Philips D700 Product information sheet

D700
D705
Register your product and get support at
www.philips.com/welcome
Short user manual

Important safety instructions
Warning
•The Electrical network is classified as hazardous.
The only way to power down the charger is to
unplug the power supply from the electrical outlet.
Ensure that the electrical outlet is always easily
accessible.
•Refer to safety information before using the
product.
•This product complies with European R&TTE
directive 1999/5/EC
•Use only the power supply listed in the user
instructions.
•Use only the batteries listed in the user
instructions.
•Do not allow the product to come into contact
with liquids.
•Risk of explosion if battery is replaced by an
incorrect type.
•Dispose of used batteries according to the
instrucions.
•When the handset rings or when the handsfree is
activated, keep the handset away from your ear to
avoid hearing damage.
When using the phone as a baby monitor
•Children should be supervised to ensure that they
do not play with the appliance.
•Make sure the baby unit and the cord are always
out of reach of the baby (at least 1 metre/3 feet
away).
•Keep the parent unit at least 1.5 metres/5 feet
away from the baby unit to prevent acoustic
feedback.
•Never place the baby unit inside the baby’s bed or
playpen.
•Never cover the parent unit and the baby unit
with anything (e.g. a towel or blanket). Always
make sure the cooling vents of the baby unit are
free.
•This appliance is not intended for use by persons
(including children) with reduced physical, sensory
or mental capabilities, or lack of experience
and knowledge, unless they have been given
supervision or instruction concerning use of the
appliance by a person responsible for their safety.
•If you place the parent unit next to a transmitter
or other DECT appliance (e.g. a DECT telephone
or wireless router for the internet), the connection
with the baby unit may be lost. Move the baby
monitor further away from the other wireless
appliances until the connection is restored.
•This baby monitor is intended as an aid. It is not
a substitute for responsible and proper adult
supervision and should not be used as such.

D705D700
Find
handset
/
/
Loudspeaker
(back side)
Microphone
Earpiece
Headphone
jack
Loudspeaker
(back side)
Display icons
In call
Enter the option menu
Adjust the volume
End calls
Turn the speaker on/off
Mute/unmute the microphone
Enter a pause
Standby
Access the main menu
Phonebook
Call log
Make and receive calls
Make intercom call
Lock/unlock the keypad.
Make and receive calls
In menu
Conrm/Entertheoptionmenu/Select
Cancel
Up / down
Exit menu
In text input
Delete text
Enter a space
Switch upper/lower case
Left / right
Main menu icons
Alarm Sounds
Phonebook Incoming calls
Phone setup Services
Display Baby monitor
Answer machine
(D705 only)
Intercom ( D700 only)
Display icons
The number of bars indicates the connection status
between the handset and base station.The more
bars are shown, the better the signal strength is.
It remains steadily on when browsing new missed
calls in call log.
Itasheswhenthereisanewmissedcall.Itremains
steadily on when browsing missed calls in call log.
The alarm is activated.
The silent mode is set, but is outside of active
period.
The ringer is off.
The silent mode is set and within active period (the
phone does not ring).
D705only:Answeringmachine:itasheswhen
there is a new message. It remains steadily on when
the telephone answering machine is turned on.
Voicemessagesindicator:ashesfornewmessages,
is steady for reviewed messages.
* This is network dependent
The ECO mode is activated.
The ECO+ mode is activated.
1Overview

1 2 3
2Connect
Multi-handset version
only.

3Get started
Insert batteries Charge your phone
Charge 8 hours
Congure your phone
1 Whenusingyourphoneforthersttime,youseea
welcome message (country dependent).
2 Set the country and language if prompted.
3 Set the date and time.
•If the time is in 12-hour format, press to select
[am] or [pm] (country dependent).
> 84%
68% - 84%
52% - 68%
36% - 52%
18% - 36%
< 18%
Flashing: low battery
Scrolling: charging in progress

