Palmer FDVZN2 User manual

Palmer Promotional Products
Three Sided Rotating Prepaid Display FDVZN2 - Instructions
May 1, 2012
1
Rotating Prepaid Display Contents:
There should be two boxes with all materials for this display.
1. Pre-assembled Rotating base
2. Casters (qty 3)
3. Metal rack panels (qty 3)
4. Metal Header Sign Holder (qty 1)
1.
3.
4.
9.
Position the rack panels on the assembled
base one at a time by aligning the holes in
the bottom of each rack to the exposed
threads on the base (fig a). Secure them
in place using provided 1/4:20 nuts (fig b).
fig. b
fig. a
5. Plastic cover sheets for header graphics (qty 3)
6. Header Sign graphics (qty 3)
7. Rack-end graphics (qty 3)
8. Graphic Side Panels with pre-cut holes (qty 3)
9. Hardware:1/4:20 screws, 1/4:20 nuts, mini screwdriver, wrench
Note: The end
with the slot for
the large graphics
is the top.
5.
2.
Step 1
Attach the casters to the
bottom of the main base
panel.
8.
7.
6.
Step 2

Palmer Promotional Products
Three Sided Rotating Prepaid Display FDVZN2 - Instructions
May 1, 2012
Step 4
Attach the header sign holder to the top of the rack
with provided 1/4:20 screws.
Step 5
Slide header sign graphics, end graphics and large graphic
panel with holes into the provided image channels on the
header, end caps and side panels respectively. Slide
plastic graphic cover in over header graphic to keep it in
place. See following pages for merchandising set up.
Secure with
provided hardware
Align to
pre-drilled
holes
Step 3
Using the pre-drilled holes in the ends of the rack
panels affix the racks to each other with provided
1/4:20 screws.
Do not over-tighten
the screws or the
large graphic
channel will become
pinched.
Aligning the rack-ends to each other
forms other end of large graphic channel
Assembled view
(shown without all large graphic panels in place)
Note: the large graphic
panel also has the option of
going in the slot behind the
rack bars.
2

Palmer Promotional Products
Three Sided Rotating Prepaid Display FDVZN2 - Instructions
May 1, 2012
Merchandising Set Up
It is recommended that each side of the fixture have a minimum of two locking hooks in the top row of
placement holes to avoid bowing of the panel (see fig c).
Attaching Locking Display Hooks
The display hook end must
be lined-up with the middle
space in the exposed bars
for it to fit correctly over the
placement hole.
Align to middle slot
Locking peg hooks can be used on any of
the large placement holes and fit to cover
up the hole in the graphic panel.
Non-locking peg hooks are generally used in
the smaller notches at the top, but may be
used in any of the larger placement holes if
you choose.
fig c
3