Philips AZ215 Product information sheet

Question?
Contact
Philips
www.philips.com/support AZ215
AZ216
2015 © Gibson Innovations Limited.All rights reser ved.
This product has been manufactured by, and is sold under the responsibility of Gibson
Innovations Ltd., and Gibson Innovations Ltd. is the warrantor in relation to this product.
Philips and the Philips Shield Emblem are registered trademarks of Koninklijke Philips N.V.
and are used under license from Koninklijke Philips N.V.
AZ215_AZ216_05_Short User Manual_V1.0
Short User Manual
1 Safety
This ‘bolt of lightning’ indicates uninsulated material within your unit
may cause an electrical shock. For the safety of everyone in your
household, please do not remove product covering.
The ‘exclamation point’ calls attention to features for which you
should read the enclosed literature closely to prevent operating and
maintenance problems.
WARNING: To reduce the risk of re or electric shock, this
apparatus should not be exposed to rain or moisture and objects
lled with liquids, such as vases, should not be placed on this
apparatus.
CAUTION:To prevent electric shock, match wide blade of plug to
wide slot, fully insert.
Warning
• Never remove the casing of this apparatus.
• Never lubricate any part of this apparatus.
• Never look into the laser beam inside this apparatus.
• Never place this apparatus on other electrical equipment.
• Keep this apparatus away from direct sunlight, naked ames or heat.
• Ensure that you always have easy access to the power cord, plug or
adaptor to disconnect the apparatus from the power.
• The device shall not exposed to dripping or splashing.
• Do no place any source of danger on the device (e.g. liquid
lled objects. lit candles).
• Where the MAINS plug or an appliance coupler is used as
the disconnect device, the disconnect device shall remain
readily operable.
• Make sure that there is enough free space around the
product for ventilation.
• Battery usage CAUTION – To prevent battery leakage which
may result in bodily injury, proper ty damage, or damage to
the unit:
• Install all batteries correctly, + and - as marked on the
unit.
• Batteries (packed or installed) shall not be exposed to
excessive heat such as sunshine, re or the like.
• Remove batteries when the unit is not used for a long
time.
• Only use attachments/accessories specied by the
manufacturer.
Caution
• Use of controls or adjustments or performance of procedures other than
herein may result in hazardous laser exposure or other unsafe operation.
2 Notice
Any changes or modications made to this device that are not
expressly approved by Gibson Innovations may void the user’s
authority to operate the equipment.
This product complies with the radio interference requirements of
the European Community.
Disposal of your old product
Your product is designed and manufactured with high quality
materials and components, which can be recycled and reused.
This symbol on a product means that the product is covered by
European Directive 2012/19/EU. Inform yourself about the local
separate collection system for electrical and electronic products.
Follow local rules and never dispose of the product with normal
household waste. Correct disposal of old products helps prevent
negative consequences for the environment and human health.
Environmental information
All unnecessary packaging has been omitted. We have tried to
make the packaging easy to separate into three materials: cardboard
(box), paper pulp (buffer) and polyethylene (bags, protective foam
sheet.)
Your system consists of materials which can be recycled and reused
if disassembled by a specialized company. Please observe the local
regulations regarding the disposal of packaging materials, exhausted
batteries and old equipment.
Important notes for users in the U.K.
This information applies only to products with a UK mains plug.
This product is tted with an approved molded plug. If you replace
the fuse, use one with:
• the ratings shown on the plug,
• a BS 1362 approval, and
• the ASTA approval mark.
Contact your dealer if you are not sure about what type of fuse
to use.
Caution: To conform with the EMC directive (2004/108/EC), do not
detach the plug from the power cord.
How to connect a plug
The wires in the mains lead are coloured with the following code:
blue = neutral (N), brown = live (L).
As these colours may not correspond with the colour markings
identifying the terminals in your plug, proceed as follows:
• Connect the blue wire to the terminal marked N or coloured
black.
• Connect the brown wire to the terminal marked L or
coloured red.
• Do not connect either wire to the earth terminal in the plug,
marked E (or e) or coloured green (or green and yellow).
Before replacing the plug cover, make certain that the cord grip
is clamped over the sheath of the lead - not simply over the two
wires.
Copyright in the U.K.
Recording and playback of material may require consent. see
Copyright Act 1956 andThe performer’s Protection Acts 1958 to
1972.
This apparatus includes these labels:
Class II equipment symbol
This symbol indicates that the apparatus has a double insulation
system.
Note
• The type plate is located on the bottom of the apparatus.
Specications
Amplier
Rated Output Power 3W
Frequency Response 80 Hz - 16000 Hz, +/-3 dB
Signal to Noise Ratio >72 dBA
Total Harmonic Distortion <1 %
Disc
Audio DAC 24 Bits, 44.1 kHz
Frequency Response 80 Hz -16000Hz, +/-3 dB
Tuner
Tuning Range FM: 87.5 - 108 MHz
Tunning grid 50 KHz
Preset stations 20
General
Power supply
- AC Power
- Battery
220 - 240 V ~, 50/60 Hz
DC 9V, 6 x 1.5V R14/
UM2/C Cell
Standby Power Consumption < 0.5 W
Dimensions
- Main Unit (W x H x D) 252 x 124 x 232 mm
Weight
- Main Unit
- With Packing
1.0 kg
1.6kg

Short user manual
www.philips.com/support
Always there to help you
Registeryour product and get support at
Question?
Contact
Philips
6X1.5V R14/UM2/C CELL
CD
Before using your product, read all accompanying
safety information.
To play with the device, you can use either
alkaline battery (R14) or AC power.
Tune to a radio station Program radio stations manually
In CD mode, you can control play through the following operations.
/ Press and hold to fast-forward
or fast-reverse the track during
playback, then release to resume
play.
Start or pause play.
Stop play.
MODE [REP]: Play the current track
repeatedly.
[REP ALL]: Play all tracks repeatedly.
[SHUF]: Play tracks randomly.
To return to normal play, press
repeatedly until the repeat icons
disappear.
Note:Only[REP] and [REP ALL] be selected when you play the
programmed tracks.
Program tracks
To download full user manual, visit www.philips.com/support.