Phonebook
Add record
1 Press > [Option] > [Add new].
2 Follow on-screen instructions.
Call from the phonebook
1 Press .
2 Select a record and press .
Direct access memory
You have 9 direct access memories (Keys 1 to 9).To
dial the saved phone number automatically, press and
hold on the keys in standby mode.
Depending on your country, keys 1 and 2 are
preset to [1_voicemail] (voice mail number) and
[2_info svc] (information service number) of your
network operator respectively (network dependent).
Call log
Call from the call log
1 Press .
2 Select [Incoming calls] (for D705 only).
3 Select a record and press .
Add record
1 Press > [Incoming calls] (for D705 only) >
[Option] > [Save number].
2 Follow on-screen instructions.
Delete record
1 Press > [Incoming calls] (for D705 only) >
[Option] > [Delete].
2 Follow on-screen instructions.
Redial list
Call from the redial list
1 Press [Redial].
2 Select a record and press .
Add record
1 Press [Redial] > [Option] > [Save number].
2 Follow on-screen instructions.
Delete record
1 Press [Redial] > [Option] > [Delete].
2 Follow on-screen instructions.
Record an announcement
(for D705 only)
1 Select [Menu] > > [Announcement].
2 Follow on-screen instructions.
Register additional handsets
You can register additional handsets to the base
station.
1 Select [Menu] > > [Register], then press
[OK]toconrm.
2 Press and hold on the base station for 5
seconds.
3 Enter the system PIN/passcode (0000).
4 Press [OK]toconrmthePIN/passcode.
» Registration is complete in less than 2 minutes.
Restore default settings
You can reset your phone settings to the original
factory settings.
1 Select [Menu] > > [Reset], then press
[OK]toconrm.
2 Follow on-screen instructions.
4Enjoy

5Learn more
Silent mode
Sets time during which the phone will not ring
> [Silent mode]
MySound
Customizes the sound of voices to your liking
> [MySound]
Eco mode
Reduces power consumption / transmission power;
reduces radiation and range by approximately 60%
> [Eco mode]
Eco+ mode
Eliminates radiation in standby mode (causes 2
seconds ring delay, 50% shorter standby time)
> [Eco+ mode]
Call barring
Prevents unwanted outgoing calls to selected
numbers
> [Call barring]

Technical data
Battery
•Philips: 2 x AAA NiMH 1.2 V Rechargeable
550 mAh batteries
Use only the supplied batteries.
Adapter
Base and charger:
Philips: MN-A102-U130 S003IB0600040
Input 100-240 V~
50/60 Hz 200 mA
100-240 V~
50/60 Hz 150 mA
Output 6 V 400 mA 6 V 400 mA
Phonebook with 250 entries
Call log with 50 entries
Talk time: 20 hours
Standby time: 250 hours
Note
•YoucaninstallaDSL(digitalsubscriberline)lter
to prevent noise and caller ID problems caused by
the DSL interference.
•YoucanndtheDeclarationofConformityon
www.p4c.philips.com.

Frequently asked questions
No signal bar is displayed on the screen.
•The handset is out of range. Move it closer to the
base station.
•If the handset displays
[Register your Handset], put the handset on
the base until the signal bar appears.
If I fail to pair (register) the additional handsets to
the base station, what do I do?
Your base memory is full. Access > >
[Unregister] to unregister the unused handsets
and try again.
I have chosen a wrong language which I cannot
read, what do I do?
1 Press to go back to the standby screen.
2 Press to access the main menu screen.
3 Select , then you see one of the following texts
appear on the screen:
Language Langue
Sprache Lingua
4 Select it to access the language options.
5 Select your own language.
My handset is in searching status, what do I do?
•Make sure that the base station has power supply.
•Register the handset to the base station.
•Move the handset closer to the base station.
I cannot change the settings of my voice mail, what
do I do?
The voice mail service is managed by your service
provider but not the phone itself. Contact your
service provider to change the settings.
No display
•Make sure the batteries are charged.
•Make sure there are power and phone
connections.
The handset on the charger does not charge.
•Make sure the batteries are inserted correctly.
•Make sure the handset is placed properly on the
charger.The battery icon animates when charging.
•Make sure the docking tone setting is turned on.
When the handset is placed correctly on the
charger, you can hear a docking tone.
•The charging contacts are dirty. Disconnect the
powersupplyrstandcleanthecontactswitha
damp cloth.
•Purchasenewoneswiththesamespecications.
Bad audio (crackles, echo, etc.)
•The handset is nearly out of range. Move it closer
to the base station.
•The phone receives interference from the nearby
electrical appliances. Move the base station away
from them.
•The phone is at a location with thick walls. Move
the base away from them.
The handset does not ring.
Make sure the handset ringtone is turned on.
The caller ID does not display.
•The service is not activated. Check with your
service provider.
•The caller’s information is withheld or unavailable.

www.philips.com/support
For information, refer to the extended user
documentation online.

When this crossed-out wheeled bin symbol is
attached to a product it means that the product
is covered by the European Directive 2002/96/EC.
2014 © WOOX Innovations Limited.
All rights reserved.
Philips and the Philips’ Shield Emblem are
registered trademarks of Koninklijke Philips N.V.
and are used by WOOX Innovations Limited
under license from Koninklijke Philips N.V.
UMS_D700-705
05_EN_V2.0
WK14043
0168