PGT Reclaimed QTA Bed User manual

Page%1
QTA Bed
ASSEMBLY INSTRUCTION
For Standard QTA bed
First of all, correctly spread out all of the pieces you are about to put together.
STEP 1: Fitting SIDE RAILS
Ensure the metal bracketson the headboard and footboard are square to the
side rail brackets when fitting each side rail. Then, push down with your foot
gently to complete.
STEP 2: Fitting THE CENTER LEG
It is important to do this step correctly
* Remove the centre leg extension from its packaging, and slide it onto the
centre leg.

Page%2
* Fit and tighten the nut and bolt at the first hole up from the ground.
STEP 3: Fitting THE CENTRE RAIL
* Extend the centre rail, and fit to the headboard and footboard.
* Then fit and tighten the extension rail lock bolt.

Page%3
STEP 4: Adjusting THE CENTER RAIL FOOT
* Unscrew the rubber foot under the centre rail leg, until it touches the ground.
* Turn the nut above the foot clockwise until it reaches the end of the
extension leg, then tighten it.
STEP 5: Fitting SLATS
* When fitting the slats into the side rails, ensure they are extended to fit
firmly into each side rail between their location blocks.

Page%4
* The slat metal lock ring should be about 5cm from the end of each slat.
The assembly is now completed, and the standard mattress now sits on top of the slats.
Trust you enjoy our QTA bed for many years!