PCP Mendip Shower Tray User manual

Installation Instructions
Mendip Shower Tray

PAGE 3
Standard InstallationStandard Installation
PARTS
Mendip Shower Tray
Self-Adhesive
Tiling Strip
Fixing Bracket
Shower Waste
Trap
X2
X4
¾x8mm
Self tapping
screw
X4
2x8mm
Wall screws
X4
Raw Plugs
AF
GH
C+E B+D
impey
uk
Waste Hole Drilling
LocationS
ticker
Sticker
Template

Mendip Shower TrayMendip Shower Tray
Determine which corner the Mendip tray
is to be fitted into.
This will establish which edges need to
have the self adhesive tile upstand
attached to them.
1
A.
B.
Remove the orange paper from the
rubber tile upstand to reveal the self
adhesive section.
Attach the rubber tile upstand to the
appropriate edges of the tray.
To wrap the rubber tile upstand around a
corner, cut a 90¡ Triangle out of the
upstand as shown.
Rubber Tile
Upstand
B
A
2
Tray Tray
Tile Tile
Ensure that the rubber upstand is parallel
to the wall when the tray is fitted into
place.
If the upstand can not be fitted parallel
to the wall, you will need to remove
plaster as necessary.
3
Remove the access cover to enable
better access for fitting the trap.
Determine which direction the waste pipe
will run and twist the swivel outlet of the
trap in the appropriate direction.
4
3

Determine on which face of the tray the
waste pipe will exit, refer to the waste
pipe hole drilling guide on page 5 and
sticker sheet.
Cut out the appropriate sticker and
apply to the required position on the tray.
5
Using a 45mm-50mm hole saw, drill the
waste pipe hole in the side of the tray.
Fit the waste pipe to the trap using
solvent weld and route the pipe under
the tray so that it exits through the
previously drilled hole.
Offer the fixing brackets into place (this is
approximately 50mm in from the corner
of the tray) and using the bracket as a
template mark the holes and drill with a
3mm drill bit.
Place the tray in position again and
check that it is level on all 4 sides with a
spirit level. If it is not pack it up as
necessary. It may also be necessary to
remove some wall plaster to
accommodate the wall brackets.
Drill and fix the tray through the brackets
using the screws and raw plugs provided.
Finally connect the waste pipe either to
existing waste or connect to a soil stack.
Before refitting the access cover please
check the water tightness of all joints
under the tray.
Refit the access cover and fit the chrome
waste mushroom
Tile the walls in an approved manner to
complete installation.
F
GH
C+E B+D
impey
uk
Waste Hole DrillingLocation
Sticker
GH
C+E B+D
Mendip
Tray
GH
C+E B+D
50mm
50mm
Tray
Fixing Bracket
4
6
7
8

Waste Pipe Drilling PositionsWaste Pipe Drilling Positions
Please refer to sticker template
AA FF
H
H
G
G
BB EE
C
C
D
D
AF
GH
C+E B+D
impey
uk
Waste Hole DrillingLocation
Sticker
1. Decide which corner the waste pipe will exit. (This will determine which template you will need)
2. Place sticker over relevant corner.
3. Drill a 45-50mm diameter hole using the relevant circle as a guide.
4. Remove sticker.
5