Panasonic KX-TGA648AZ User manual

Installation Manual
Additional Digital Cordless Handset
Model No. KX-TGA648AZ
Thank you for purchasing a Panasonic product.
Please read this installation manual before using the unit and
save it for future reference.
This unit is an additional handset compatible with the
following series of Panasonic Digital Cordless Phone:
KX-TG7301/KX-TG7321/KX-TG7341/KX-TG8301/
KX-TG8321/KX-TG6411/KX-TG6421/KX-TG6461/
KX-TG8411/KX-TG6481
You must register this handset with your base unit before it
can be used. This installation manual describes only the
steps needed to register and begin using the handset. Please
read the base unit’s operating instructions for further details.
Charge the batteries for about 7 hours before initial use.
TGA648AZ(e).fm Page 1 Tuesday, July 7, 2009 4:05 PM

– 2 –
Accessory information
Supplied accessories
*1 Please read the base unit’s operating instructions for replacement
battery information.
*2 The handset cover comes attached to the handset.
Note:
LPlease read the base unit’s operating instructions for additional/
replacement accessories.
Accessory item/Part number Quantity
Charger 1
AC adaptor/PQLV219AL 1
Rechargeable batteries*1/
HHR-55AAAB or N4DHYYY00001
2
Handset cover*2 1
Belt clip 1
TGA648AZ(e).fm Page 2 Tuesday, July 7, 2009 4:05 PM

– 3 –
Setting up
Connection/Wall mounting
Note:
LUse only the supplied Panasonic AC adaptor PQLV219AL.
LThe AC adaptor must remain connected at all times. (It is normal for
the adaptor to feel warm during use.)
Battery installation/Battery charge
Important:
LUse the supplied rechargeable batteries. For replacement, we
recommend using the Panasonic rechargeable batteries noted in the
base unit’s operating instructions.
LWipe the battery ends (S, T) with a dry cloth.
LAvoid touching the battery ends (S, T) or the unit contacts.
LConfirm correct polarities (S, T).
LUSE ONLY Ni-MH batteries AAA (R03) size.
LDo NOT use Alkaline/Manganese/Ni-Cd batteries.
Hooks
(220-240 V AC,
50/60 Hz)
25 mm
Screws
(Not supplied)
TGA648AZ(e).fm Page 3 Tuesday, July 7, 2009 4:05 PM

– 4 –
Charge for about 7 hours.
LWhen the batteries are fully charged, the charge indicator goes off.
Note:
LWhen the language selection is displayed after installing the batteries
for the first time, you can select your desired language.
{V} / {^} : Select your desired language. i M i {ic}
LThe handset display may show “Please wait for 1 minute.”
when the handset is placed on the charger if it is not registered to the
base unit.
LIf the batteries are fully charged, but the operating time seems to be
shorter, clean the battery ends (S, T) and the charge contacts with a
dry cloth and charge again.
Confirm “Charging”
is displayed.
Rechargeable Ni-MH ONLY
TGA648AZ(e).fm Page 4 Tuesday, July 7, 2009 4:05 PM

– 5 –
Controls
NControl type
ASoft keys
The handset features 3 soft keys. By pressing a soft key, you can
select the feature shown directly above it on the display.
BNavigator key/?(Volume) key
By pressing this key ({^}, {V}, {<}, or {>}) repeatedly, you can:
−scroll through (up, down, left, or right) various lists
−adjust the receiver or speaker volume (up or down) while talking
ASpeaker
BHeadset socket
C{C} (Talk)
D{s} (Speakerphone)
EDial keypad
F{R/E}
R: Recall/Flash
E: Alarm shortcut key
GCharge indicator
Ringer indicator
HReceiver
IDisplay
J{ic}(Off/Power)
K{C/T}(Clear/Mute)
L{INT}(Intercom)
MMicrophone
NCharge contacts
H
K
J
G
L
M
N
B
C
D
E
F
AI
B
A
TGA648AZ(e).fm Page 5 Tuesday, July 7, 2009 4:05 PM

– 6 –
Registering the handset to the base unit
Ensure that the handset is switched on. If it is not on, press and hold
{ic}for few seconds to turn the handset on.
1Handset:
Lift the handset and press {ic}.
2Base unit:
Proceed with the operation for your model.
3Handset:
Place the handset on the base unit.
LContinue the operation even when the handset display shows
“Please wait for 1 minute.”.
4With the handset still on the base unit, wait until a confirmation tone
sounds and wstops flashing.
Note:
LIf an error tone sounds, or if wis still flashing, register the handset
according to the base unit’s operating instructions.
LWhen you register the handset to your base unit, some features may
be unavailable.
LThe KX-TG7301/KX-TG8301/KX-TG6411/KX-TG8411 does not
feature an answering system.
LAnswering system features are available only when this handset is
registered to the KX-TG7321/KX-TG7341/KX-TG8321/KX-TG6421/
KX-TG6461/KX-TG6481.
NKX-TG7301/KX-TG8301/KX-TG6411/KX-TG8411
Press and hold {x} for about 5 seconds. (No registration tone)
NKX-TG7321/KX-TG7341/KX-TG8321/KX-TG6421/KX-TG6461/
KX-TG6481
Press and hold {x} for about 5 seconds, until the registration tone
sounds.
LIf all registered handsets start ringing, press the same button to
stop. Then repeat this step.
TGA648AZ(e).fm Page 6 Tuesday, July 7, 2009 4:05 PM

