Panasonic KX-TGA939 User manual

PanasoniC
Installation Manual
Additional Digital Cordless Handset
Model No. KX-TGA939
2LINE
DECT
6.0
Thank you for purchasing a Panasonic digital cordless phone.
This unit is an additional handsetcompatible with the following
Panasonic Digital Cordless Phones:
KX-TG9321/KX-TG9322/KX-TG9381/KX-TG9382/
KX-TG9391/KX-TG9392
You must registerthis handsetwith yourbase unitbefore it can
be used. This installation manual describes only the steps
needed to register and begin using the handset. Please read
the base unit's operating instructions for further details.
Please read this installation manual before using the unit and
save it for future reference.
For assistance, visit our website:
http://www.panasonic.com/help
for customers in the U.S.A. or
Puerto Rico. *TGA.939*
Printed in Malaysia PNQX1455VA DM0708SY5050

excludes damages for lost time, lost calls or messages, cost of having someone remove or
re-install an installed unit if applicable, travel to and from the servicer. The items listed are
not exclusive, but are for illustration only.) ALL EXPRESS AND IMPLIED WARRANTIES,
INCLUDING THE WARRANTY OF MERCHANTABILITY, ARE LIMITED TO THE PERIOD OF
THE LIMITED WARRANTY.
Some states do not allow the exclusion or limitation of incidental or consequential damages, or
limitations on how long an implied warranty lasts, so the exclusions may not apply to you.
This Limited Warranty gives you specific legal rights and you may also have other rights which
vary from state to state. If a problem with this product develops during or after the Limited
Warranty period, you may contact your dealer or Service Center. If the problem is not
handled to your satisfaction, then write to the warrantor's Consumer Affairs Department at the
addresses listed for the warrantor.
PARTS AND SERVICE, WHICH ARE NOT COVERED BY THIS LIMITED WARRANTY, ARE
YOUR RESPONSIBILITY.
Customer Services Directory (United States and Puerto Rico)
Obtain Product Information and Operating Assistance; locate your nearest
Dealer
or Service Center; purchase Parts and Accessories; or make
Customer Service and Literature requests
by visiting our Web Site at:
http://www.panasonic.com/help
or, contact us via the web at:
http://www.panasonic.com/contactinfo
You may also contact us directly at: 1-800-211-PANA (1-800-211-7262),
Monday -Friday 9am
to 9pm; Saturday -Sunday 10 am to 7pm, EST.
ITTY users (hearing or speech impaired users) can call 1-877-833-8855.
Accessory Purchases (United States and Puerto Rico)
Purchase Parts, Accessories and Instruction Books online for all Panasonic
Products
by visiting our Web Site at:
http://WWW.pstc.panasonic.com
or, send your request by E-mail to:
[email protected]
You may also contact us directly at:
1-800-332-5368 (Phone) 1-800-237-9080 (Fax Only)
(Monday -Friday 9am
to 9pm, EST.)
Panasonic Service and Technology Company
20421 84th Avenue South, Kent, WA 98032
(We Accept Visa, MasterCard, Discover Card, American Express, and Personal Checks.)
ITTY users (hearing or speech impaired users) can call 1-866-605-1277.
When you ship the product
•Carefully pack your unit, preferably in the original carton.
• Attach a letter, detailing the symptom.
•
Send the unit to PSTC (Panasonic) Exchange Center, prepaid and adequately
insured.
• Do not send your unit to Panasonic Corporation of North America or to executive
or regional sales offices. These locations
do not repair consumer products.

