Ozonics HR-200P User manual

Pages 1 & 2 Introduction & warnings
Pages 3 & 4 How to use
Ozonics
™
for
optimal
performance
Pages 5 & 6 How to operate
the HR-200
Page 7 How to use the blind mount
Page 8 Storing your Ozonics
™
Pages 9–12 Ozonics
™
accessories
Pages 13 & 14 Guarantee/Warranty information
Operating Manual
Operating Manual
P
P
TS
TS
LC
LC
Pages 1 & 2 Introduction & warnings
Pages 3 & 4 How to use
Ozonics
™
for
optimal
performance
Pages 5 & 6 How to operate
the HR-200
Page 7 How to use the blind mount
Page 8 Storing your Ozonics
™
Pages 9–12 Ozonics
™
accessories
Pages 13 & 14 Guarantee/Warranty information

C
ongratulations and thank you
for purchasing an Ozonics,TM the
revolutionary in-the-field ozone
generator. OzonicsTM will change the
way you hunt for deer and other
scent-savvy game. OzonicsTM blankets
your scent zone with scent-destroying
ozone. You will be amazed at how
downwind deer that previously busted
you, no longer smell you. And, you will
appreciate that you no longer must
be so diligent with pre-hunt scent
control. OzonicsTM will make your hunt
more successful and your preparation
much simpler.
www.ozonicshunting.com
1
“Ozonics is the real deal! You
will not find me without one,
whether I am in a blind or in
a tree!”
– Will Primos,
Primos Truth About Hunting
“I have always been a human
scent control fanatic because
I realize how critical it is to
my success. Ozonics REALLY
works!”
– Dick Scorzafava,
The Radical Hunter
1

IMPORTANT –
Read the instructions thoroughly
before operating OzonicsTM!
CAUTION – The OzonicsTM ozone generator operates in excess
of 10,000 volts.
CAUTION – Do not place fingers or any metal object into fan inlet/outlet
grills. If dirt or debris gets into unit, use gentle compressed air
to remove. If you cannot remove debris, or if the air cell or
fan needs replacement, contact Ozonics for service.
CAUTION – Do not use Boost mode in any closed environment.
CAUTION – When using the OzonicsTM ozone generator in a hunting
enclosure, adequate ventilation is required to prevent the
build-up of ozone within the enclosure.
CAUTION – The OzonicsTM ozone generator operates in an oxygen-rich
environment. Do not use in vicinity of combustible gases.
CAUTION – Do not immerse OzonicsTM in water. Use a clean, dry rag to
remove external dirt and dust. Do not use chemicals
(e.g., gasoline, kerosene, acetone) to clean plastic.
CAUTION – Use only the rechargeable battery and charger
supplied by Ozonics.
CAUTION – Ozone (O3) can be an irritant and powerful oxidizing agent.
Like many products, ozone can be dangerous if used improperly.
So, follow the instructions herein. Should you experience dry
eyes or a sore, scratchy throat, turn the OzonicsTM ozone
generator off immediately and get fresh air. Please refer to ozone
and battery Material Safety Data Sheet (MSDS) for further
information (available from Ozonics).
Ozonics, LLC manufactures to meet or exceed Federal Safety
Standards (e.g., NIOSH, OSHA, EPA, etc.) when used as directed.
2

How to use the OzonicsTM ozone generator
for optimal scent-destroying performance
The only scent control product that deals with your scent zone
The OzonicsTM ozone generator is the first in-the-field ozone generator. It blankets your
scent zone with scent-destroying ozone. Unlike any other scent control products, the
OzonicsTM ozone generator deals with the scent in the area between you and the deer,
cleansing this scent zone so deer won’t smell you.
The OzonicsTM ozone generator electronically changes oxygen (O2) molecules
into ozone (O3) molecules
The OzonicsTM ozone generator produces ozone via corona discharge, converting
oxygen to ozone through the introduction of electricity. This ozone gas is a very
strong oxidizing agent that is commonly used to destroy odors and other organic
contaminants. The OzonicsTM ozone generator projects the ozone downwind with a
quiet, built-in fan.
Heavy, unstable ozone molecules fall through scent zone and bond with scent molecules
The heavier ozone molecules fall through your scent zone. Because ozone molecules
are extremely unstable, they bond with any molecule they come near (scent molecules)
rendering them indistinguishable to the nose of the deer. The bottom line: You will
notice a dramatic reduction in the number of deer that smell you!
3

