Pettinaroli U2WA User manual

TECHNICAL SPECIFICATIONS
U2WR
Via Pianelli,38 - 28017 S.Maurizio d’Opaglio (NO) ITALY Tel. [phone] - Fax. [phone] - www.pettinaroli.com
STE0164 rev.00 04/11/2015
REPEATER
U2WR
The repeater U2WR extends the radio range of the wireless
control units U2W in order to reach also the furthest
thermostats.
The repeater can be coupled only with the following products:
U2W404/ U2W408/ U2W412
U2W4E04/ U2W4E08/ U2W4E12
U2W204/ U2W208/ U2W212
U2W2E04/ U2W2E08/ U2W2E12
Every other use is considered as not intended and the
manufacturer warranty is not more valid.
-----------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
TECHNICAL DATA
Type
U2WA
APPROVALS
Operating voltage
5 V via power supply
EN 60730/1
Power consumption
<1 W
Operating frequency
868 MHz SRD band
Degree/Class of protection
IP30 / III
Range
>25 m inside buildings
Ambient temperature
0°C to 55°C
Storage temperature
-25°C to +70°C
Air humidity
max. 80% 1
Dimensions (mm)
76/76/35
Weight
115 g
Length of connection cable
1,5 m
1 –non condensing
------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
INSTALLATION
Direct pairing procedure of non-receiving room thermostat to the wireless control unit and wall installation:
1. Open the repeater with a flat screwdriver.
2. Insert the cable of the power supply into the housing from the back
3. Install the repeater
4. Connect the repeater to the power supply, put the jack into the specific socket
5. Close the repeater cover
6. Power the repeater, putting the main plug into a house socket. The green LED are lighted
7. Active the pairing mode on the repeater pushing the button for more than 5s. The green LED starts flashing
8. Perform the radio test on the room thermostat. The green and yellow LED are lighted
------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------

TECHNICAL SPECIFICATIONS
U2WR
Via Pianelli,38 - 28017 S.Maurizio d’Opaglio (NO) ITALY Tel. [phone] - Fax. [phone] - www.pettinaroli.com
STE0164 rev.00 04/11/2015
PACKAGE CONTENT
------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
RESTORE OF FACTORY SETTINGS
------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
SWITCHING OFF LEDs
Press the pairing button for more than 12 seconds
1. Open the housing
2. Press the higher button for more than 5 seconds