peerless-AV ACC340 Guide

1 of 5 ISSUED: 01-16-13 SHEET #: 125-9400-2 05-20-13
Installation and Assembly:
Media Storage Shelf for FPZ-600 and DS-VWS546-2X2
Model: ACC340

2 of 5 ISSUED: 01-16-13 SHEET #: 125-9400-2 05-20-13
Table of Contents
PARTS LIST ...........................................................................................................................................................................2
SAFETY BELT.................................................................................................................................................................... 3,4
MEDIA SHELF........................................................................................................................................................................5
NOTE: Read entire instruction sheet before you start installation and assembly.
Tools Needed for Assembly Accessories
• Allen wrench (supplied) • ACC604
• Do not begin to install your Peerless product until you have read and understood the instructions and warnings
contained in this Installation Sheet. If you have any questions regarding any of the instructions or warnings, for US
customers please call Peerless customer care at 1-800-865-2112, for all international customers, please contact
your local distributor.
• This product should only be installed by someone of good mechanical aptitude, has experience with basic building
construction, and fully understands these instructions.
• Always use an assistant or mechanical lifting equipment to safely lift and position equipment.
• Tightenscrewsrmly,butdonotovertighten.Overtighteningcandamagetheitems,greatlyreducingtheirholding
power.
• This product is intended for indoor use only. Use of this product outdoors could lead to product failure and personal
injury.
WARNING
Parts List
Part Description Quantity Part Number
Amedia shelf 1145-1732
BM5 x 10mm screw 2 520 -1063
Callen wrench 1 560-9646
Dsafety belt 1ACC316
Before beginning, make sure you have all parts shown below
A
B
C D

3 of 5 ISSUED: 01-16-13 SHEET #: 125-9400-2 05-20-13
Place belt assembly over electronic component.
Note: keep buckle closer to left side of the electronic component to allow for movement when tightening belt
assembly.
Trim off the end of the belt if necessary, then lightly burn the end of the belt to prevent fraying. Repeat for the
opposite end electronic component.
Connect belt with buckle to belt without buckle.
Continue by sliding one belt guide and one
tri-bar belt clip on each side of the buckle. Refer to
drawing below.
SAFETY BELT
NOTELINES
FACES UP
TRI-BAR CLIP
BELT
GUIDE
REMOVE
STICKER
TOP
BOTTOM
Make sure that electronic component surface is clean of
grease,oilanddust.Onceallcomponentsareinplace,
removestickerfrombottomofbeltguidesandrmly
press them onto the electronic component.
1.4
1.3
1.2
1.1

4 of 5 ISSUED: 01-16-13 SHEET #: 125-9400-2 05-20-13
1.5 Take belt and hold it so that the tri-bar belt clip (A)
is facing as illustrated. Feed belt through the slot
you have chosen. Now feed belt through belt clip
as shown. Repeat on other side of tray using other
belt.
Tighten belt by pulling on loose end.

5 of 5 ISSUED: 01-16-13 SHEET #: 125-9400-2 05-20-13
2.1 Secure media shelf (A) to mount using two M5 x 10mm
screws (B).
2.2 Secure media shelf (A) to ACC604 (supplied separately)
using two M5 x 10mm screws (B) as shown.
MEDIA SHELF ATTACHMENT
MEDIA SHELF ATTACHMENT TO ACC604
B
B
A
A
ACC604NOTSUPPLIED