INSTRUCTION MANUAL
How to charge mulple devices
1. Connect the power adaptor to the iQ 5 Sync Charge Box and also to the mains supply, and switch on.
The indicator LEDs will ash red-green-yellow and the cooling fan will start briey for a test as the
iQ 5 Sync Charge Box powers up. With nothing else connected to the iQ 5 Sync Charge Box the LEDs
will now show red, indicang that the it is ready to charge devices.
2. Connect all the devices required to be charged to the iQ 5 Sync Charge Box USB output ports using
only approved USB cables. The devices may be connected to any of the USB sockets, in any order and
any sequence.
3. Each port that is connected to a device will inially show a ashing red LED to indicate that it is
determining the best charging prole to use. Once the charge prole has been set the LED will begin
ashing green, indicang that the device is charging. Aer the charge current has fallen below 40mA
the green LED will stop ashing to indicate that the device is now fully charged.
4. If it is necessary to check the baery status of any device, momentarily switch the selected device ON
and check it’s on-screen charge indicaon.
How to sync mulple devices
1. Power up the iQ 5 Sync Charge Box and connect all the devices required to be synchronized in the
same manner as above for charging.
2. Connect the iQ 5 Sync Charge Box to a host computer which contains the synchronizing soware using
an approved Type A to Type B USB cable.
3. Upon connecng the iQ 5 Sync Charge Box to the host computer, the iQ 5 Sync Charge Box will
automacally switch from Charge Mode to Sync Mode and this will be signied by the LED indicators
changing to yellow (if a device is connected) or to ashing yellow (if no device is connected).
PLEASE NOTE: The devices will connue to charge at a reduced rate during syncing.
4. Removing the USB cable from the host computer will return the iQ 5 Sync Charge Box to Charge Mode
and the devices will automacally resume charging.
Connecng Mulple iQ 5 Sync Charge Box units to a host
1. Up to four iQ 5 Sync Charge Box units may be connected together to reduce the number of
connections required to the host computer. Each unit can be chained to the next by connecting the
expansion port of the first iQ 5 Sync Charge Box to the host port of the next iQ 5 Sync Charge Box
using a Type A to Type B USB cable.
2. Power up the iQ 5 Sync Charge Box units and connect all the devices required to be synchronized in
the same manner as above for charging.
3. Connect the rst iQ 5 Sync Charge Box to a host computer which contains the synchronizing soware
using an approved Type A to Type B USB cable.
4. Upon connecng the iQ 5 Sync Charge Box to the host computer, the iQ 5 Sync Charge Box will
automacally switch from Charge Mode to Sync Mode and this will be signied by the LED indicators
changing to yellow (if a device is connected) or to ashing yellow (if no device is connected).
PLEASE NOTE: The devices will connue to charge at a reduced rate during syncing.
5. Removing the USB cable from the host computer will return the iQ 5 Sync Charge Box to Charge Mode
and the devices will automacally resume charging at the full rate.
