Philips Senseo HD7822 User manual

HD7824, HD7822, HD7820
Coffee Machine

2

3
B
C
AF
G
H
I
E
D
K
L
J
POM N
1

4

HD7824, HD7822, HD7820
ENGLISH 6
DANSK 19
SUOMI 32
NORSK 45
SVENSKA 58

6
Introduction
With Douwe Egberts SENSEO®coffee pods, you can enjoy a perfect cup
of coffee at any time of the day. Every cup is freshly brewed to give you
that smooth and full taste.
Using more than 250 years of coffee expertise Douwe Egberts has roasted
and ground specially selected coffee beans that, when prepared using a
special brewing method co-developed with Philips, ensure a full, smooth
taste and delicious foam layer.This joint creation, known as the SENSEO®
coffee pod system, consists of the Philips SENSEO®coffee machine and
specially developed Douwe Egberts SENSEO®coffee pods. Only when
used together will you be rewarded with a sensational cup of SENSEO®
coffee with the delicious SENSEO®foam layer.
To ensure a smooth and full coffee taste, you should keep the following
things in mind:
Fresh water
Use fresh water every day. If you have not used the coffee machine for
three days, you have to ush it with fresh water before you use it again
(see section ‘Flushing’ in chapter ‘Cleaning’).
Fresh coffee pods
Use the SENSEO®coffee pods that have been specially developed by
Douwe Egberts for your SENSEO®coffee machine for a full, round taste.
The Douwe Egberts SENSEO®coffee pods will stay fresh longer if you
store them in an airtight storage container.
A clean machine
Clean and descale your Philips SENSEO®coffee machine regularly (see
chapters ‘Cleaning’ and ‘Descaling’). Remove used coffee pods after brewing.
If a used pod has been left in the coffee machine and you have not used
the machine for some time, ush the machine before you use it again (see
section ‘Flushing’ in chapter ‘Cleaning’).
General description (Fig. 1)
AWater reservoir
BGrip area
C Outow valve
DSealing ring
EWater distribution disc
F1-cup pod holder q
G2-cup pod holder qq
HCover of coffee spout
ICoffee spout
JCoffee collector
KCup tray
LDrip tray
M1-cup button q
NWater level light rings (HD7824 only)
OOn/off button with indicator light
P2-cup button qq
ENGLISH

Important
Read these instructions for use carefully before using the machine and save
them for future reference.
Check if the voltage indicated on the bottom of the machine
corresponds to the local mains voltage before you connect the
machine.
If the mains cord is damaged, it must be replaced by Philips, a service
centre authorised by Philips or similarly qualied persons in order to
avoid a hazard.
To prevent unexpected contact with hot water, always make sure
the lid of the SENSEO®machine is properly locked before you start
using the machine.
Never put normal ground coffee or use torn pods in the SENSEO®
machine, as this will cause it to become blocked.
Do not use the machine in combination with a transformer, as this
could cause hazardous situations.
Put the machine on a at, stable surface.
Never let the machine operate unattended.
Do not use the machine at altitudes higher than 2200 metres above
sea level.
The machine does not work at temperatures below 10 °C.
Flush the coffee machine with fresh water before using it for the rst
time (see chapter ‘Preparing the machine for use’).This will cause the
boiler to ll with water, which is essential for the machine to work
properly.
This appliance is not intended for use by persons (including children)
with reduced physical, sensory or mental capabilities, or lack of
experience and knowledge, unless they have been given supervision
or instruction concerning use of the appliance by a person
responsible for their safety.
Children should be supervised to ensure that they do not play with
the appliance.
Electromagnetic elds (EMF)
This Philips appliance complies with all standards regarding electromagnetic
elds (EMF). If handled properly and in accordance with the instructions in
this instruction manual, the appliance is safe to use according to scientic
evidence available today.
Preparing the machine for use
YOU CANNOT BREW COFFEE IFYOU HAVE NOT FLUSHED THE
SENSEO®COFFEE MACHINE FIRST!
The ushing cycle causes the boiler to be lled with water. After this the
coffee machine is ready for use.
Flush the machine in the following way:
,
,
,
,
,
,
,
,
,
,
,
,
ENGLISH 7