– 7 –
For your safety
To prevent severe injury and loss of life/property, read this section carefully before
using the product to ensure proper and safe operation of your product.
WARNING
Power connection
LCompletely insert the AC adaptor/power plug into the power outlet. Failure to do
so may cause electric shock and/or excessive heat resulting in a fire.
LRegularly remove any dust, etc. from the AC adaptor/power plug by pulling it
from the power outlet, then wiping with a dry cloth. Accumulated dust may cause
an insulation defect from moisture, etc. resulting in a fire.
LUnplug the product from power outlets if it emits smoke, an abnormal smell, or
makes an unusual noise. These conditions can cause fire or electric shock.
Confirm that smoke has stopped emitting and contact an authorised service
centre.
Installation
LTo prevent the risk of fire or electrical shock, do not expose the product to rain or
any type of moisture.
LDo not place or use this product near automatically controlled devices such as
automatic doors and fire alarms. Radio waves emitted from this product may
cause such devices to malfunction resulting in an accident.
LIt is advised not to use the equipment at a refuelling point. Users are reminded to
observe restrictions on the use of radio equipment in fuel depots, chemical plants
or where blasting operations are in progress.
CAUTION
Installation and location
LThe AC adaptor is used as the main disconnect device. Ensure that the AC outlet
is installed near the product and is easily accessible.
Battery
LWe recommend using the supplied batteries or additional/replacement batteries
noted in the base unit’s operating instructions for replacement battery
information. USE ONLY rechargeable Ni-MH batteries AAA (R03) size.
LDo not mix old and new batteries.
LDo not open or mutilate the batteries. Released electrolyte from the batteries is
corrosive and may cause burns or injury to the eyes or skin. The electrolyte is
toxic and may be harmful if swallowed.
TGA648AZ(e).fm Page 7 Tuesday, July 7, 2009 4:05 PM

– 8 –
LExercise care when handling the batteries. Do not allow conductive materials
such as rings, bracelets, or keys to touch the batteries, otherwise a short circuit
may cause the batteries and/or the conductive material to overheat and cause
burns.
LCharge the batteries provided with or identified for use with this product only, in
accordance with the instructions and limitations specified in this manual.
LOnly use a compatible base unit (or charger) to charge the batteries. Do not
tamper with the base unit (or charger). Failure to follow these instructions may
cause the batteries to swell or explode.
General notices
LPlease ensure that a separate telephone, not dependent on local power, is
available for emergency use.
LThis equipment will be inoperable when mains power fails.
LWhen a failure occurs which results in the internal parts becoming accessible,
disconnect the power supply cord immediately and return this unit to an
authorised service centre.
LTo minimise the possibility of lighting damage, when you know that a
thunderstorm is coming, we recommend you to unplug the power supply cord
from the AC power outlet.
LNo “000”(for Australia), “111”(for New Zealand), and/or other calls can be
made from this device during a mains power failure.
LThe earpiece on the handset is magnetised and may retain small metallic
objects.
Other information
LOperating the product near electrical appliances may cause interference. Move
away from the electrical appliances.
LUse only the power cord and batteries indicated in this manual. Do not dispose
of batteries in a fire. They may explode. Check with local codes for possible
special disposal instructions.
Routine care
LWipe the outer surface of the product with a soft moist cloth.
LDo not use benzine, thinner, or any abrasive powder.
Splash resistance (handset only)
The handset is designed to be splash-resistant. You can use the handset with wet
hands. (IP 54 Standard)
LDo not immerse in water or leave under running water.
LKeep the handset away from salt water.
LAvoid exposure to prolonged high humidity.
TGA648AZ(e).fm Page 8 Tuesday, July 7, 2009 4:05 PM

– 9 –
LSince water in headset socket may cause damage, close the headset socket
cover when the optional headset is not in use. When the optional headset is
connected, do not use the handset with wet hands.
LIf the handset is wet, wipe with a soft dry cloth.
LThe base unit/charger is not designed to be splash resistant. Do not place the
handset on the base unit/charger if the handset is wet.
Shock resistance (handset only)
The handset is designed to be shock-resistant, however, it should not be thrown or
stepped on.
Notice for product disposal, transfer, or return
LThis product can store your private/confidential information. To protect your
privacy/confidentiality, we recommend that you erase information such as
phonebook or caller list entries from the memory before you dispose of, transfer,
or return the product.
Information on Disposal in other Countries outside the European Union
These symbols are only valid in the European Union. If you wish to discard these
items, please contact your local authorities or dealer and ask for the correct method
of disposal.
TGA648AZ(e).fm Page 9 Tuesday, July 7, 2009 4:05 PM

PNQX2043ZA DC0609DG0
Sales Department:
Austlink Corporate Park, 1 Garigal Road, Belrose, NSW 2085, Australia
350 Te Irirangi Drive, East Tamaki, Private Bag 14911 Panmure,
Auckland, New Zealand
1-62, 4-chome, Minoshima, Hakata-ku, Fukuoka 812-8531, Japan
Copyright:
This material is copyrighted by Panasonic Communications Co., Ltd.,
and may be reproduced for internal use only. All other reproduction, in
whole or in part, is prohibited without the written consent of Panasonic
Communications Co., Ltd.
© Panasonic Communications Co., Ltd. 2009
For Australia
Customer Support Centre Tel. No.:
132600 or website www.panasonic.com.au
For New Zealand
Customer Support Centre Tel. No.:
[phone] or website www.panasonic.co.nz
N52
TGA648AZ(e).fm Page 10 Tuesday, July 7, 2009 4:05 PM