Panasonic SC-ALL2 User manual

12
3
45
RQT0A31-2B
F0515HA3075
Connect Turn On Unit
Do not connect
the LAN cable.
Operating Instructions <Setup>
Wireless Speaker System
Model No. SC-ALL2
Thank you for purchasing this product. Please read these instructions
carefully before using this product, and save this manual for future use.
This manual contains quick set up information. More detailed
instructions are contained in “Operating Instructions <Full version>”
which can be downloaded at the bottom right links.
The network indicator starts blinking
in blue and red.
Configure with Smartphone/Tablet
Go to wireless
settings on
your
smartphone
or tablet.
Select
“ALL2  _AJ”
§
.
§This can sometimes take
1 minute to appear.
Name your device
e.g. Kitchen, Lounge
or whatever you would
like it to appear.
Select your network.
(enter password if needed)
Wait a few seconds and...
...you’re connected!§
§ After a short wait, your smartphone/
tablet should be automatically
reconnected to your Wi-Fi
®
network.
In case you are not reconnected
automatically, please re-select your
Wi-Fi network from the settings /
Wi-Fi settings menu on your device.
NOTE: If this operation does not
work correctly, please repeat it
several times.
NOTE: If this page is not
automatically displayed, type
“http://172.19.42.1/” into your
internet browser URL address field.
The network indicator blinks in red
for a few seconds, and then lights
up solid blue when a network
connection is established.
Download App
Download the free
“Panasonic Music
Streaming” app
[iOS] : App Store
[Android] : Google Play
TM
Stream your music Further Support
For Operating Instructions <Full
version>, FAQs, video tutorials,
or further help, please visit
http://panasonic.jp/support/
global/cs/audio/ALL/index.html
(This site is in English only.)
Alternatively, scan the QR code.
Settings
Wi-Fi Settings
Network Reset
1 Touch and hold [NET] and [1] for
more than 4 seconds, “-- --” on
the display will start blinking.
2 Touch [NET] within 10 seconds,
the network indicator starts
blinking blue/red.
For details on the app, refer to the site below. (These sites are in English only.)
[iOS] : http://panasonic.jp/support/global/cs/audio/app/music_streaming/ios/
[Android] : http://panasonic.jp/support/global/cs/audio/app/music_streaming/android/
After approximately 1 minute, it will
blink in blue slowly.
If the blinking in blue does not start, perform a
network reset (see below - Network Reset).
NOTE: If you encounter an error
message asking you to reconfigure
your router to WPA2TM security, please
refer to your router’s manual or contact
your service provider for instructions on
how to do this.
SC-ALL2-EGEB-QSG~RQT0A31-2B.book 1 ページ ２０１５年７月２日 木曜日 午前１０時５６分

Accessories
∏1 AC mains lead
Bluetooth® operations
Preparation
≥Turn on the Bluetooth® feature of the device and place
the device near this unit.
1.Touch [ ].
2.Select “SC-ALL2” from the Bluetooth® device’s
Bluetooth® menu.
3.Start playback on the Bluetooth® device.
To restore the settings to
the factory defaults
You need to perform a factory reset if you want to clear
and reset the memory contents.
– If you want to restore the network settings, perform a
network reset
(see on the reverse - Network Reset).
1.Touch and hold [Í/I] for more than 4 seconds.
2.While still holding [Í/I], touch and release
[NET].
3.During the reset process, “--:--” will be
displayed.
4.The unit will turn off.
“-- --” appears and the reset is complete.
Precautions
Unit
≥To reduce the risk of fire, electric shock or product damage,
– Do not expose this unit to rain, moisture, dripping or splashing.
– Do not place objects filled with liquids, such as vases, on this unit.
– Use only the recommended accessories.
– Do not remove covers.
– Do not repair this unit by yourself. Refer servicing to qualified
service personnel.
– Do not let metal objects fall inside this unit.
– Do not place any item on top of this unit.
