tHe strap on eacH side. tHe top velcro strap end faces towards tHe
centre of tHe board.
you can cHoose between five stance angles, tHe
centre Hole is tHe standard position.

7:: for a furtHer custoMised fit you can try tHe
various strap positions using tHe tongue and
baseplate slot.
slowly undo tHe baseplate screws (don’t unscrew all
tHe way) to allow clearance for tHe strap tongue to
be pusHed down, tHen Move tHe tongue forward or
backward in tHe baseplate slot, tHen pull it back up
into place.
eacH strap tongue Has tHree positions in tHe
baseplate, wHicH allows for nine different strap
positions wHen coMbining left and rigHt tongue
positions. once you find tHe best setting tigHten
tHe baseplate screws back down.
sTaNdard TONguE pOsiTiON slidE TONguE backwards slidE TONguE fOrwards
:: after first use and periodically we recoMMend to
cHeck all screws and re-tigHten if necessary.