
Copyright © 2019, Fast ČR, a. s. Revision 12/2019
EN - 8
PART 2: INSTALLATION
1. Make sure that all the packing materials are removed from the inside of the door.
2. WARNING: Check the oven for any damage, such as misaligned or bent door, damaged door seals and
sealing surface, broken or loose door hinges and latches and dents inside the cavity or on the door. If
there is any damage, do not operate the oven and contact qualied service personnel.
3. This microwave oven must be placed on a at, stable surface to hold its weight and the heaviest food
likely to be cooked in the oven.
4. Do not place the oven where heat, moisture, or high humidity are generated, or near combustible
materials.
5. For correct operation, the oven must have sucient airow. Allow 20cm of space above the oven, 10cm
at back and 5cm at both sides. Do not cover or block any openings on the appliance. Do not remove
feet.
6. Do not operate the oven without glass tray, roller support, and shaft in their proper positions.
7. Make sure that the power supply cord is undamaged and does not run under the oven or over any hot
or sharp surface.
8. The socket must be readily accessible so that it can be easily unplugged in an emergency.
9. Do not use the oven outdoors.
PART 3: UTENSILS GUIDE
1. Microwave cannot penetrate metal. Only use utensils that are suitable for use in microwave ovens.
Metallic containers for food and beverages are not allowed during microwave cooking. This requirement
is not applicable if the manufacturer species size and shape of metallic containers suitable for
microwave cooking.
2. Microwave cannot penetrate metal, so metal utensils or dishes with metallic trim should not be used.
3. Do not use recycled paper products when microwave cooking, as they may contain small metal
fragments which may cause sparks and/or res.
4. Round /oval dishes rather than square/oblong ones are recommend, as food in corners tends to
overcook.
5. Narrow strips of aluminum foil may be used to prevent overcooking of exposed areas. But be careful
don’t use too much and keep a distance of 1 inch (2.54cm) between foil and cavity.