AC mains lead
≥To reduce the risk of fire, electric shock or product damage,
– Ensure that the power supply voltage corresponds to the
voltage printed on this unit.
– Insert the mains plug fully into the socket outlet.
– Do not pull, bend, or place heavy items on the lead.
– Do not handle the plug with wet hands.
– Hold onto the mains plug body when disconnecting the plug.
– Do not use a damaged mains plug or socket outlet.
≥The mains plug is the disconnecting device.
Install this unit so that the mains plug can be unplugged from
the socket outlet immediately.
Unit
≥Do not place sources of naked flames, such as lighted candles,
on this unit.
≥This unit may receive radio interference caused by mobile
telephones during use. If such interference occurs, please
increase separation between this unit and the mobile telephone.
≥This unit is intended for use in moderate climates.
Placement
≥Place this unit on an even surface.
≥To reduce the risk of fire, electric shock or product damage,
– Do not install or place this unit in a bookcase, built-in cabinet
or in another confined space. Ensure this unit is well
ventilated.
– Do not obstruct this unit’s ventilation openings with
newspapers, tablecloths, curtains, and similar items.
– Do not expose this unit to direct sunlight, high temperatures,
high humidity, and excessive vibration.
AC mains lead
≥Do not use AC mains lead with other equipment.
(For the AC mains plug of three pins)
For your safety, please read the following text carefully.
This appliance is supplied with a moulded three pin mains plug for
your safety and convenience.
A 5-ampere fuse is fitted in this plug.
Should the fuse need to be replaced please ensure that the
replacement fuse has a rating of 5-ampere and that it is approved
by ASTA or BSI to BS1362.
Check for the ASTA mark Ï or the BSI mark Ì on the body of the
fuse.
If the plug contains a removable fuse cover you must ensure that it
is refitted when the fuse is replaced.
If you lose the fuse cover the plug must not be used until a
replacement cover is obtained.
A replacement fuse cover can be purchased from your local dealer.
Before use
Remove the connector cover.
How to replace the fuse
The location of the fuse differ according to the type of AC mains
plug (figures A and B). Confirm the AC mains plug fitted and follow
the instructions below.
Illustrations may differ from actual AC mains plug.
1. Open the fuse cover with a screwdriver.
2. Replace the fuse and close or attach the fuse cover.
NORSK
Produkt
≥For å redusere faren for brann, elektrisk støt eller skade på
apparatet:
– Utsett ikke produktet for regn, fukt, drypping eller sprut.
– Ikke plasser objekter som er fylt med væske, som vaser, på
apparatet.
– Bruk kun anbefalt tilbehør.
– Fjern ikke deksler.
– Reparer ikke denne enheten selv, overlat service til
kvalifisert servicepersonell.
Vekselstrømnett
≥Nettstøpselet er trukket ut fra denne enheten.
Installer denne enheten slik at nettstøpselet umiddelbart kan
trekkes fra stikkontakten.
Produkt
≥Plasser ikke åpen ild, slik som levende lys, oppå apparatet.
≥Dette apparatet er beregnet for bruk under moderate
klimaforhold.
Plassering
≥For å redusere faren for brann, elektrisk støt eller skade på
apparatet:
– Ikke plasser apparatet i en bokhylle, et innebygget kabinett
eller et annet lukket sted. Pass på at produktet er godt
ventilert.
– Apparatets ventilasjonsåpninger må ikke dekkes til med
aviser, duker, gardiner eller lignende.
Model number suffix “EB” denotes UK model.
For further dedicated help, support and advice
about your ALL Series product please visit:
http://panasonic.jp/support/global/cs/audio/ALL/
index.html
(This site is in English only.)
WARNING
1
Top view Display
blinking
1
2
Top v iew
Top view Display
blink 4 times
CAUTION
Caution for AC Mains Lead
Safety information for customers in Norway
ADVARSEL
FORSIKTIG
Figure A Figure B
Fuse cover
Figure A Figure B
Fuse
(5 ampere)
Fuse
(5 ampere)
This symbol indicates separate
collection of waste electrical and
electronic equipment.
