Thermostat Wired to Damper Actuator
WHEN INSTALLING THIS PRODUCT...
1. Read these instructions carefully and thoroughly. Failure to follow these instructions or a result
of improper installation, service, adjustments, maintenance, and/or use can result in personal
injury, damage to personal property, and/or cause a hazardous and dangerous situation.
2. Check the ratings and description given in the specification of the product to make sure the
product is suitable for your application
3. Installer must be trained and experienced service technician. Follow all safety codes and
regulations and all local and state building codes. Read instructions thoroughly and follow any
warnings or notes.
4. After installation is complete, check product operation as provided in these instructions.
CAUTION
1. Disconnect power supply before connecting any wiring to device to prevent
electrical shock or damage to equipment.
2. This guide is designed for certified, trained, and experienced service technicians.
Failure to follow installation instructions does not alleviate installer responsibility to
protect the equipment, the property, and the device it is being connected too. If at
anytime if there is concern or confusion about how to install this device, immediately
stop what you are doing and either contact Pelican Wireless Systems or a certified
Pelican Wireless Systems distributor.
WARNING
1. This equipment is designed to communicate over radio frequency to other Pelican
equipment only. If this equipment is not installed and used in accordance with the
instruction manual, you may experience wireless interference. This device has been
tested and complies with FCC rules and regulations.
LOCATION AND MOUNTING
Choose a location for the Pelican zone thermostat that represents that spaces temperature, and
where connections are accessible. The zone thermostat is directly wired to the damper actuator.
8
