Panasonic KX-TGA830AZ User manual

Installation Manual
Additional Digital Cordless Handset
Model No. KX-TGA830AZ
Thank you for purchasing a Panasonic digital cordless phone.
Please read this installation manual before using the unit and
save it for future reference.
This unit is an additional handset for use with the following
series of Panasonic Digital Cordless Phone: KX-TG8301
You must register this handset with your base unit before it
can be used. This installation manual describes only the
steps needed to register and begin using the handset. Please
read the base unit’s operating instructions for further details.
Charge the batteries for about 7 hours before initial use.
TGA830AZ(e).fm Page 1 Wednesday, June 4, 2008 4:26 PM

– 2 –
Supplied accessories
*1 Please read the base unit’s operating instructions for replacement
battery information.
*2 The handset cover comes attached to the handset.
Note:
LPlease read the base unit’s operating instructions for additional/
replacement accessories.
Connection/Wall mounting
Note:
LUse only the supplied Panasonic AC adaptor PQLV209AL.
LThe AC adaptor must remain connected at all times. (It is normal for
the adaptor to feel warm during use.)
Accessory item/Part number Quantity
Charger 1
AC adaptor for charger/PQLV209AL 1
Rechargeable batteries*1 2
Handset cover*2 1
Belt clip 1
(220-240 V AC,
50/60 Hz)
Hooks
25.4 mm
Screws
TGA830AZ(e).fm Page 2 Wednesday, June 4, 2008 4:26 PM

– 3 –
Battery installation/Battery charge
Important:
LUse the supplied rechargeable batteries (Part No. HHR-55AAAB).
LWhen installing the batteries:
– Wipe the battery ends (S, T) with a dry cloth.
– Avoid touching the battery ends (S, T) or the unit contacts.
– Confirm correct polarities (S, T).
LWhen replacing the batteries:
– USE ONLY rechargeable Ni-MH batteries AAA (R03) size.
– Do NOT use Alkaline/Manganese/Ni-Cd batteries.
– We recommend using the Panasonic rechargeable batteries noted
in the base unit’s operating instructions for replacement battery
information.
1Firmly press the notch on the handset cover and slide it in the
direction of the arrow.
2Insert the batteries negative (T) end first. Close the handset cover.
3Place the handset on the charger for about 7 hours before initial
use.
Note:
LThe handset display may show “Please Wait...”when the
handset is placed on the charger if it is not registered to the base unit.
LIf the batteries are fully charged, but the operating time seems to be
shorter, clean the battery ends (S, T) and the charge contacts with a
dry cloth and charge again.
TGA830AZ(e).fm Page 3 Wednesday, June 4, 2008 4:26 PM

– 4 –
Registering the handset to the base unit
Ensure that the handset is switched on. If it is not on, press and hold
{ih} for few seconds to turn the handset on.
1Handset:
Lift the handset and press {ih}.
2Base unit:
Press and hold {x} for about 5 seconds. (No registration tone)
LIf all registered handsets start ringing, press the same button to
stop. Then repeat this step.
3Handset:
Place the handset on the base unit.
LContinue the operation even when the handset display shows
“Please Wait...”.
4With the handset still on the base unit, wait until a confirmation tone
sounds and wstops flashing.
Note:
LIf an error tone sounds, or if wis still flashing, register the handset
according to the base unit’s operating instructions.
For your safety
To prevent severe injury and loss of life/property, read this section
carefully before using the product to ensure proper and safe operation of
your product.
WARNING
Power connection
LCompletely insert the AC adaptor/power plug into the power outlet.
Failure to do so may cause electric shock and/or excessive heat
resulting in a fire.
TGA830AZ(e).fm Page 4 Wednesday, June 4, 2008 4:26 PM

