5Revison 03/2017Copyright © 2017, Fast ČR, a. s.
EN
Steam ironing
If you do not allow your iron to reach the selected temperature, water may drip from the soleplate during steam
ironing .
It is recommended that for harder to iron fabrics such as cotton and linen, steam should be used when ironing.
When ironing cotton and linen ,always select the highest temperature ,steam should never be used on delicate
fabrics like nylons, acrylics and synthetics .
1. Filled your iron with water
2. Plug your iron into the mains supply and switch on
3. Use the +/- buttons to select the or MAX setting ,The hotter your iron ,The more steams is generated
4. When the or MAX light stops flashing ,your irons is at the correct temperature and ready to use,
During use, the or MAX light will flash periodically as your iron maintains the selected temperature
5. Adjust the steam control lever to select the desired steam output
6. Move the steam control lever to the high steam setting to increase the amount of steam ,or towards
the off (0) setting to decrease the amount of steam ,
7. The steam can be shut off at any time by setting the steam control to the off (0) postion
Spraying
The spray function will only operate when there is water in the water tank
1. The water spray can be used to help iron heavy fabrics or difficult areas(collars, pockects, sleeves, creases,
etc ).It can also be uses when ironing delicate fabrics which can not be steam ironed.
2. Simply press the button as required to produce as spray of water .if the spray is being used for the first time
,or if the iron has been standing for some time ,you may need to press the spray button a few times before
it works correctly
Burst of steam
Your iron must be set to either or MAX ,Wait several seconds between each press of the steam button
.press the shot of steam button whenever you have a stubbom crease that needs extra steam ,Steam will burst
from the holes in the soleplate of your iron into the fabric.
Vertical steam ironing
Never iron garments when they are being worn
Your iron can be used for vertical steam ironing curtains ,dresses on the hangers etc.
1. Fill your iron with water
2. Plug your iron into the mains supply and switch on
3. Use the +/- buttons to select the or MAX setting ,The hotter your iron ,The more steams is generated
4. When the or MAX light stops flashing ,your irons is at the correct temperature and ready to use,
During use, the or MAX light will flash periodically as your iron maintains the selected temperature
5. Hold your iron 15cm(6 inches) from the fabric
6. Press the shot of steam button ,The steam will penetrate the fabric removing the creases. To apply more
steam press the shot of steam button again ,wait several seconds between each press of the button
