Pelonis FT30-14AU User manual

OWNER’S MANUAL
12" RETRO TABLE FAN
MODEL:FT30-14AU

1
Read Rules for Safe Operation and Instructions Carefully.
1. To reduce the risk of fire or electric shock, do not use this fan with any solid-state
speed control device.
2. This appliance has a grounded three-prong plug and is suitable for grounded
receptacle use only.If an adapter is used to connecting three-blade grounding-type
piugs to two-slot receptales.The adapter must be properly grounded.DO NOT
attempt to defeat the purpose of this safety feature.
3. DO NOT use fan in window. Rain may create an electrical hazard. Do not leave
the fan operating adjacent to an area where water has collected to avoid the
potential of electrical hazard. Do not immerse unit, plug or cord in water or spray
with liquids.
4. Do not leave the fan running unattended.
5. Please make sure the voltage of the power supply is the same as shown on the
fan nameplate.
1. Never insert fingers, pencils, or any other object through the grille when fan is
running.
2. Disconnect fan when moving from one location to another.
3. Disconnect fan when removing grilles for cleaning.
4. Be sure fan is on a stable surface when operating to avoid overturning.
5. DO NOT use fan in window, rain may create electrical hazard.
6. Indoor use only.
7. The rules about cord and plug as below:
(1) This product employs overload protection (fuse). A blown fuse indicates an
overload or short-circuit situation. If the fuse blows, unplug the product from
the outlet. Replace the fuse as per the User Servicing Instructions (follow
product marking for proper fuse rating) and check the products. If the
replacement fuse blows, a short-circuit may be present and the product
should be discarded or returned to an authorized service facility for
examination and/ or repair.
(2) Do not operate any fan with a damaged cord or plug. Discard fan or return
to an authorized service facility for examination and/or repair.
(3) Do not run cord under carpeting. Do not cover cord with throw rugs, runners,
or similar coverings. Do not route cord under furniture or appliances. Arrange
cord away from traffic area and where it will not be tripped over.
IMPORTANT: During the first few minutes of initial use, you may notice a slight
odor due to lubrication of the motor at the factory. This is normal and will quickly
disappear.
CAUTION
WARNING
RULES FOR SAFE OPERATION

22
INSTALLATION INSTRUCTIONS
Name of components
INSTRUCTIONS FOR USE
Speed Display
Snap Switch
Swing Pull-knob
Push-down to swing
Pull-up for static
Horizontal Swing
Screw Screw
Rear grill
Blade
Front grill
Tighten
knob
ClipHandleKnob
Lock nut
of blade

3
CLEANING
1. Be sure to unplug from the electrical supply source before cleaning.
2. Plastic parts should be cleaned with mild soap and a damp cloth or sponge.
Thoroughly to remove soap film with clean water.
3. Be sure not to make water or other liquid enter inside of motor.
a) Grasp plug and remove from the receptacle or other
outlet device. Do not unplug by pulling on cord.
b) Open fuse cover. Slide open fuse access cover on top
of attachment plug towards blades.
c) Remove fuse carefully. Push the fuse from the other side
or turn fuseholder over to remove fuse.
d) Risk of fire. Replace fuse only with 5 A, 125 Volt fuse.
e) Close fuse cover. Slide closed the fuse access cover on top of attachment plug.
f ) Risk of fire. Do not replace attachment plug. Contains a safety device (fuse) that
should not be removed. Discard product if the attachment plug is damaged.
Notice:
1. If fuse is difficult to install, please make sure you are installing properly.
2. When you feel it hard to be operated, please make sure you have got the right
way.
USER SERVICING INSTRUCTIONS

SERVICE & SUPPORT
In the event of a warranty claim or if service is required for this heater, please contact us at the
following:
Toll Free: 1-866-646-4332
Email us at: [email protected]
For questions or comments, please write to:
Midea America Corporation
Customer Care Center
For your records, staple your sales receipt to this manual and record the following:
DATE OF PURCHASE: ________________________________
PLACE OF PURCHASE: ________________________________
(STAPLE SALES RECEIPT HERE)
NOTE: PROOF OF PURCHASE IS REQUIRED FOR ALL
WARRANTY CLAIMS
PRINTED IN CHINA
11411 NW 107th Street,
Suite 12 Miami, FL 33178