4
Treestand use –
1. Attach the tree mounting screw provided so the OzonicsTM ozone generator will be
approximately 6 to 12 inches above the top of your head and facing at a slightly
downward (30°) angle. The most effective use of the OzonicsTM ozone generator is
keeping your scent profile as minimal as possible. Therefore, we advocate being
seated while on the stand.
2. Connect the OzonicsTM ozone generator to tree mount ensuring that it is facing
downwind and that it gets proper air flow.
3. Turn the OzonicsTM ozone generator on (see next page for operating instructions)
and toggle to “Boost”.
4. If you smell ozone other than from an occasional change in wind speed or
direction, you are improperly set up.
Ground Blind use – (Fabric-Type Portable Blind)
1. Attach ground blind mounting
bracket (provided, see page 7) to
blind’s roof frame. Connect the
OzonicsTM ozone generator to the
bracket so that outlet will be
positioned 12 to 18 inches from
the opening in the blind and aimed
toward the downwind ventilation.
(Blinds vary, so this distance may
need to be adjusted for optimum
effectiveness). For blinds with
shoot-through mesh windows – ensure a minimum of 6 square feet of downwind
ventilation and 2 square feet For blinds (fabric or hard-sided) with
open windows – ensure a minimum of 2 square feet of downwind ventilation and 1
square foot of upwind ventilation.
2. Do not direct the ozone at any occupant of the blind. Ozone is relatively heavy and
without proper ventilation, the OzonicsTM ozone generator can create excess
concentration of ozone, primarily found in the lower levels of the blind.
3. Turn the OzonicsTM ozone generator on (see operating instructions on
subsequent pages). Do not operate HR-200 in “Boost” mode in a ground blind.
4. If you smell ozone other than just with an occasional change in wind speed
or direction, you are improperly set up.

How to operate the OzonicsTM HR-200 ozone generator
5
o to ope ate t e O o cs
00 o
Built-in fan
Projects generated ozone
silently over scent zone
Battery level indicator (BATT)
Push button to determine
percentage of charge
Mode switch
(MODE)
Switches between
Standard (default)
and Boost modes
Power switch
(PWR)
Silently turns
machine on or off
12-volt rechargeable battery
Removable quick-charge battery
lasts up to 5 hours in Standard
mode, 4 hours in Boost mode
Green utility lights (LITE)
Illuminates without
warning nearby game
OXYGEN
OZONE
1. Turn the OzonicsTM HR-200 ozone generator on or off with PWR switch
To turn the unit ON, simply push the “PWR” button. The battery level LEDs will cycle
from bottom to top once to indicate power has been applied. The fan will start and
the unit will immediately begin producing ozone and expelling it out of the front grill.
2. Choose between Standard mode and Boost mode
The HR-200 features a “MODE” button, which will change ozone output from
Standard to Boost setting. When the HR-200 is first turned on it starts in
“STD” setting. To change to “BOOST” setting, push the “MODE” button.
The top LED (green) of the battery monitor will glow briefly indicating “BOOST”
setting. To change back to “STD” setting, push the “MODE” button and
the bottom LED (red) will glow briefly indicating “STD” setting. The Boost
mode was designed and is recommended for hunting in a tree stand.
3. Check battery level easily
The HR-200 features a built-in battery monitor. To test the battery-level,
push the “BATT” button. Note that the battery test is only momentary, and the

