PerfectVision PV5HEC-F User manual

90°
Do not nick or cut through these wires
0.25” 0.25”
Coax against
the stop
Cut the end of
the cable cleanly
with sharp cutters
at a 90° angle.
Insert the coax into the
appropriate cable prep tool
so the end of the coax is
flush against the stop.
We recommend using the Ripley
brand LDT-MINI coax preparation
tool for best results.
Turn the prep tool three or four full and continuous revolutions
around the coax. Do not reverse the direction of the turn, it is
unnecessary and can damage the braid.
1
3
2
It is important to make sure ALL the braid
wires are folded back neatly.
The two cutoff sections should both be 1/4" long.
4
©2016 PerfectVision Manufacturing
Align core up with
connector post and
load cable into rear
F connector shell
6
3 - 4
ROTATIONS
PV5HEC-F
Installation Guide
PV5HEC-F-Install_09132016_ALB_V4 U.S. Toll Free 1.866.470.0887 International +1.501.955.0032 www.perfect-vision.com
NO
PERFECT
5
Inspect your work carefully before
attempting to install the connector.
Look for all of these issues:
• Conductor is straight
• Braid wires are pushed back
neatly and evenly
• Dielectric is round and smooth
Look closely at the innermost
aluminum foil shield to ensure it is
flat against the dielectric foam.

Inspect your work to see if connector
core is flush and no stray braid wires are
showing. Connector is now attached.
Load connector into any standard 21mm F compression tool. Recommended tools are PV100, PV200 or PV300.
7
©2016 PerfectVision Manufacturing
PV5HEC-F-Install_09132016_ALB_V4 U.S. Toll Free 1.866.470.0887 International +1.501.955.0032 www.perfect-vision.com
PV5HEC-F
Installation Guide
Fully compressed connector