Supplied accessories
Charger/PNLC1
001
YT 1
AC adaptor for charger*
1
/PQLV209T or PQL
V219Z 1
Rechargeable batteries*
2 2
Handset cover*3/PNYNTGA430BR 1
Belt clip/PNKE1004Z1 1
*1
Both
of
the AC adaptors are compatible with the charger.
*2 Please read the base unit's operating instructions for replacement
battery information.
*3 The handset cover comes attached to the handset.
Note:
• Please read the base unit's operating instructions for additional/
replacement accessories.
Sales and support information
•
To
order additional/replacement accessories, call 1-800-332-5368.
• TTY users (hearing or speech impaired users) can call 1-866-605-
1277.
Connection
·--------------------------
Note:
• Use only the supplied Panasonic AC adaptor PQLV209 or PQLV219.
2 For assistance, please visit http://www.panasonic.com/help

• The AC adaptor must remain connected at all times. (It is normal for
the adaptor to feel warm during use.)
Battery installation and battery charge
Important:
• Use the supplied rechargeable batteries (Part
No.
HHR-55AAABU
or
N4DHYYY00004
).
• When installing the batteries:
-Wipe
the battery ends((±),
8)
with a dry cloth.
-Avoid
touching the battery ends((±),
8)
or the unit contacts.
-Confirm
correct
polarities(~,
8).
• When replacing the batteries:
-USE ONLY rechargeable Ni-MH batteries AAA (R03) size.
-Do NOT use Alkaline/Manganese/Ni-Cd batteries.
-We recommend using the Panasonic rechargeable batteries noted
in
the base unit's operating instructions for replacement battery
information.
1 Press the notch on the handset cover firmly, and slide it
in
the
direction ofthe arrow.
2 Insert the batteries negative
(8)
end first. Close the handset cover.
3
Place the handseton the
charger
for
about
7
hours
before initial
use.
Note:
• Ifthe batteries are fully charged, but the operating time seems to be
shorter, clean the battery ends (
(±),
8)
and the charge contacts with a
dry cloth.
For assistance, please visit http://www.panasonic.com/help 3

Attention:
A nickel metal hydride battery that is
recyclable powers the product you
have purchased.
Please caii1-800-8-BATTERY (1-
800-822-8837) for information on how
to recycle this battery.
Registering a handset to the base unit
1
Handset:
Lift the handset and press [OFF].
2
Base unit:
• KX-TG9321/KX-TG9322
Press and hold [LOCATOR] for about 5 seconds. (No registration
tone)
• KX-TG9381/KX-TG9382/KX-
TG9391/KX-
TG9392
Press and hold [LOCATOR] for about 5 seconds until the
registration tone sounds.
• If all registered handsets start ringing, press the same button to
stop. Then repeat this step.
• The next step must be completed within 90 seconds.
3 Handset:
Place the handset on the charger.
• Continue the operation even when the handset display shows
"Registering".
4 With the handset still on the charger, wait until a long beep sounds
and
Y stops flashing.
Note:
•
If
an error tone sounds, or
if
Y is still flashing, register the handset
according to the base unit's operating instructions.
4 For assistance, please visit http://www.panasonic.com/help

Display language
1
[MENU]~ [t:t][1][1][0]
2 [f]/[i]: Select the desired setting.
3 Press the middle soft key to save. ~ [OFF]
Wall mounting
1 Drive the screws (not supplied) into the wall.
2 Mount the charger (0), then slide it down (f)) and to the right (f))
until it is secure.
25.4 mm
(1 inch)
~ (120 V AC, 60Hz)
Belt clip
You can hang the handset on your belt or pocket using the supplied belt
clip.
• To attach the belt clip •
To remove the belt clip
For assistance, please visit http://www.panasonic.com/help 5

For your safety
To
prevent severe injury and loss
of
life/property, read this section
carefully before using the product to ensure properand safe operation
of
your product.
WARNING
Power connection
• Completely insert the AC adaptor/power plug into the power outlet.
Failure to do so may cause electric shock and/or excessive heat
resulting
in
a fire.
• Regularly remove any dust, etc. from the AC adaptor/power plug by
pulling it from the power outlet, then wiping with a dry cloth.
Accumulated dust may cause an insulation defect from moisture, etc.
resulting
in
a fire.
• Unplug the product from power outlets if it emits smoke,
an
abnormal
smell,
or
makes an unusual noise. These conditions can cause fire or
electric shock. Confirm that smoke has stopped emitting and contact
the Panasonic Call Center at 1-800-211- PANA (1-800-211-7262).
Installation
•
To
preventthe risk
of
fire
or
electrical shock, do not expose the product
to rain
or
any type
of
moisture.
• Do not place
or
use this product near automatically controlled devices
such as automatic doors and fire alarms. Radio waves emitted from
this product may cause such devices to malfunction resulting
in
an
accident.
CAUTION
Installation and relocation
• The AC adaptor is used as the main disconnect device. Ensure that
the AC outlet is installed near the product and is easily accessible.
6 For assistance, please visit http://www.panasonic.com/help