– 5 –
LRegularly remove any dust, etc. from the AC adaptor/power plug by
pulling it from the power outlet, then wiping with a dry cloth.
Accumulated dust may cause an insulation defect from moisture, etc.
resulting in a fire.
LUnplug the product from power outlets if it emits smoke, an abnormal
smell, or makes an unusual noise. These conditions can cause fire or
electric shock. Confirm that smoke has stopped emitting and contact
an authorised service centre.
Installation
LTo prevent the risk of fire or electrical shock, do not expose the product
to rain or any type of moisture.
LDo not place or use this product near automatically controlled devices
such as automatic doors and fire alarms. Radio waves emitted from
this product may cause such devices to malfunction resulting in an
accident.
LIt is advised not to use the equipment at a refuelling point. Users are
reminded to observe restrictions on the use of radio equipment in fuel
depots, chemical plants or where blasting operations are in progress.
CAUTION
Installation and relocation
LThe AC adaptor is used as the main disconnect device. Ensure that
the AC outlet is installed near the product and is easily accessible.
Battery
LWe recommend using the supplied batteries or additional/replacement
batteries noted in the base unit's operating instructions for
replacement battery information. USE ONLY rechargeable Ni-MH
batteries AAA (R03) size.
LDo not mix old and new batteries.
LDo not open or mutilate the batteries. Released electrolyte from the
batteries is corrosive and may cause burns or injury to the eyes or skin.
The electrolyte may be toxic if swallowed.
TGA830AZ(e).fm Page 5 Wednesday, June 4, 2008 4:26 PM

– 6 –
LExercise care when handling the batteries. Do not allow conductive
materials such as rings, bracelets or keys to touch the batteries,
otherwise a short circuit may cause the batteries and/or the conductive
material to overheat and cause burns.
LCharge the batteries provided with or identified for use with this
product only, in accordance with the instructions and limitations
specified in this manual.
LOnly use a compatible base unit (or charger) to charge the batteries.
Do not tamper with the base unit (or charger). Failure to follow these
instructions may cause the batteries to swell or explode.
General notice
LPlease ensure that a separate telephone, not dependent on local
power, is available for emergency use.
LThis equipment will be inoperable when mains power fails.
LWhen a failure occurs which results in the internal parts becoming
accessible, disconnect the power supply cord immediately and return
this unit to an authorised service centre.
LTo minimise the possibility of lighting damage, when you know that a
thunderstorm is coming, we recommend you to unplug the power
supply cord from the AC power outlet.
LNo “000” (for Australia), “111” (for New Zealand), and/or other calls can
be made from this device during a mains power failure.
LThe earpiece on the handset is magnetised and may retain small
metallic objects.
TGA830AZ(e).fm Page 6 Wednesday, June 4, 2008 4:26 PM

– 7 –
Other information
LOperating the product near electrical appliances may cause
interference. Move away from the electrical appliances.
LUse only the power cord and batteries indicated in this manual. Do not
dispose of batteries in a fire. They may explode. Check with local
codes for possible special disposal instructions.
Routine care
LWipe the outer surface of the product with a soft moist cloth.
LDo not use benzine, thinner, or any abrasive powder.
Notice for product disposal, transfer, or return
LThis product can store your private/confidential information. To protect
your privacy/confidentiality, we recommend that you erase the
information such as phonebook or caller list entries from the memory
before you dispose of, transfer, or return the product.
Information on Disposal in other Countries outside the European
Union
These symbols are only valid in the European Union. If you wish to
discard these items, please contact your local authorities or dealer and
ask for the correct method of disposal.
TGA830AZ(e).fm Page 7 Wednesday, June 4, 2008 4:26 PM

PNQX1209ZA DC0608DM0
Panasonic Communications Co., Ltd.
1-62, 4-chome, Minoshima, Hakata-ku, Fukuoka 812-8531, Japan
Copyright:
This material is copyrighted by Panasonic Communications Co., Ltd.,
and may be reproduced for internal use only. All other reproduction, in
whole or in part, is prohibited without the written consent of Panasonic
Communications Co., Ltd.
© 2008 Panasonic Communications Co., Ltd. All Rights Reserved.
For Australia
Customer Support Centre Tel. No.:
132600 or website www.panasonic.com.au
For New Zealand
Customer Support Centre Tel. No.:
[phone] or website www.panasonic.co.nz
Sales Department:
Panasonic Australia Pty. Limited
Austlink Corporate Park
1 Garigal Road Belrose
NSW 2085
Australia
Sales Department:
Panasonic New Zealand Ltd.
350 Te Irirangi Drive
East Tamaki
Private Bag 14911 Panmure
Auckland
New Zealand
N52
TGA830AZ(e).fm Page 8 Wednesday, June 4, 2008 4:26 PM