Payment Express BRF210 Manual

BRF210
Hardware Installation Guide
Version 0.1

DOCUMENT REVISION INFORMATION
Version
Date
Revision Information
0.1
15/10/2014
Initial version.

COPYRIGHT
© Copyright 2014, Direct Payment Solutions (DPS) Limited
98 Anzac Avenue
PO Box 8400
Auckland, 1035
New Zealand
www.paymentexpress.com
All rights are reserved. No part of this work may be reproduced or copied in any form or by any means, electronic or
mechanical, including photocopying, without the express written permission of Direct Payment Solutions.
PROPRIETARY NOTICE
The information described in this document is proprietary and confidential to Direct Payment Solutions (DPS). Any
unauthorised use of this material is expressly prohibited except as authorised by Direct Payment Solutions in writing.

CONTENTS
1Overview......................................................................................................................................................................4
2Unit Dimensions...........................................................................................................................................................5
3Mounting Plate Dimensions .........................................................................................................................................6
4Contact DPS ................................................................................................................................................................7

BRF210 –Hardware Installation Guide
Version: 0.1
Page | 4 of 7
1OVERVIEW
Hardware Overview
The BRF contactless antenna is an optional receiver that can be plugged into the SCR to support contactless
payments (e.g. Visa PayWave, MasterCard PayPass).
Supports closed loop proprietary payment cards (e.g MiFare)
32-Bit Cortex M3 120MHz processor
Display LEDs x4
Physical Link Interface
Connection with the SCR unit is via the attached cable located on the back of the BRF unit.
Power Requirements
The device accepts DC regulated from +5V to +45V. SELV (Safety Extra Low Voltage)
Standards Compliance
EMV Level 1 & 2
Visa PayWave v2.1
MasterCard PayPass v3.0
EMC Standards
oAS/NZS 4268: 2012
oETSI EN 302 291-2, V1.1.1, 2005
oEN 301 489-3 V1.4.1
oAS/NZS CISPR 22: 2009 + Amendment 1: 2009
Environmental Standards
oIEC 60529 : 2013 (Ed 2.2) –Degrees of protection provided by enclosures –IP66
oIEC 60068-2-6 : 2007 (Ed. 7.0) –Sinusoidal Vibration
oIEC 60068-2-64 : 2008 (Ed. 2.0) –Broadband Random Vibration

BRF210 –Hardware Installation Guide
Version: 0.1
Page | 5 of 7
2UNIT DIMENSIONS

BRF210 –Hardware Installation Guide
Version: 0.1
Page | 6 of 7
3MOUNTING PLATE DIMENSIONS

BRF210 –Hardware Installation Guide
Version: 0.1
Page | 7 of 7
4CONTACT DPS
Phone
International
[phone]
Australia
1 800 006 254 or [phone]
Hong Kong
[phone]
New Zealand
0800 PAYMENT (729 6368) or 09 309 4693
Singapore
[phone]
South Africa
[phone]
United Kingdom
[phone]
USA
[phone]
E-mail
Sales
[email protected]
Support
[email protected]
Dev Support
[email protected]