1 Remove the water reservoir.
2 Fill the water reservoir with cold water up to the MAX indication
and put it back onto the machine.
3 Release the lid by moving the lever upwards.
4 Open the lid.
5 Put the 1-cup pod holder qor the 2-cup pod holder qq in the
machine without pod(s).
ENGLISH8

6 Close the lid and lock the lever.
Note: Make sure the lever is properly locked by pushing it down until it snaps
home with a click.
Note: Never ush the machine with the lid open. The lid must be properly
locked.
7 Put the plug in an earthed wall socket.
8 Put a bowl (with a capacity of at least 1500 ml) under the spout
openings to collect the water.
9 Press the on/off button 3.
Type HD7824 only: after pressing the on/off button, the light rings around
the 1-cup button qand the 2-cup button qq burn continuously.
10 Press the 1-cup button qand the 2-cup button qq briey at the
same time.
The boiler lls itself with water from the water reservoir. This may take
some time (approx. 90 to 150 seconds).The machine switches off
automatically when the ushing cycle ends. During the ushing cycle the
machine produces more noise than during a regular brewing cycle.
Never interrupt the ushing cycle halfway. If you do, the boiler will not
ll itself properly.
Note: Before you use the machine for the rst time, clean the coffee spout,
the coffee collector and the pod holders with hot water and some washing-up
liquid or in the dishwasher. Clean the water reservoir thoroughly in hot water, if
necessary with some washing-up liquid.
Now your Philips SENSEO®coffee machine is ready for use.
ENGLISH 9

Brewing coffee
1 Fill the water reservoir with cold water up to the MAX indication
and put it back onto the machine.
Never pour milk, coffee, hot water or carbonated water into the water
reservoir.
q MIN: minimum amount of water required to brew 1 cup of
SENSEO®coffee.
qq MIN: minimum amount of water required to brew 2 cups of
SENSEO®coffee.
A full reservoir allows you to make up to 8 cups of SENSEO®coffee.
This makes it unnecessary to ll the water reservoir each time you
want to make a cup of coffee.
2 Press the on/off button 3.
The indicator light blinks slowly while the water is heating up. Heating up
takes approx. 75 seconds.
The coffee machine is ready for use when the indicator light burns
continuously. If the indicator light blinks rapidly, the water reservoir
does not contain enough water for brewing one cup of coffee.
Type HD7824 only: the light rings around the 1-cup button qand
the 2-cup button qq also go on when the machine is ready for use.
If there is not enough water for brewing two cups of coffee, the light
ring around the 2-cup button qq will not go on and this button
cannot be operated.
3 Release the lid by moving the lever upwards.
4 Open the lid.
5 Place the appropriate pod holder in the machine.
Note: Make sure the pod holder is clean and the sieve in the centre is not
clogged, e.g. with loose coffee grounds.
If you want to make one cup of SENSEO®coffee, use 1 coffee pod in
combination with the 1-cup pod holder qand the 1- cup button q.
If you want to make two cups of SENSEO®coffee, use 2 coffee pods
in combination with the deeper 2-cup pod holder qq and the 2-cup
button qq.
6 Place the SENSEO®coffee pod(s) properly in the centre of the pod
holder, with the convex side pointing downwards.
Note: Use SENSEO®coffee pods from Douwe Egberts specially designed for
your SENSEO®coffee machine for a full and round taste.
Note: Make sure the coffee in the pod(s) is evenly distributed and press the
pod(s) lightly into the pod holder.
Note: Never put normal ground coffee or use torn pods in the SENSEO®
machine, as this will cause it to become blocked.
-
-
-
,
,
,
,
ENGLISH10