Permasafe PSSM-1017 User manual

20 oz. High Volume, Low Pressure
Pneumatic Atomizing Spray Gun
Model Number: PSSM-1017
User Manual

SYMBOLS DEFINITION
SAFETY
• Before you begin using this spray gun, you must read this manual completely. Relevant safety,
operating, and maintenance information is included herein.
• Ensure all parts are well attached before connecting air supply and operating.
• Do not operate above maximum recommended air pressure.
• Operate away from children and animals.
• Do not operate tool near open ames or other source of heat.
• Use for any application other than that for which tool was designed can cause damage or
injuries and is not recommended.
• Operate spray gun in clean and well lit area.
• Do not use the tool while under the inuence of drugs, alcohol or medication.
• Stay alert and avoid distractions while operating tool.
• Wear appropriate protective equipment as needed.
• Disconnect tool from air source prior to any adjustment.
• Store tool when not in use.
• Servicing of the tool should only be performed by a qualied operator or technician and
replacement of parts should only be made with approved parts.
Indicates a potentially hazardous situation, which, if not avoided, could result in serious
injury or death.
!
WARNING
When using tools, basic precautions should always be followed, including the following:
!
This product can expose you to chemicals including lead, which is known to the state of
California to cause cancer and birth defects or other reproductive harm. For more information, go
to www.P65Warnings.ca.gov.
CALIFORNIA PROPOSITION 65
WARNING
SPECIFICATIONS
Fluid Nozzle 1.4 mm
Cup Capacity 20 . oz.
Air Connection IN
Maximum Air Pressure 50 PSI
Air Consumption 6 CFM @ 40 PSI

OPERATION
MAINTENANCE
TROUBLESHOOTING
WARRANTY
1. Screw on cup onto spray gun.
2. Pour liquid into cup.
3. Attach air hose to air compressor.
4. Connect air hose to tool’s air inlet using appropriate coupler.
5. Turn on the air compressor.
6. Gradually adjust the air pressure using the air compressor’s regulator until you achieve the
desired pressure range. Do not exceed the Maximum Air Pressure.
7. Hold tool 6-9 inches from surface and pull trigger slowly while moving in parallel strokes.
8. Fluid Adjustment: Loosen collar on uid control knob. Turn knob counterclockwise until 3
threads are visible. Depress trigger fully. Turn uid knob clockwise until it stops and release
trigger. Tighten collar on uid knob to secure uid adjustment position.
9. Airow Adjustment: Turn air control knob clockwise to reduce airow pressure. Turn knob
counterclockwise to increase airow pressure.
10.Pattern Adjustment: Use pattern control knob counterclockwise to atten spray pattern. Turn
knob clockwise for round spray pattern.
11. Fan Direction Adjustment: Fan direction can be adjusted by turning air cap 90 degrees.
12.Remove cup, rinse and store tool in dry secure area after every use.
Soak all parts in approved solvent for 15-30 minutes. Longer soaking time may be necessary for severe
clogs. Clean all parts with brush provided and let dry.
Contact point of sale for assistance troubleshooting your pneumatic spray gun.
Distributor warrants to the original purchaser of the spray gun that it is free from defects in workmanship
and materials, under normal use and conditions, for a period of 90 days from the original date of purchase.
This warranty does not apply to damage incurred due incorrect or inadequate maintenance or care,
misuse, abuse, negligence, accidents, modication, or failure to follow instructions provided herein.
DISTRIBUTOR EXCLUDES ANY AND ALL LIABILITY FOR INCIDENTAL, INDIRECT, AND
CONSEQUENTIAL LOSS OR DAMAGES.
WARNING
Procedures not described in this manual should be performed by a qualied technician.
!