Parachute Outpost User manual

Outpost Wood Bed Frame
Assembly Instructions

Before getting started:
Remove instructions from the side of the box and clear the area of fragile objects. Bed frame assembly requires
two people. Please read all instructions carefully and do not discard in case they’re needed for future reference.
B1. Allen Bolt
(M8x70) x 4
Parts list:
A1. Headboard x 1
A2.Footboard x 1
A7. Back Leg Frame x 1
A9. Slats x 1 set
2 / 7
Assembly Instructions
B2. Allen Bolt
(M8x40) x 4
B3. Allen Bolt
(M8x40) x 4
B4. Screws x 6
B5. Spring
Washer M8 x 16
B6. Flat Washer
M8 x 16
B7. Allen Key
(M4) x 1
B8. Screw Driver Tool
(not included)
B9. Allen Bolt
(M6x40) x 3
B10. Spring
Washer M6 x 2
B11. Flat Washer
(M6) x 3
A3. Left Rail x 1 A4. Right Rail x 1 A5. Support Rail x 1 A6. Support Legs x 3
A8. Front Leg Frame x 1

1
Line up the holes on the left and right rails with the designated holes located on the front leg and
back leg frames. From there, layer a spring washer onto a flat washer (B5, B6) before tightly
screwing the designated allen bolts (B1) in place with an allen key.
NOTE: Loosely hand thread all bolts into place to check alignment before proceeding. When all
pieces are properly aligned, securely tighten each bolt into place. If screws/bolts don’t thread in,
try to adjust by loosening the metal brackets.
3 / 7
Assembly Instructions
A3
A7
B1
B2 B6
B5
B7
A8
A4

2
4 / 7
Assembly Instructions
B7
B9
B10
B11
A5
A6
A1
A2
B3
B5
B6
B7
Now that you have the outline of the frame constructed, attach both the left and right rails to the headboard
by aligning the designated holes and layering a flat washer onto a spring washer (B5, B6). From there, you’ll
be able to tighten the allen bolts (B3) into place and complete the top portion. Repeat this step to connect
the footboard to the bottom of the left and right rails.
3
Assemble the center base by connecting the support rail to the three support legs. Layer a spring washer
onto a flat washer (B10,B11) before securing and tightening the designated allen bolts (B9).

4
Assembly Instructions
5 / 7
B8
B4
A9
Next, slide the assembled support rail into the designated metal brackets located at the
center of the headboard and footboard.
5
Take the pre-assembled slats set and line up each corner with the corners of the newly
assembled bed frame. Loosely thread each screw (B4) into place on the top and bottom
corners of the left and right sides. Once all corners are in alignment use a screwdriver (not
included) to securely connect each screw to the base.

6
6 / 7
Assembly Instructions
Inspect all corners, joints and connections to ensure proper assembly before placing your
mattress on top of the slats.
7
Have a wonderful night’s sleep.