PB Dorm Over-the-Door Mirror Rack User manual

Over-the-Door Mirror Rack
Parts:
A
B
C
D
E
F
G
H
I
Screws
Mirror
Wire hook
Hook
Large wire
bins
Small wire bins
Large canvas
bins
Small canvas
bins
3M Velcro
6 PCS
1 PC
1 PC
2 PCS
2 PCS
2 PCS
2 PCS
2 PCs
1 SET
Tools: Phillips screwdriver.
Assembling product:
1. Open wire bin and assemble canvas bin with wire bin as shown in below photos.
1. Attach the mirror (B) to the wire hook (C) by aligning the mirror
holes with the two threaded holes and secure the mirror using
2 x screws (A) and a screwdriver.
2. Attach 2 hooks (D) to the mirror (B) by aligning the hook
holes with the two threaded holes and secure the hooks using
4 x screws (A) and a screwdriver.
3. Attach the 3M Velcro on the back of the mirror.
Clean the surface with isopropyl rubbing alcohol, wipe gently, let dry.
Do not use household cleaners. Separate strips. Press fasteners
together until they snap. Remove one red liner. Position the set
of strips on back of mirror and press firmly. Remove remaining
red liners. Press firmly for 30 seconds.

4. Hang the product on the door as shown in photo.
5. Hang the wire bins on the product as shown in photo.
6. Grab the mirror at the bottom and peel off the protective surface.
Do not pull directly toward you to remove.
Firmly press all 3 areas of strips for 30 seconds.
Wait 1 hour to mount the frame. Press fasteners firmly
together until they click. If item is not level, reposition.
To Remove 3M Velcro:
Grab bottom corners and remove bamboo board as shown.
Never pull strip towards you. Lightly press top of strip and
grab tab, slowly stretching downward along wall. Continue
stretching at least 6 inches (15cm) until strip releases from wall.
Important:
Failure to follow instruction carefully may cause damage! Save instructions for damage-free removal or visit
command.com
Caution:
Do not use with wallpaper. May not adhere well to vinyl surfaces. Do not use for antique, heirlooms, or other valuable or
irreplaceable items. Do not hang items over beds.
Noted:
Apply to surfaces above 50˚F (10˚C). Adhesive could lose adhesion above 150˚F (40˚C).
Care Instructions:
Wipe with a soft, dry cloth
Do not use strong chemical or abrasive cleaners.
You can use a household glass cleaner to clean the glass, but apply the cleaner to a clean cloth first and then use the
cloth to clean the mirrored surfaces. Avoid spraying the cleaner directly onto the frame of this item.
Thank you for your purchase.
www.pbteen.com