More detailed information is
contained in “Operating
Instructions<Full version>”.
The Bluetooth® word mark and logos are registered trademarks
owned by Bluetooth SIG, Inc. and any use of such marks by
Panasonic Corporation is under license.
Other trademarks and trade names are those of their respective owners.
The Wi-Fi CERTIFIEDTM Logo is a certification mark of Wi-Fi
Alliance®. The Wi-Fi Protected SetupTM Identifier mark is a
certification mark of Wi-Fi Alliance®. “Wi-Fi®” is a registered
trademark of Wi-Fi Alliance®. “Wi-Fi Protected SetupTM”,
“WPATM”, and “WPA2TM” are trademarks of Wi-Fi Alliance®.
Google Play and Android are trademarks of Google Inc.
App Store is a service mark of Apple Inc.
All other trademarks are trademarks of their respective owners.
This product incorporates the following software:
(1) the software developed independently by or for Panasonic
Corporation,
(2) the software owned by third party and licensed to Panasonic
Corporation,
(3) the software licensed under the GNU General Public
License, Version 2.0 (GPL V2.0),
(4) the software licensed under the GNU LESSER General
Public License, Version 2.1 (LGPL V2.1), and/or
(5) open source software other than the software licensed under
the GPL V2.0 and/or LGPL V2.1.
The software categorized as (3) - (5) are distributed in the hope
that it will be useful, but WITHOUT ANY WARRANTY, without
even the implied warranty of MERCHANTABILITY or FITNESS
FOR A PARTICULAR PURPOSE.
Please refer to the detailed terms and conditions thereof shown
in our website below.
http://panasonic.jp/support/global/cs/audio/oss/all8_3_1c.html
At least three (3) years from delivery of this product, Panasonic will give
to any third party who contacts us at the contact information provided
below, for a charge no more than our cost of physically performing
source code distribution, a complete machine-readable copy of the
corresponding source code covered under GPL V2.0, LGPL V2.1 or the
other licenses with the obligation to do so, as well as the respective
copyright notice thereof.
Contact Information: oss-cd-requ[email protected]anasonic.com
The source code and the copyright notice are also available for
free in our website below.
http://panasonic.net/avc/oss/
Declaration of Conformity (DoC)
Hereby, “Panasonic Corporation” declares that this product is in
compliance with the essential requirements and other relevant
provisions of Directive 1999/5/EC.
Customers can download a copy of the original DoC to our
R&TTE products from our DoC server:
http://www.doc.panasonic.de
Contact to Authorised Representative:
Panasonic Marketing Europe GmbH, Panasonic Testing Centre,
Winsbergring 15, 22525 Hamburg, Germany
This product is intended to be used in the following countries.
GB, DE, AT, BE, DK, SE, FR, IT, ES, NL, FI, GR, PT, PL, HU, CZ, SK,
EE, LV, LT, SI, BG, RO, MT, CY, IE, LU, HR, NO, CH, IS, LI, TR
This product is intended for general consumer. (Category 3)
The WLAN feature of this product shall exclusively be used
inside buildings.
This product on purpose to connect to access point of 2.4 GHz
or 5 GHz WLAN.
Product Identification Marking is located on the bottom of the unit.
Manufactured by:
Panasonic Corporation
Kadoma, Osaka, Japan
Importer for Europe:
Panasonic Marketing Europe GmbH
Panasonic Testing Centre
Winsbergring 15, 22525 Hamburg,
Germany
Panasonic Corporation
Web Site: http://www.panasonic.com
C Panasonic Corporation 2015
p
EG
EB
SC-ALL2-EGEB-QSG~RQT0A31-2B.book 1 ページ ２０１５年７月２日 木曜日 午前１０時５６分