Battery
• We recommend using the supplied batteries
or additional/replacement
batteries noted in the base unit's operating instructions for
replacement battery information. USE ONLY rechargeable Ni-MH
batteries AAA (R03) size.
• Do not mix old and new batteries.
• Do not open or mutilate the batteries. Released electrolyte from the
batteries is corrosive and maycause burns
or injuryto the eyes or skin.
The electrolyte may be toxic if swallowed.
• Exercise care when handling the batteries. Do not allow conductive
materials such as rings, bracelets
or keys to touch the batteries,
otherwise a shortcircuit maycause the batteries and/orthe conductive
material to overheat and cause burns.
• Charge the batteries provided with or identified for use with this
product only,
in accordance with the instructions and limitations
specified
in this manual.
• Only use a compatible charger to charge the batteries. Do not tamper
with the charger. Failure to follow these instructions may cause the
batteries to swell or explode.
Other information
• Operating the product near electrical appliances may cause
interference. Move away from the electrical appliances.
• Use only the power cord and batteries indicated
in this manual. Do not
dispose
of batteries in a fire. They may explode. Check with local
codes for possible special disposal instructions.
Routine care
• Wipe the outer surface
of the product with a soft moist cloth.
• Do not use benzine, thinner,
or any abrasive powder.
For assistance, please visit http://www.panasonic.com/help 7

Notice for product disposal, transfer,
or
return
• This product can store your private/confidential information.
To
protect
your privacy/confidentiality, we recommend that you erase the
information such as phonebook
or
caller list entries from the memory
before you dispose of, transfer, or return the product.
FCC and other information
This equipment is hearing aid compatible as defined by the FCC
in
47
CFR Section 68.316.
When you hold the phone to your ear, noise might be heard
in
your
Hearing Aid. Some Hearing Aids are not adequately shielded from
external RF (radio frequency) energy. If noise occurs, use
an
optional
headset accessory or the speakerphone option (if applicable) when
using this phone. Consult with your audiologist or Hearing Aid
manufacturer about the availability
of
Hearing Aids which provide
adequate shielding to RF energy commonly emitted by digital devices.
WHEN PROGRAMMING EMERGENCYNUMBERSAND(OR) MAKING
TEST CALLS TO EMERGENCY NUMBERS:
1) Remain on the line and briefly explain to the dispatcherthe reason for
the call.
2) Perform such activities
in
the off-peak hours, such as early morning
or
late evenings.
This device complies with Part 15 ofthe FCC Rules. Operation is subject
to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may
cause undesired operation.
Privacy
of
communications may not be ensured when using this phone.
8 For assistance, please visit http://www.panasonic.com/help

CAUTION:
Any changes or modifications not expressly approved by the party
responsible forcompliance could void the user's authority to operate this
device.
NOTE:
This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to Part 15
of
the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference
in
a residential installation. This equipmentgenerates, uses,
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference
will not occur
in
a particular installation. Ifthis equipment does cause
harmful interference to radio
or
television reception, which can be
determined by turning the equipment offand on, the user is encouraged
to try to correct the interference by one or more
of
the following
measures:
-Reorient
or relocate the receiving antenna.
-Increase
the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
-Consult
the dealer or an experienced radio/TV technician for help.
FCC RF Exposure Warning:
• This product complies with FCC radiation exposure limits set forth for
an uncontrolled environment.
• This handset may not be collocated or operated
in
conjunction with
any other antenna or transmitter.
• The handset may be carried and operated with only the specific
provided belt-clip. Other non-tested belt-clips or similar body-worn
accessories may not comply and must be avoided.
Notice:
• FCC
ID
can be found inside the battery compartment
or
on
the bottom
of
the unit.
For assistance, please visit http://www.panasonic.com/help 9