PerfectVision PV6UE-05 User manual

Coax against
the stop
90° Cut the end of the
cable cleanly with
sharp cutters at a
90° angle.
Insert the coax into the appropriate cable prep tool so
the end of the coax is flush against the stop.
Turn the prep tool five or six full and continuous revolutions
around the coax. Do not reverse the direction of the turn, it
is unnecessary and can damage the braid.
1
3
2
4
It is important to make sure
ALL the braid wires are
folded back neatly.
Do not nick or cut through these wires
The two cutoff
sections should
be 1/4" and
5/16" long.
Remove the foil layer. Cutoffs should be 1/4” and
5/16” long.
Fold ALL braid wires
back neatly.
Nick the foil close to the
PVC jacket and begin
peeling the foil.
0.25”
0.25”
0.3125”
0.3125” Nick Foil
Nick Foil
4
4
DUAL SHIELD
TRI-SHIELD
QUAD-SHIELD
Fold back the first
layer of braid wires.
Peel off the foil layer. Fold ALL braid wires
back neatly.
Nick outer foil as shown.
©2016 PerfectVision Manufacturing
5 - 6
ROTATIONS
PV6UE-05
Installation Guide
U.S. Toll Free 1.866.470.0887 International +1.501.955.0032 www.perfect-vision.comPV6UE-05-Install_12162016_ALB

NO
5 6
Inspect your work
carefully before
attempting to install the
connector. Look for all
of these issues.
Also look closely at the
innermost aluminum
jacket to ensure it is
laying flat against the
white dielectric foam.
Gently Press
Gently fit the connector onto the coax cable.
Ensure the dielectric and foil shield enters the
connector post without damage to the foil.
Press the connector onto the cable until the
white dielectric foam is flush with the inside
face of the connector.
NO
NO
PERFECT
NO
7
8
Too short
NO
Too long
The connector will slide down into the coax smoothly if you have aligned everything properly.
PERFECT
©2016 PerfectVision Manufacturing
Compress the connector to 21 mm using the PV-200 tool.
U.S. Toll Free 1.866.470.0887 International +1.501.955.0032 www.perfect-vision.comPV6UE-05-Install_12162016_ALB
PV6UE-05
Installation Guide