
EN - 6
Revision 06/2018Copyright © 2018, Fast ČR, a. s.
• Secure any accessories in the fridge during transporta-
tion to prevent damage to the accessories.
Installing and operating your fridge
Before starting to use your fridge freezer, you should pay attention to the following points:
• The operating voltage for your fridge is 220–240 Vat 50 Hz.
• The plug must be accessible after installation.
• Your fridge freezer may have asmell when it is operated for the rst time. This is normal and the smell will
fade away when your fridge freezer starts to cool.
• Before connecting your fridge freezer, ensure that the information on the data plate (voltage and connect-
ed load) matches that of the mains electricity supply. If in doubt, consult aqualied electrician.
• Insert the plug into asocket with an ecient ground connection. If the socket has no ground contact or
the plug does not match, we recommend that you consult aqualied electrician for assistance.
• The appliance must be connected with aproperly installed fused socket. Power supply (AC) and voltage at
the operating point must match with the details on the name plate of the appliance (name plate is located
on the inside left of the appliance).
• We do not accept responsibility for any damages that occur due to ungrounded usage.
• Place your fridge where it will not be exposed to direct sunlight.
• Your fridge should never be used outdoors or exposed to rain.
• Your appliance should be at least 50 cm away from stoves, gas ovens and heater cores, and at least 5 cm
away from electrical ovens.
• When your fridge is placed next to adeep freezer, there should be at least 2 cm be-
tween them to prevent humidity forming on the outer surface.
• Do not place heavy items on the appliance.
• Clean the appliance thoroughly, especially the interior, before use (see Cleaning and
Maintenance).
• The installation procedure into the kitchen unit is given in the installation manual. This
product is intended to be used in proper kitchen units only.
• Before using your fridge freezer, wipe all parts with asolution of warm water and atea-
spoon of sodium bicarbonate, then rinse with clean water and dry. Place all parts in the
fridge after cleaning.
• Install the plastic distance guide (the part with black vanes at the rear) by turning it 90°
(as shown in the gure) to prevent the condenser from touching the wall.
• The refrigerator should be placed against awall with afree space not exceeding 75 mm.
Before using your fridge freezer
• When using your fridge freezer for the rst time, or after transportation, keep it in
an upright position for at least 3 hours before plugging into the mains. This allows
ecient operation and prevents damage to the compressor.
• Your fridge freezer may have asmell when it is operated for the rst time. This is
normal and the smell will fade away when your fridge starts to cool.