Panasonic ES5801 User manual

Matsushita Electric Works, Ltd.
1048, Kadoma, Osaka 571-8686, Japan
No.1 EN, CH ( 中国 ) Printed in Japan
Operating Instructions
Card Sized Shaver
Model No. ES5801
ES5801
Before operating this unit, please read these instructions completely.
Thank you for purchasing the Panasonic Card Sized Shaver Model No. ES5801.
Panasonic ES5801anasonic ES5801
R

32
Caution
R
Not Washable
CThe outer foil is very thin and should not be exposed to
excessive pressure or impact which may deform or damage it.
CIf the outer foil is deformed or damaged, do not shave with it,
because skin irritation can result.
CBoth the foil and the blade have a limited service life. To keep a
better result, we suggest you to replace the outer foil and the
inner blade as the following standard.
Standard life. (based on use for 3 minutes. once a day)
Outer foil ······ approximate 1 year
Inner Blade ······ approximate 2 year
CBoth the foil and the blade are available in the department store
or Panasonic service station.
Panasonic
1 3
4
5
2
A
B
C
D
E
F
G

54
Before use
This unit will give you excellent
service over a long period if you
follow a few simple suggestions.
This booklet is designed to help
you get the best possible use
from this unit.
READ ALL INSTRUCTIONS
BEFORE USE.
Parts identification
(See Fig. 1)
A Protective cap
Keep it on the shaver when
the shaver is not in use. To
remove it, put upward.
B Outer foil
This is a precision foil. Do
not handle it roughly.
Dropping the shaver can
result in damage to this deli-
cate foil.
C Foil cassette release button
D Inner blade
E Inner blade mount
F Switch
Slide the switch upward to
turn the shaver on.
G Bottom cover
Replacing batteries
(See Fig.2)
When the blade speed
decreases, this indicates that the
batteries should be replaced with
new ones. Do not use this
shaver with weak batteries.
Specifications
Power source : Two DC 3V LR-3 (AAA/UM-4)
alkaline batteries (not included)
Attachment : clean brush, soft case
Turn the shaver so the bottom is
facing up and remove the bottom
cover.
Insert two LR-3 alkaline
(AAA/UM-4) batteries observing
the Positive (+) and Negative (-)
positions indicated beside the
battery compartment.
Attach the bottom cover.
CDo not press the razor area
when attaching the cover.
Do not combine an old battery
with a new one, or use different
types of batteries together.
CLR-3 alkaline (AAA/UM-4) bat-
teries allow one month of
usage, assuming one two-
minute shave each day.
CRemove the batteries when not
using the appliance for a long
time.
Using your shaver
Remove the protective cap then
switch the shaver on. Using light
pressure, move the shaver
against the direction of beard
growth.

76
Maintenance
Cleaning
Push the foil cassette release but-
ton and detach the foil frame as
shown. (See Fig. 3)
Grasp inner blade firmly at each
side, and pull straight up. (See
Fig. 4)
Clean away the clippings with the
cleaning brush provided. (See
Fig. 5)
Reassemble the shaver parts in
the reverse order.
Replace the outer foil
(See Fig. 3)
Squeeze the foil cassette release
buttons and lift the outer foil up-
ward to remove it.
Insert the new outer foil
(See Fig. 3)
Press down until the outer foil
snaps into place.
Replace the inner blade
(See Fig. 4)
Remove the inner blade by
grasping it firmly at both sides and
pulling straight away from the
shaver.
Insert the new inner blade
(See Fig. 4)
Hold the inner blade at both sides
and guide it onto the inner blade
mount. Press it firmly into the
mount until it snaps in place.
Caution
Do not wash with water.
CIt may damage the shaver.
Do not leave the shaver where
the temperature is below 0°C
(32°F) or above 40°C (104°F),
where it will be exposed to
direct sunlight or a heat source,
or where there is much mois-
ture.
Do not wipe the shaver body
using anything other than mild
soapy water.
CIt may alter the color of the
shaver.
Do not use the shaver if it has a
damaged foil and/or blade, as in-
jury can result.
Use this shaver for its intended
use, as described in this manual.

8