6
LEDs will only glow for a brief time, allowing you to determine battery level. The
battery LEDs will then turn off. A low charge (25% or less) is indicated by the
bottom red LED. 25 to 50% charge is indicated by the next green LED. 50 to 75%
charge is indicated by the next green LED. And, a 75 to 100% charge is indicated
by the top green LED. When the battery level reaches 10% or less and the “BATT”
Button is pushed, the 0 to 25% red LED will blink several times, indicating the
battery is near full discharge. The unit has an automatic cut-off switch that will not
allow the device to operate when the battery voltage is below efficient
operating levels.
4. Low battery warning
The HR-200 has a low battery indicator. The 0 to 25% red LED will blink several
times when the battery reaches the full discharge level and the unit will turn off,
indicating the battery should be recharged.
5. Handy utility lights are green so deer won’t see them
The HR-200 features two external LED lights for use whenever extra illumination
is needed. Push the “LITE” button to activate or deactivate. These lights are green
because deer don’t easily see green light.
6. Charging the battery
While the battery is charging, the light on the wall plug will turn red.
If there is no battery present in the charger, the light will be green.
When the battery is present and charging is complete, the light will go green.
After the light turns green, the battery should be at approximately 100% charge.
Remove the battery from the charger after the light has turned green.
Do not store that battery in the charger.
7. Transporting batteries within Passenger Baggage
Certain restrictions apply to the carriage of lithium ion batteries when carried by
passengers as baggage. Ozonics™original batteries have successfully passed testing
outlined in Part III, Sub-Section 38.3 of the UN Manual of tests, allowing them to
be carried in passenger baggage. Because of the risks associated with the carriage
of batteries, these may NOT be transported within passenger CHECKED BAGGAGE.
Batteries MUST be in CARRY-ON BAGGAGE. Batteries must be installed in the
device or individually protected to prevent short circuit by insulating the terminals
(e.g., taping over terminals, or by placing batteries in a separate bag or protective
pouch). Although not defined, a “reasonable” number of spare batteries can be
carried within a passenger’s carry-on baggage in context of the equipment used by
the passenger and his or her itinerary. (see http://www.safetravel.dot.gov)

7
How to use the OzonicsTM Blind Mounting Bracket
Attach the blind mount
to the bracket.
Close the blind
mount, making
sure the threads
line up with the
hole. Leave the lock loose
enough to fit fiberglass rod
into the blind mount.
Threaded shaft
Place the opening in
the blind mount onto
the fiberglass rod at
the top of the blind.
Mount your Ozonics™ unit to the
bracket. Be sure your Ozonics™ is
mounted above your head, pointing
downwind and located 12 to 18
inches from the downwind opening.
Tighten the lock
in position.
1.
2.
4.
6.
5.
3.

8
Storage of your OzonicsTM HR-200
During the off-season it is best to store your Ozonics™ HR-200 in a dust-free
environment. Prior to storage we recommend that you use a can of compressed air to
blow the area around the coil free of any dust and dirt particles. This will help to ensure
your Ozonics™ will be in top working condition the following season.
Storage of OzonicsTM batteries
It is recommended that you fully charge the lithium-ion battery in your Ozonics™ and
then let it discharge to 50% prior to storage. This can be accomplished by operating
your Ozonics™ outdoors for roughly two hours. Then, store the battery disconnected
from your Ozonics™ in a cool, dry place – between 25°F and 70°F.
Spare batteries should be carried in their own protective case to prevent unintentional
activation or short-circuiting. Don’t allow the contacts of the battery to come in contact
with metal objects such as keys, coins or jewelry.
Troubleshooting
Unit does not power on
1. Check that the protective tabs (for shipping) have been removed from the battery.
2. Check the battery indicator light to see if battery is fully charged.
3. Check that the battery is fully inserted into the unit.
4. Charge or replace battery as needed.
Nothing happens when Boost mode button is pressed
1. You must turn the power on first to start the unit in Standard mode.
2. Then press “MODE” button once to turn on Boost mode.
3. Pressing “MODE” a second time returns the unit to Standard mode.
No smell of ozone
Look inside the front exit grill to see if the air cell has a lilac/bluish color to it when
the unit is on. If you see this color, the unit is working properly. If not, contact Ozonic s, LLC
for further assistance.
For additional information on Ozonics, please visit ozonicshunting.com and click on
the “frequently asked questions” tab.

9
OzonicsTM Accessories
Carry Case
Designed specifically to hold
your Ozonics™generator and
accessories! One exterior and
two interior pockets. Has
detachable shoulder strap and
belt loop.
Protect your Ozonics™
unit to and from your
stand or blind.
belt
loop
.
Extension Arm
Makes it easier to
maneuver your Ozonics
in order to direct ozone
downwind, especially
around the tree. And, it
moves with just a
simple touch.
Position your Ozonics farther
out, away from the tree.