1-800-451-8546 www.paragoninc.com
5. Insert two floor glides into each leg foot in the designated locations.
6. Install two 3/8-16 X ½” set screw into leg upper into two extruded holes located on the back side of the
leg upper. Insert leg lower into leg upper and tighten to the desired leg height using 3/8-16 X ½” set
screw. Use the 3/16 hex key to tighten the set screws.
7. Place the assembled legs over the corresponding holes and tighten using six #10 X ½” machine
screws per leg.
8. Attach the chase to the legs using two ¼-20 X 1 ¾” machine screws and secure them with ¼-20
locknuts using a 7/16 wrench. Attach the chase to the FPSR tub using two #10 X ½” machine screws and
10/32 locknuts per tub and tighten securely.
9. Turn the fully assembled table over and adjust the floor glides until the table is completely level.
NOTE: When moving this table, do not push, pull, or drag the table. With help, pick the table up to move.
